Jump to content
SAU Community

Recommended Posts

  • 3 months later...
Where can I find pictures of the different types of Bride material available? (I'm aware they do a few different kinds). I want to do my door cards to match my seats also.

It comes in the following colours

Black, Blue, Red and Gradation (black to white fade)

100cmx150cm : 6,694yen

76cmx156cm: 6,694yen

Most people say that Bride has discontinue all colour but gradation. this is completely false

Here is the black bride material (i purchase this about 4months ago from bride)

4632200371_77ba41434f_b.jpg

Link to comment
https://www.sau.com.au/forums/topic/307517-bride-material/#findComment-5250064
Share on other sites

Thanks man, that's EXACTLY the info I was chasing. So if I am correct Bride material #P01CKO would be just like that except dark blue? or would it be light blue?

I think #P01CKO is just the solid blue colour

I think what you are after is #P02JKO (Fabric Center / ブルーロゴ Blue Logo); as my black fabric has the part code #P02HKO which is センター生地/ Fabric Center / ブラックロゴ Black logo

unsure of what colour blue it is as they only list one colour blue

Edited by Kaido_RR
Link to comment
https://www.sau.com.au/forums/topic/307517-bride-material/#findComment-5252299
Share on other sites

Apparently #P02JKO is the light blue colour shown here on this seat

d_f31jmf.gif

So it seems the same black you got is the way to go for me aswell as my seats are dark blue. Thanks for your help man, much appreciated!

Link to comment
https://www.sau.com.au/forums/topic/307517-bride-material/#findComment-5255238
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I don't care for these at all, but at least the underside looks straight and not rusty. A good basis for a long life. Many cars from Japan have been lifted with forklifts and f**ked almost irrepairably.
    • Yes, but it's not dumb or dodgy. You can build a perfectly good boost controller from a pressure reg, a relief valve (looks same same as a reg if all from Norgren or SMC, for example) and a check valve. I ran one for years. Only superceded with  EBC because I could get one for cheaps and wanted finer control.   THis mod is certainly not a sketchy boost mod, provided the boost is kept below the "spin to death" threshold of the turbos.
    • With ordering the belt, you're doing water pump and the idler and tensioner at the same time too yes?
    • This is just a dumb way of keeping the wastegate closed to make more boost. Undo it and either follow the factory setup or redo it properly. Manual boost controllers just use a spring preload to determine when to close in response to boost pressure so it no longer vents to atmosphere.
    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
×
×
  • Create New...