Jump to content
SAU Community

Recommended Posts

Just out of curiosity, will the factory radar cruise control do an emergency stop if its set to cruise and a car pulls out in front? Or is there only a certain percentage of braking forced which can be applied by the cruise control? I would be guessing the latter?

Link to comment
https://www.sau.com.au/forums/topic/308786-m35-radar-cruise-control/
Share on other sites

Im not sure, can you test it for us? :) Wont it just roll off the throttle?

I do know the new volvo will do a full emergency stop, not sure its a good idea though. I always wondered what would happen if a bit of newspaper blew onto the road or a roo bounced past. Could cause problems for the car behind. :D

Im not sure, can you test it for us? :) Wont it just roll off the throttle?

I do know the new volvo will do a full emergency stop, not sure its a good idea though. I always wondered what would happen if a bit of newspaper blew onto the road or a roo bounced past. Could cause problems for the car behind. :D

Exactly my thoughts! I've read some where on here that the system does in fact use the brakes to slow the car if needed, but just not sure if it will do an emergency stop. Hmm... yeah will have to test it out when I get the car... but I'd say it would only be allowed to apply a small amount of braking force. Another question would be whether it uses the speed sensor and brakes when going down hills to maintain the correct speed. But I'm guessing if they've gone as far as to use a radar they would've implement that for sure...

Edited by Vesza

It would be a great package if that's the case. Shame about the obtrusive radar sticking out the front.

You could always put big wheels on to bump up your speed, if needed. 22 inch rims should do it. :D

Yeah the radar grille looks like barf!

haha, yeah or I may look into tampering with the speed sensor. Was just thinking to myself.... an even better option would be adding GPS guided cruise control. So when I'm driving to Melbourne I can do 150km/h and automatically slow down for the speed camera's at each bridge :D

one way to test is to setup a pile of cardboard boxes and then 'cruise' into them and see if it stops!

or foam, or something else soft. maybe a group of people?

Funeral gathering?

Saves time!

(didn't put in my first or second thoughts.... would probably have gotten a warning :ermm: )

Edited by iamhe77
  • 2 months later...

For those interested, the factory radar cruise can apply the brakes HARD if it feels the need (it has activated the ABS in mine before), and can slow the car down to around 5km/h or so. It might be able to stop completely, though I haven't been game enough to let it try.

If while driving you catch another car and the speed difference is too great, it will beep to indicate that another car is within the range of the radar, and either roll off the throttle or brake gently to maintain the safety gap distance you have set. If the speed difference isn't too high, it will just match speeds with the car in front without a beep.

The safety gaps are "far, very far, and stupid far"

It will only apply the brakes to maintain the set cruise speed if you are following another car, so on a steep downhill it will basically free roll. At 120km/h the cruise beeps and disengages.

Occasionally it will have a fit at some odd-angled road signs, when driving into morning/evening sunstrike, and it will sometimes 'see' oncoming traffic as being in your lane. Most of the time these events just produce a beep, as the object passes by and the radar clears. In some cases it will stamp on the brakes, though again only for a brief moment (though this is annoying for people following)

Fortunately in all cases it beeps which gives you time to react. Once you know what to look out for, you can predict it's behavior.

The brakes are activated by an actuator which actually pushes the brake pedal, it's creepy to feel it moving.

The cruise won't engage below 45km/h, or if the gearbox is in manual mode or snow mode, or if the windscreen wipers are on normal or fast. It also won't engage if the radar unit is obscured/disconnected.

It will disengage if the front wipers are turned on for more than 10 seconds or so (though it is happy to operate if the wipers are only on the intermittent setting). It will also disengage if the rear wheels slip, if the sensor becomes too dirty (following cattle trucks etc), if you corner too hard, or if the car aquaplanes. The cornering one I discovered playing on a track - you'd have to be *really* pushing on the road.

It must have a G or steering angle sensor somewhere also, as it will often allow the speed to drop while cornering, and then accelerate back to the set speed once the wheel is straight again. I guess this avoids ending up with a heap more power being applied mid-corner.

It's not without it's problems, but it's a damn clever system. Just a shame it can't be set over 110km/h - my speedo reads 10km/h low at 100km/h.

For those interested, the factory radar cruise can apply the brakes HARD if it feels the need (it has activated the ABS in mine before), and can slow the car down to around 5km/h or so. It might be able to stop completely, though I haven't been game enough to let it try.

If while driving you catch another car and the speed difference is too great, it will beep to indicate that another car is within the range of the radar, and either roll off the throttle or brake gently to maintain the safety gap distance you have set. If the speed difference isn't too high, it will just match speeds with the car in front without a beep.

The safety gaps are "far, very far, and stupid far"

It will only apply the brakes to maintain the set cruise speed if you are following another car, so on a steep downhill it will basically free roll. At 120km/h the cruise beeps and disengages.

Occasionally it will have a fit at some odd-angled road signs, when driving into morning/evening sunstrike, and it will sometimes 'see' oncoming traffic as being in your lane. Most of the time these events just produce a beep, as the object passes by and the radar clears. In some cases it will stamp on the brakes, though again only for a brief moment (though this is annoying for people following)

Fortunately in all cases it beeps which gives you time to react. Once you know what to look out for, you can predict it's behavior.

The brakes are activated by an actuator which actually pushes the brake pedal, it's creepy to feel it moving.

The cruise won't engage below 45km/h, or if the gearbox is in manual mode or snow mode, or if the windscreen wipers are on normal or fast. It also won't engage if the radar unit is obscured/disconnected.

It will disengage if the front wipers are turned on for more than 10 seconds or so (though it is happy to operate if the wipers are only on the intermittent setting). It will also disengage if the rear wheels slip, if the sensor becomes too dirty (following cattle trucks etc), if you corner too hard, or if the car aquaplanes. The cornering one I discovered playing on a track - you'd have to be *really* pushing on the road.

It must have a G or steering angle sensor somewhere also, as it will often allow the speed to drop while cornering, and then accelerate back to the set speed once the wheel is straight again. I guess this avoids ending up with a heap more power being applied mid-corner.

It's not without it's problems, but it's a damn clever system. Just a shame it can't be set over 110km/h - my speedo reads 10km/h low at 100km/h.

Yerp, discovered pretty much exactly what you wrote, about mine. Except haven't tried the hard cornering stuff. My speedo is also 10km out. Yeah the radar doesn't work too well when there's too much water spray following other cars, hence why it's designed to disengage if you set the wipers on anything else other than intermittent. I also get the same random blip of the brakes here and there (pretty rare though). As you said, would be nice if it could be set over 110km/h!

Also, depending on the vehicle shape and height, sometimes it won't detect the car until much closer than set... doesn't happen often, but still need to be on your toes. I haven't had it brake hard enough for the ABS to kick in, but I have a feeling once it got real close it would finally get a better radar bounce back and stop in time... just not game to test it lol.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I thought that might be the case, thats what I'll start saving for. Thanks for the info 
    • Ps i found the below forum and it seems to be the same scenario Im dealing with. Going to check my ECU coolant temp wire tomorrow    From NICOclub forum: s1 RB25det flooding at start up Thu Apr 11, 2013 7:23 am I am completely lost on this. Car ran perfectly fine when I parked it at the end of the year. I took the engine out and painted the engine bay, and put a fuel cell with an inline walbro 255 instead of the in tank unit I had last year. After reinstalling everything, the engine floods when the fuel pump primes. if i pull the fuel pump fuse it'll start, and as soon as I put the fuse back in it starts running ridiculously rich. I checked the tps voltage, and its fine. Cleaned the maf as it had some dust from sitting on a shelf all winter, fuel pressure is correct while running, but wont fire until there is less than 5psi in the lines. The fuel lines are run correctly. I have found a few threads with the same problem but no actual explanation of what fixed it, the threads just ended. Any help would be appreciated. Rb25det s1 walbro255 fuel pump nismo fpr holset hx35 turbo fmic 3" exhaust freddy intake manifold q45tb q45 maf   Re: s1 RB25det flooding at start up Fri Apr 12, 2013 5:07 am No, I didn't. I found the problem though. There was a break in one of the ecu coolant temp sensor wires. Once it was repaired it fired right up with no problems. I would have never thought a non working coolant temp sensor would have caused such an issue.
    • Hi sorry late reply I didnt get a chance to take any pics (my mechanics on the other side of the city) but the plugs were fouled from being too rich. I noticed the MAF wasn't genuine, so I replaced it with a genuine green label unit. I also swapped in a different ignitor, but the issue remains. I've narrowed it down a bit now: - If I unplug and reconnect the fuel lines and install fresh spark plugs, the car starts right up and runs perfectly. Took it around the block with no issues - As soon as I shut it off and try to restart, it won't start again - Fuel pressure while cranking is steady around 40 psi, injectors have good spray, return line is clear, and the FPR vacuum is working. It just seems like it's getting flooded after the first start I unplugged coolant sensors to see if its related to ECU flooding but that didnt make a difference. Im thinking its related to this because this issue only started happening after fixing coolant leaks and replacing the bottom part of the stock manifolds coolant pipe. My mechanic took off the inlet to get to get to do these repairs. My mechanics actually just an old mate who's retired now so ill be taking it to a different mechanic who i know has exp with RBs to see if they find anything. If you have any ideas please send em lll give it a try. Ive tried other things like swapping the injectors, fuel rail, different fuel pressure regs, different ignitor, spark plugs, comp test and MAF but the same issue persists.
    • My return flow is custom and puts the return behind the reo, instead of at the bottom. All my core is in the air flow, rather than losing some of it up behind the reo. I realise that the core really acts more as a spiky heatsink than as a constant rate heat exchanger, and that therefore size is important.... but mine fits everything I needed and wanted without having to cut anything, and that's worth something too. And there won't be a hot patch of core up behind the reo after every hit, releasing heat back into the intake air.
    • There is a really fun solution to this problem, buy a Haltech (or ECU of your choice) and put the MAF in the bin.  I'm assuming your going to want more power in future, so you'll need to get the ECU at some stage. I'd put the new MAF money towards the new ECU. 
×
×
  • Create New...