Jump to content
SAU Community

Recommended Posts

  • Replies 158
  • Created
  • Last Reply

Top Posters In This Topic

hellllll yeaah!!!!  seeing as you guys have all bailed on me! :D

Oh you are so talking to the hand after that one :D

and yes i'm only kiddin before you all start hammering into me :D

I have no further comment to make at this time... *smirk*

hahaha your all classics...  :D

Hope i can get outta bed to be there at 10:15 :D

sawakita I live in bbecroft too wanna meet up and cruise out there (thompsons corner or somethin)

ronin what sevicing you gotta do? jus brakes or more??

cheers...

thats a very good idea.. bcos i'm worrying about the way back to beecroft!! i'm very bad at geography and i got short term memory... so its ok if u can lead me there and back?? ^.< where do u want to meat up???

hahaha your all classics...  :D

Hope i can get outta bed to be there at 10:15 :D

sawakita I live in bbecroft too wanna meet up and cruise out there (thompsons corner or somethin)

ronin what sevicing you gotta do? jus brakes or more??

cheers...

good idea.. bcos i'm worrying about the way back to beecroft!! i'm very bad at geography and i got short term memory... so its ok if u can lead me there and back?? ^.< how about we meet at beecroft station??

Hey guys... thanks,

It was a great day and as Moanie said, good to put faces to names.

SLY33: you wheren't the "FLYDLICE" car where you?... If so, i was there when you got back...

Thanks for a GREAT day guys, was fun and we didn't have any trouble so it's all good.

I look forward to organising more in the future after today so lookout for them :D

cheers,

Dave.




  • Similar Content

  • Latest Posts

    • Yeh I think i'll message an old contact i had for ages that manages his own tyre shop now.. n tell him what i want n work with him before ordering..  Got this 17x9 +30 Driftteks on 245/45/17 PSR Drag Radials on the rear.. They fit well - for your reference in future - Rear guards  have been lipped in & minimal to non flaring of the rear Gaurds.    
    • If only it were that easy! I also needed to remove seats, shocks, brake calipers, send my car through a fence, and use measuring and ended up guessing because I didn't remove seats, shocks and brake calipers. It can be hard sometimes Can be a little more complex than 'just measure' if you want to truly measure the entire wheel through all of it's suspension travel. But if you aren't going for every last mm then yeah, you can check the space you currently have and guesstimate.
    • If you own a car, and it has wheels on it, and you know the offset of those wheels, and you have a measuring device, you have everything you need to work out if other wheels will fit.
    • Will this fit? but they are staggered set - RAYS 57DR SEMI GLOSS BLACK 18x8.5 +37 | 18x9.5 +38 5-114.3 STAGGERED SET   or If no go could just get a set 4's wheels of 18x8.5 +37 5-114.3 - would i run 8.5's 235s up front n 245's at the back if I do?   Thanks.        
    • Put a clamp on your return line. I have a feeling it's sucking air, and introducing bubbles to your fuel. With a lot of fuel, less problematic. I'd honestly be redoing all the lines in the tank and clamps on everything.   Also, you've given two different answers to the same question: Asked if being followed by the police you could get down to use the whole tank, you said yes you could, so long as you keep off boost. However, you then followed this up that free revving, it would also cause the issues. I'm doubting free revving is enough to make any noticeable boost on what is likely a decent sized turbo.   So now I have to ask, can you actually drive it lightly and use all the fuel, or does it break up even free revving? Also, have you put a fuel pressure gauge on it? Can you hear the pump change noise at all when you're having this issue?
×
×
  • Create New...