Jump to content
SAU Community

Recommended Posts

1994 Nissan BNR32 GTR.

VIN: 6U9000BNR32309395

Engine #: RB26APO42229A

89,777 kms on after market speedometer. (70,000 on odometer when i purchased the car in feb 07)

Second owner in Australia.

Rego runs out 11.09.2010

Located in Vermont, Victoria

Selling due to expanding family.

Price: $20,500 or may swap for manual turbo wagon e.g. Nissan Stagea or Subaru Liberty

Engine Modifications:

Rebuilt standard turbos steel wheeled, 360deg thrust bearing and highflowed by ATP.

Trust front pipes, high flow cat, Jasma SR cat back exhaust.

HKS twin pod filters with heat shield

Ported exhaust manifolds

JustJap air/oil separator

Nismo fuel reg

Nismo 600cc injectors

Power FC and hand controller

Greddy Profec B boost controller

Cam gears tuned for low down torque and response

Gates timing belt

50mm alloy radiator

Exedy heavy duty puck clutch.

Bosch 040 fuel pump

Greddy air diversion plate

Suspension/Brakes:

Tein Ha coilovers... not uncomfortably stiff.

Whiteline adjustable sway bars front and back

Whiteline adjustable front castor bushes

Solid rear cradle bushes

Hicas lockout bar and all lines and pump removed

Cusco front and rear strut braces

Master cylinder rebuilt with steel sleeve

Ebc brake fluid

RDA slotted front rotors

Endless Super Street front brake pads

DTM Rush18x9.5 +15 wheels in satin black with nankang 255/35/r18

Interior:

Momo tuner steering wheel

New leather handbrake and gear boots

Blitz fatt dc turbo timer

Nismo 320km/hr speedo

Nismo gear knob

JVC head unit with aux input

Infinity front speakers, pioneer 6 inch rear speakers.

Cobra 2260 alarm with turbo timer bypass, passive arming and level reference sensor.

Tinted windows.

Exterior: Has been resprayed in the past by previous owner. Rear wiper removed (can be replaced) A few nicks and pin dents in paint work that can be pointed out on inspection.

Maintenance:

100k service with new water pump, idle and tension bearings, and timing belt.

Front wheel bearings replaced, front right drive shaft replaced, front upper control arms rebuilt.

Platinum sparkplugs gapped to .8

Oil and filter change every 5000km with either castrol edge 10w60 or royal purple. Motol gear oil in diffs. Redline lightweight shockproof in gearbox.

Tuned for low down torque and response and engine safety. Tuned by Craig at Revzone. Made 281 all wheel kw at 18psi. see here: http://www.skylinesaustralia.com/forums/Rb...html&st=140

For more information and contact details send me a PM or make a post.

post-17186-1272777297_thumb.jpg

post-17186-1272777316_thumb.jpg

post-17186-1272777323_thumb.jpg

post-17186-1272777330_thumb.jpg

post-17186-1272777344_thumb.jpg

post-17186-1272777353_thumb.jpg

Link to comment
https://www.sau.com.au/forums/topic/318931-1994-bnr32-gtr-20500/
Share on other sites

yes, i agree. but..... a gtr for $16 000 will most likely need a few thousand spent on it to get it up to standard. Plenty of cheap gtrs going, that will end up costing you more than you ever expected. Just ask someone that has purchased a cheap gtr! (you probably already know this Chibs). Hopefully a person smart with their money will see that buying a well sorted car will save them money in the long run, over buying a cheap, but abused car.

Having said that, the price i have set has a 'o.n.o' after it :D

i'm trying to convince myself to sell my r33gtst and buy a gtr

wasn't sure if i wanted a 33 or 32, but looking at yours has convinced me i want a 32!

great looking car mate. i hope for my sake, its still for sale in about a month

what fuel economy do you get? gtr daily would be nice

thanks for the compliments nakuma. fuel economy is surprisingly good. 550km easy for highway driving, not sure about the exact economy for stop start town driving, but its very reasonable. I drive it most days to work and don't have fuel rage :ninja: .

Its not that your price is unrealistic... its that people dont really have 20G'z to spend on it now days....

You see GTR'S going for 16-18

Wait till that cheap nugget fpos chews a bearing, and you'll see just how cheap that GT-R is......

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I got back to Japan in January and was keen to get back on track as quickly as possible. Europe is god-awful for track accessibility (by comparison), so I picked up a first-gen GT86 in December just to have something I could jump into right away. The Skyline came over in a container this time and landed in early January. It was a bit battered after Europe, though—I refused to do anything beyond essential upkeep while it was over there. The clutch master cylinder gave out, and so did the power steering. I didn’t even bother changing the oil; it was the same stuff that went in just before I left Japan the first time. Naughty. Power steering parts would’ve cost double with shipping and taxes, so knowing I’d be heading back to Japan, I just postponed it and powered through the arm workout. It took a solid three months to get the car back on the road. Registration was a nightmare this time around. There were a bunch of BS fees to navigate, and sourcing parts was a headache. I needed stock seats for shaken, mistakenly blew 34k JPY on some ENR34 seats—which, of course, didn’t fit—then ended up having the car’s technical sheet amended to register it as a two-seater with the Brides. Then there’s the GT86. Amazing car. Does everything I want it to do. Parts are cheap, easy to find, and I don’t care what anyone says—it’s super rewarding to drive. I’ve done a few basic mods: diff ratio, coilovers, discs, pads, seat, etc. It already had a new exhaust manifold and the 180kph limiter removed, so I assume it’s running some kind of map. I’ve just been thrashing it at the track non-stop—mostly Fuji Speedway now, since I need something with higher speed after all that autobahn time. The wheels on the R34 always pissed me off—too big, and it was a nightmare getting tires to fit properly under the arches. So I threw in the towel and bought something that fits better. Looks way cleaner too (at least to me)—less hotboy, less attention-seeking. Still an R34, though. Now for future plans. There are a few things still outstanding with the car. First up, the rear subframe needs an overhaul—that’s priority one. Next, I need to figure out an engine rebuild plan. No timeline yet, but I want to keep it economical—not cutting corners, just not throwing tens of thousands at a mechanic I can barely communicate with. And finally, paint. Plus a bit of tidying up here and there.  
    • Nope, needed to clearance under the bar a little with a heat gun, a 1/2" extension as the "clearancer", and big hammer, I was aware of this from the onset, they fit a 2.0 with this intake no problems, but, the 2.5 is around 15mm taller than a 2.0, so "clearancing" was required  It "just" touched when test fitting, now, I have about 10mm of clearance  You cannot see where it was done, and so far, there's no contact when giving it the beans Happy days
    • It's been a while since I've updated this thread. The last year (and some) has been very hectic. In the second-half of 2024 I took the R34 on a trip through Germany, Italy, France and Switzerland - it was f*cking great. I got a little annoyed with the attention the car was getting around Europe and really didn't drive it that much. I could barely work on the car since I was living in an inner-city apartment (with underground parking). During the trip, the car lost power steering in France - split hose - and I ended up driving around 4,000kms with no power steering.  There were a few Nurburgring trips here and there, but in total the R34 amassed just shy of 7,000kms on European roads. Long story short, I broke up with the reason I was transferred to Europe for and requested to be moved back to Japan. The E90, loved it. It was a sunk cost of around EUR 10,000 and I sold it to a friend for EUR 1,500 just to get rid of it quickly. Trust me, moving countries f*cking sucks and I could not be bothered to be as methodical as I was the first time around.
    • I assume clearances were all a-okay?
×
×
  • Create New...