Jump to content
SAU Community

Recommended Posts

ok this is a huge post so just bare with me,

Location is Adelaide.

R33 parts are from a S1, RB25 DET

R32 parts are from a RB20 DET

R33 Boot Lip spoiler - $150

sdc11008w.th.jpg

Full set of R33 mats - $100

sdc11007n.th.jpg

Rear parcel shelf - $30

sdc11006n.th.jpg

R32 GTR rear seats - $100

sdc11005o.th.jpg

S1 front bar - VERY AVERAGE CONDITION $30

sdc10916f.th.jpg

R33 Window washer bottles - $50 each

sdc10914x.th.jpg

Complete Doors in red, drivers is damaged but has everything inside - $350

sdc10915.th.jpg

sdc10989.th.jpg

Silver Boot with wing - $100

sdc11002.th.jpg

Red boot - $100

sdc10999d.th.jpg

Guards for the pair - $150

sdc10997h.th.jpg

R33 dash - $100

sdc10985r.th.jpg

Highflow 3" cat - $100

sdc10986h.th.jpg

R33 Radiator - $130 damaged one $80

sdc10984y.th.jpg

sdc10983f.th.jpg

R33 Passengers light - $150

sdc10974a.th.jpg

R33 Rear lights + center garnish - $120

sdc10975l.th.jpg

Rb25 coilpacks - $120

sdc10972.th.jpg

Standard R33 suspension - $150

sdc10964n.th.jpg

Tein R33 Coilovers, height adjustable - $500

sdc10963l.th.jpg

Greddy FMIC + all pipe work - $400

sdc10962q.th.jpg

sdc10961y.th.jpg

2 SR20 Manifolds - $300 each

sdc10960.th.jpg

R33 castor rods - $100

sdc10948.th.jpg

R33 starter motor - $70

R33 Power Steering pump - $70

R32 Starter motor - $70

sdc10947e.th.jpg

R32 GTR passengers seat, perfect condition - $250

sdc10938mk.th.jpg

R33 standard seats, small rip on drivers bolster - $150 pair

sdc10936q.th.jpg

Silver R33 doors, good condition, complete - $400

sdc10935f.th.jpg

sdc10934z.th.jpg

A pillar interior piece - $30

S1 Grill - $30

sdc10931o.th.jpg

Edited by JiN_MaN
  • Replies 54
  • Created
  • Last Reply

Top Posters In This Topic

R33 rear pods - $70

sdc10930s.th.jpg

R33 complete boot trim - $100

sdc10928y.th.jpg

Dash surround thing - $40 each

sdc10923t.th.jpg

sdc10922p.th.jpg

R33 exhausts

Twin pipes $350

Brand name Jap kaitamatiso (cant remember name) - $300

sdc10988.th.jpg

Complete R33 manual conversion without gearbox and clutch - $400

sdc10865.th.jpg

R33 uncut loom $120

R33 standard ECU - $80

R33 Cross over pipe + blow off - $60

sdc10867q.th.jpg

Clutch - NEED to be inspected

Exedy - $200

Nismo - $200

Standard - $100

Flywheels - $100

sdc10884k.th.jpg

sdc10883q.th.jpg

sdc10882.th.jpg

sdc10863f.th.jpg

R33 Airbox + snorkel - $100

R33 AFM - $100

sdc10893.th.jpg

sdc10891g.th.jpg

R33 tray - $15

sdc10890u.th.jpg

R33 BOV - $40

sdc10885n.th.jpg

R33 Steering wheels

Good condition - $100

Average condition - $70

sdc10911x.th.jpg

sdc10910rt.th.jpg

R33 overflow bottle - $70

sdc10913ew.th.jpg

Nismo steering wheel, no horn button - $100

sdc10917m.th.jpg

R33 Rear end - $400 (no wheels)

sdc10958s.th.jpg

R33 Engine Crossmember - $100

R33 sterring rack - $80

sdc10955w.th.jpg

And that concludes about 1/2 of the horde of car parts 3 brothers and a father have collected in 2 years.

Edited by JiN_MaN
Do u have any side skirts?

Nope sorry

Hey mate can u pm me your number interested in your "Complete R33 manual conversion without gearbox and clutch"

Done and done

Hey,

3" hiflow cat, is this ceramic or metal core?

Thanks :banana:

I have no idea, if you can give me a clue of how to tell I can check and get back to you.

Hey Jinman, Tein Coileys good condition? how many k's? no sign of leakage?

Condition is fine, I didnt get to drive the car, but was reported to be all good

Unsure km's, I could speculate but would never know the true exact km's, no signs of leaks and the rebound/compress no problems.

Jin Man, no reply Re: Coil Packs yet! :)

Sorry I get sick of waiting for for 5 minutes to write back to people.

Sorry its, $120 for the coilpacks only, loom and igniter are a different sale and not included in the coil pack price.

Greddy FMIC sold

Edited by JiN_MaN
hey mate, can you pm me your number? i'm after the engine loom (inc coil + ign), ecu and air box + snorkel if you still have em.

cheers luke

Pm sent

still have the right front guard?> how much for just that?

pat

0 410644102

$80 + postage

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • PRICE  : $1400 LOCATION   : NSW Central Coast FIT  :  All Nissan 350Z type Z33 and Infinity G35 Coupe. See delivery note. Hi, brand new, unused, still in the box.  ($1850.00 is what i paid ) My bad luck !!! I thought my right front  Bilstein was cactus so i bought the ST 's to replace all.  Turns out the right front is fine ( loose mounting after service  by a well known importer of Bilsteins ) So im selling the ST's. They are made by KW ( no intro needed ) . Iam on the Central Coast and im willing to meet up in Sydney metro, within reason and Newcastle.
    • Yep, yeah would need to do the flywheel although the 6 bolt NA clutch can handle a 20de if just wants to replace the stocker.
    • No it's fine. Heat sleeve is a thing. With oil running through it it is unlikely. Engine off heat soak can be a thing though. There is no way that you have a leak through the hose. That has pressure behind it and any small hole will turn into a large one in very short order. It is so much more likely to be leaking from the connection.
    • Really? That's piss weak. I didn't know they hobbled the shitboxen that badly. OK. So probs need to buy a flywheel too. But that's not too bad.
    • Hi all. I already posted some newbie-ish questions here and there but this will be my first "big" post. Last summer I went and fulfilled a kind of childhood wish, because I just thought I needed this experience in my life no matter what. The car I bought is a mildly modded 1995 BCNR33 Vspec. It was repainted to a metallic orange color all around and it had all windows reseated. Not so well done black respray in the trunk and a metallic black in the engine bay. From outside it looks very nice except for a minor paint error on the roof and the rear spats needing new adhesive tape. The inside is pretty clean and no broken plastics, missing or faded buttons. Even the adjustable mirrors and trunk antenna work like a charm. Despite a moderately long list of issues I don't (yet) regret buying this car. Most mechanical problems are just due to age, like worn rubbers here and there. The underside sadly has lots of corrosion, especially to the back. It looks like it either has been driven in the winter for a while or it lived near the saltwater in Japan, the rust is nothing terrible but it'll require to be looked after. Mostly panel gaps and all the mounted components underneath are a bit crusty, but I don't think anywhere has progressed so badly that there's going to be holes. Front right jacking rail is crushed and needs some care so it doesn't develop into a rust crater at some point. Worst part is definitely the strut towers. I thought they looked fine but after taking off the strut bar I noticed that it actually started bulging up on the passenger side. Probably would have passed on the car or negotiated down by some thousand Euros more if I had noticed this before buying, but here we are. Trunk area also has signs that there was a water leak to the interior once but nothing too crazy, I guess lots of Skylines had this at some point. As for the list of (known) issues, I'll try to make this compact. I hope the coloring is self explanatory. Mechanical: -Various busted or soon-to-be busted rubber bushings and ball joints. Will replace ball joints with OEM or better and bushings with polyurethane where possible. -Shaking steering wheel at above 80kph -downshift from 5th to 4th is a bit crunchy unless I rev-match, might just try to renew the shifter assembly, but it's not a priority issue -tailshaft centre bearing could use a replacement, is it worth going 1-piece tailshaft as it doesn't look too fresh all around? Chassis: -underbody corrosion on many spots and in hollow spaces, needs to be treated -corrosion on many bolts, hoses, lines, suspension components, subframes, will be treated when replacing of the bushings is needed as time goes on -strut tower top panels and some of the surrounding panels are rusty, so needs fixing. Will look into doing this with a buddy in the winter, otherwise bite the bullet and pay a professional -driver side door is misaligned to the body and needs to go a slight bit more inwards -both door windows are misaligned and have an airgap where the window meets the door at the B pillar -The Aerocatch latches for the bonnet have locks but no keys, need new keys. -driver side door window is kind of gritty and could use a polish -damaged jacking rails and front frame rails, from people lifting the car the wrong way, might have this fixed by a bodyshop Electrical: -Nismo tachometer is just bouncing and displaying nonsense, supposedly worked fine when the stock ECU was still in the car -An old Greddy boost controller sits on the dash which will be removed as it servers no purpose anymore. -a led segment rpm gauge is on the steering column, will probably also be (re-)moved once the Nismo tacho is working correctly -there was an attempt to make the sound system better by the previous owner but it was just inducing noise all the time, ripped out the amp and filters in the back, no music for now -trunk antenna goes up as long as the radio is on regardless of the mode, I want it to only rise if I choose Radio specifically or per switch -3rd brake light is a bit dimmer than the taillights but everything was converted to LEDs so mabye now it just seems dimmer? -reverse light flickers, have to test if that behavior changes when I fiddle with the gear stick. Hope I can get around changing the switch. -Left side taillight, blinker section has minor water intake and is humid after washing. Other side has a hole in it, probably for that exact reason. I'll probably reseal them entirely and plug the holes. Engine: -minor coolant drips on one or the other hose -rear turbo leaks oil onto the exhaust making the car essentially undriveable due to fire hazard -Oil filter relocation kit has an oil drip at the Dash lines, will probably make a new connection there and tighten real good and pray -throttle body assembly is slightly stuck for the first throttle pedal input after sitting for a while I'm always open to suggestions and advice from more experienced people, I'm sure half of this list is easily dealt with and just requires some time and effort to sort out properly. Once I have some proper pictures of the car I will post some in this thread, I just have to remember to take some more once I get the chance to. Will post updates when I have news on anything, I want to try to keep this thread as kind of a logbook as well. Ultimately my goal for this car is to just enjoy it. An engine rebuild is probably going to happen sometime as well, because it is old after all. It will never be fully new again, I am just not that rich. But I want it to look good, work well and not rot away while I drive it. I'm probably gonna spend a lot of money on this journey, hopefully not an unreasonable amount.
×
×
  • Create New...