Jump to content
SAU Community

Recommended Posts

hey, i know this is pathetic and for most people is common sense, but if someone could please help a fellow noob out it'd be appreciated.

ive been searching on this and other forums about the correct spot for the jacking points for mainly the rear wheels. now when it comes to the chassis side of things im not really educated much in the area, and have heard that the x member (not a clue to what this is), and the diff (diff support, or something?) are good spots for jacking.

again, if anyone could enlighten me id be grateful. :D

Link to comment
https://www.sau.com.au/forums/topic/321801-jack-points-for-r33-skyline/
Share on other sites

hi, ok so the jack will have to go right in the middle where the diff housing is? or next to it, according to what side wheel your doing?

cheers.

I use the middle of the diff to jack the rear up. You can use the jacking points on the left / right hand side.

Also this was the 3rd result in google http://media.photobucket.com/image/r33%20j...kPoints.jpg?o=1 these are the official jackpoints, I only use them for the front because my jack cannot reach the chassis.

Hi, i saw the diagram there, though still was hesitant about putting it on the rigid rack parts because wasnt sure if it would suit a hydraulic jack as i dont have one of the genuine nissan ones. and to get to the diff i dunno if i can even get my head in there to see anthing let alone fit my jack in there. car might be a bit too low. :yes:

shit i think im paranoid that my car will topple over and possibly ignite leading to a gigantic explosion.

lol, thanks for the replies guys. :cheers:

Hi, i saw the diagram there, though still was hesitant about putting it on the rigid rack parts because wasnt sure if it would suit a hydraulic jack as i dont have one of the genuine nissan ones. and to get to the diff i dunno if i can even get my head in there to see anthing let alone fit my jack in there. car might be a bit too low. :cheers:

I use a low jack + half a brick to reach my rigid jack points :yes:

Another solution is to drive the car onto something to get to a point where you can jack it, I've seen plenty of people say 'ramps' but if your car is very low its hard to find ramps low enough to put the car on.

what I normally do is raise the car a bit with the floor jack, position it under the sill. Then I can slide the trolley jack under the diff or cross member.

Do not go underneath your car while it's resting on the jack !!!!!! Please use the car stands, jack is not stable.

  • Like 1
  • 1 year later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • For these last 7 years of ownership, I've always had to use a small scissor jack under one of the front tow hooks to raise the front just enough so my low-profile jack fits under to reach my subframe jack point. I'm beginning to get annoyed of always having to do this. Are there any lower low-profile jacks that fit under the gtr lip on a dropped car?
    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
×
×
  • Create New...