Jump to content
SAU Community

Recommended Posts

Hi,

For sale is a set of 4 Yokohama Advan AO48 Semi Slicks.

Sizes are all 255 / 40 / R17.

Had a couple track days use, 2 tyres are not far from new at approximately 90%, and the other 2 at about 60%, all with fairly even wear.

Always been stored undercover, out of the sun and dry.

After $1000ono

Located in Melbourne east, can arrange freight if needed or pickup is good.

Cheers!

Mat.

0400 558 030

post-17897-1274744117_thumb.jpg

post-17897-1274744139_thumb.jpg

post-17897-1274744172_thumb.jpg

post-17897-1274744192_thumb.jpg

Link to comment
https://www.sau.com.au/forums/topic/322032-yokohama-advan-ao48-semi-slicks/
Share on other sites

  • 2 weeks later...
  • 2 weeks later...

AH SHIT Troy you should have told me you wanted these, wouldve had no issue holding onto them for you!

Oh well.

You at August DECA is a way more exciting thought though!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Legend. I ended up finding the facebook account of the owner of the first car i sent but sadly he deactivated the account. I think you’re right in saying it’s some sort of well done custom job. Really appreciate your help anyways.
    • Totally equivalent. Stock often goes from the comp cover because that's where the actuator is also installed and the factory needs 2" of hose to make the connection - and it comes as a pre-assembled unit. They totally have a boost reference from somewhere between the turbo and the throttle(s). Oh, jeez. Just do it in M12 then. We don't actually care that much. I would expect any such AN converter fitting to rely on an o-ring or some other seal onto a flat surface under the flange of the hex**, because bolt threads are no intended to provide a pressure seal. unlike..... pipe threads. **which also requires a suitably flat and smooth surface on the turbo's boss to provide the seal.
    • I also used NP   That’s were it’s seems to be the best place to fit it? All schematic shows also that it’s should be referenced from the turbo housing. But idk, I do see high hp cars without any connection or anything to their turbos, so I really don’t know how they connect their things
    • I do have loctite 243 and 246 and a few more models. I could drill it now in place and make new threads for m12 and order an4 - m12 coupling and fit that to the turbo. Run a braided hose to the EBC which I could get a an4 to 1/8npt 
    • So M12 and sealant should be fine?    NPT ” because that’s what I had and what I could get atm. 
×
×
  • Create New...