Jump to content
SAU Community

Need To Drain Current Petrol Any Easy Way Beside Letting It Run Out While Car Is On

boostn0199
 Share

Recommended Posts

N1GTR Grand Master

N1GTR

Posted
Posted

Get a petrol jiggler hose, put the brass end in the tank (of course it will have to be quite long), jiggle it a bit and that will get most out

Then take the line off the fuel reg and turn the key to ON so the pump primes. Repeat. Will take a fair while but it's simple.

N1GTR Grand Master

N1GTR

Posted
Posted

Btw that's what happened to my car when it switched to e85. I got the shits with the tiny bit that was coming out with every prime so it was easier to just turn the fuel pumps on through the ecu and it took hardly any time at all to empty the tank

skins Grand Master

skins

Posted
Posted
Is there a way to turn on the pump from the powerfc hand controller to keep working til it runs out?

I had to empty mine and i used the jiggler through the boot opening. Was a pain and it stank of fuel everywhere but it got done. Then a mate said why don't you just drill a hole in it at its lowest point and then use a roofing screw ( which has a rubber seal on one end ) and put the screw in the hole. I thought that could work but didn't attempt it.

joeyjoejoejuniorshabadoo Grand Master

joeyjoejoejuniorshabadoo

Posted
Posted
On my previous car I pulled off the fuel return line and pointed it into a bucket and started the car. It then pumps all the fuel into the bucket.

this is what i do when i swap between 98 and e85

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Latest Posts

    • aznriptide859
      How To: "Refabricate" a Stagea 260RS/R33 GTR Speedo Sensor

      By aznriptide859 · Posted

      Yes the gear for the R33/34 is different, it is red and has a different number of teeth. My part didn't come with that gear though, so I don't know how many teeth are on the red one. You'd have to reuse the 260RS/R33 gear, as long as it's not destroyed.   Haha, as unfortunate as that might be it was working fine for about the first 1500km I've had the car for now.
    • sinn3r
      R34 Skyline climate control unit transistor

      By sinn3r · Posted

      Update all   thanks to the workshop manual, it lead me back to checking fuses as mentioned central locking and door open lights worked when acc was switched on. diagram attached shows two points of power 1. ACC and 2.  Batt with the later being fused (#28) I did check the fuses using a multimeter but I must have stuffed that up also. Went back and checked the batt fuse in interior fuse box and you wouldn’t believe it… a blown fuse. replaced fuse and everything is now working as it should including the climate control   thank you all with your positive insight and knowledge.    
    • MBS206
      Lock up the old for sale / wtb threads.

      By MBS206 · Posted

      Where is the warning "That this thread is super old"   I just went into a 5 year old thread, went to do a reply, and couldn't see anywhere obvious a warning of it being super old
    • Rezz
      WGNC34 - floor mats

      By Rezz · Posted

      Duncan is correct. Pitwork (and Toyota's own cheap brand "Drive Joy") were primarily created as brands to sell other manufacturers car parts. It would be weird if Nissan sold parts for Toyota vehicles with a Nissan logo on it, so they created Pitwork to sell parts for other brans Toyota, Honda etc. They are not the same as Nissan genuine parts, although they *do* meet Nissan's standards for replacement parts. They aren't supposed to be a substitute for genuine parts, but a cheaper alternative that is better than Ebay fake parts from you-know-where.
    • Ozdavroz
      Starting again

      By Ozdavroz · Posted

      Thanks GTSBoy, much easier to work with it now it's free!  
×
×
  • Create New...