Jump to content
SAU Community

Recommended Posts

located in perth will post if buyer pays whole amount.

i have my turbo up for sale. i bought it second hand so i dont know who built it, i have replaced it with a propper upgrade. full boost just after 4k, but i did find that when i removed it i was missing 2 exhaust manifold studs and as a result had an exhaust leak on cyl 1 & 6. so i dont know what it'd be like on your car. better than mine i presume.

- made just under 270rwhp @ 1 bar on the ovaboost dyno with a safe tune.

- steel wheels

- OP6 rear housing

straight bolt on for rb25. stock dump stock lines all bolt up no worries. i'm not going to include the stock dump or lines incase i need to revert back to stock in the future. however, with that said i will include an aftermarket dump that has a screamer pipe.

also;

- 1 dump bolt has snapped (see pic)

- hardly any shaft play. only a tiny bit of side to side. i dont know if this is normal for journal bearing. either way it never caused any problems, never blew smoke, functioned perfectly and was quite punchy compared to a stock turbo.

$400.

pm if you'd like to grab it.

SDC10437.jpg

SDC10436.jpg

SDC10435.jpg

SDC10434.jpg

Link to comment
https://www.sau.com.au/forums/topic/323524-wa-rb25-high-flow-turbo/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The powder coating came in at $250 EACH. The TRX rims got a coat of clearcoat on the outside only.    
    • Bit wet, but YUMMY
    • Keeping in mind that I am currently getting flat 10 L/100km on my RB25DET, which means >>500km/tank. I would test this car for vacuum leaks, check codes and AFM signal with NissDataScan as D says, check plugs, do a compression check while they are out.
    • It is hard to be specific half way across the world...but it *seems* like it might have a minor issue. Is the idle stable and does it rev smoothly? I would not expect any pops out of what I am assuming is a standard ECU, standard tune, standard exhaust. You can use Nissan Data Scan to find out exactly what is happening when it runs, the cable/software is reasonably affordable if you are not planning on changing the ECU (which hopefully you are not with an NA skyline) BTW your mileage may not be that far off, these are heavy old tech cars, and being NA might mean you use a heavy foot to keep up with traffic....
    • Hey guys! Y'all are the masters so figured I'd check in on a few items here. - My engine sounds ever-so-slightly more raspy than the other NA RB25s I've listened to. It's barely noticeable but definitely a slightly different sound. - When I back off the throttle at high RPM, I will sometimes get a pop out of the exhaust, assuming this can be diagnosed as misfire. Some history on the car: - Had an exhaust leak in auction sheet but was claimed to be fixed by seller (bought from USA importer).  - Car's coil packs and sparks were replaced when it was sold to me, but unsure on what the gap is and whether the coil packs are correct.  - A prior mechanic had misdiagnosed a pilot or throwout bearing sound as LSPI/detonation. Had played with timing a bit, pops/raspy sound of engine just got worse. Got timing reset. - Had failed emissions a few times. First time went in as is, failed. Second time, replaced cat, still failed, running rich as hell. Third time replaced o2 sensor, passed. Car still smells gassy though. - Timing belt and valve cover gasket also replaced.  - Gas mileage is... low. about 350-400K per tank.  Any idea if I'm having any serious issues here or does this all sound like normal old NA RB stuff and I'm fine to drive it with the pops/slightly raspy engine? If it'll help, I can get drop a video of the sound of the engine.
×
×
  • Create New...