Jump to content
SAU Community

Recommended Posts

  • 4 months later...

i did this once one day when i was bored (yes i get bored easily)... sounded fullsikwesidephat, or another words fuggen loud

reality is at idle it was hunting all over the place between 450-1600RPM & you can hear it leak slightly at full load. a good way to really confuse the ECU

.

hey guys this is prob a good time to ask this....

The compliance guys i took my car to last yr didnt block or take off the stock BOV and it has an after market BLITZ one on as well and the BLITZ doesnt even sound loud. Whats a good safe way to block the stockie.

Thanx guys  ;)

you have the same as me.would somthing like im suggesting be legal my question is why arnt there kits that cater for the top pipe to be replaced so there would be no need for stock bov,bov air return piping the pipe that runs from the elbow to plenum(would you keep it or is it possible to toss it?) plug intake pipe can it be done within law?

performance wise what is the efect it will give

you could also run a steel intake pipe.any suggestion for thought.

I need your suggestions because ive come across a deal with a neighbour who can supply me with the aluminium pipes.

:)

hey guys

I did wat Nick said and bout a blanking plate....and damn thats alot better...not a single problem with the engine or anything...runs like a dream....im getting way better response too....now b4 4500rpm i get this lovely whirling wastegate noise and over 4500rpm i get this massive pressure noise which i looovvveeee :headspin: ....thanx nick man !!! :D

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...