Jump to content
SAU Community

Recommended Posts

What is the best way to check if you have a air leak somewhere in the cooler pipes? i have checked and tighted all clamps!

cheers

Using a smoke tester would be the best method, because it will send smoke signals from where the leak is.

im think im either going to make or buy a boost leak tester!

i have 3 questions tho

1, do you have to block both ends of the piping ( for example put your tester on the turbo outlet pipe to the cooler and block off at the intake near the throttle body)?

2, it is easyer to take the throttle body pipe off, can i put my tester there?

3, and if i put my tester there can i leave the other pipe still connected to the turbo? or wont that work or will is damage the turbo?

you want to block it off at the turbo end. this way you can test to see if the leak is coming from the inlet manifold.

if you have a boost controller you may want to remove it as some will leak if you pressurise it above the pressure it is set at. i know the turbotech ones will since they have a hole drilled in the side of them.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Starter motors used to use the weight of metal (magnets) to provide torque. Now they use (more) current instead. This. It's completely normal.
    • So thing that had me stumped, but I think is OK....is that when it was up in the air, in neutral I had it running to bleed to coolant while I put the wheels back on. I noticed the rears were turning (slowly) which I'd never seen before 20250928_163512.mp4     Because there had been an issue with clutch slip due to pedal adjustment on the dyno, I assumed there was still and issue so spent some quality time upside down under the dash adjusting the pedal....but no matter what I did the wheels still turned in neutral. Even disconnected the master cylinder to pedal rod and same. In despair, I even removed the clutch slave so there was no chance of any preload causing it.....still happened. So either: 1. Something is not right in the bellhousing, or 2. Its a thing sometimes with cold, thick gearbox oil Internet says it might be 2, I hope so!
    • OK, few more things sorted and it is ready for a shakedown on 10-Oct, with one weird thing. Changed the run in oil and filter for the good stuff. 8l came out, about 8.5 went in with filter so that looks all good. Changed the starter (again), this time for a brand new one, works good. Interesting that the Taaaarks one is shorter than factory but spins harder, I guess electronics have moved on a little in the last 30 years. Will be nice to have a bit of extra space under there. Put the timing cover back on, and noted where the cam gears were set as a record.  Will need to double check the timing but it is pretty close. Also put the coil pack cover and intake snorkel back on. Exhaust Inlet Changed the water out for coolant, bled up nicely. Removed the rear brake pads (well worn factory sumitomo ones!), gave the hardware a good clean and reassembled. I've put bendix XP on the back again because the price is excellent at $150 a set and they worked well on the V37. Front pads have plenty so no issue there
    • Mine is all -12, I’m running a dry sump in a billet block though 
×
×
  • Create New...