Jump to content
SAU Community

Recommended Posts

Hi guys

Just had my 2000km service and took a 370 for the day

Very impressed with the interior lighting at night, and appears it has the euro style interior led downlighting onto the centre console

The map light/interior light switch in the 370 looks to be identical to the GTR, even down to the tiny oval hole where the led emits the light

But on my GTR it doesnt illuminate. Now is it just my car, or is the GTR supposed to have the red downlighting as well? It seems strange theyd put an led in the 370 but not the GTR

If this is so, i might look into buying the map light piece out of the 370 and doing some retro wire taping

Edited by domino_z
Link to comment
https://www.sau.com.au/forums/topic/329092-euro-style-interior-downlighting/
Share on other sites

I have a similar yellow LED in the 06 accord I had, actually is quite useful and not annoying. Shouldn't be that hard to retrofit it'd just be the issue of getting constant power there.

my m3 has the soft red downlighting as well, and illuminating onto white leather it looks great at night

would look really good in the GTR with red light illuminating the flat silver console

just strange that nissan put the same map light centre piece in the 370 as the GTR but pull the led out :P

ill go past jaycar and buy a few different angle 3mm red leds and see what works, otherwise i might see if buying the 370 map light isnt too expensive at the dealer

oh, and another thing i need to do is footwell lighting, yet another euro feature ive taken for granted

edit - this is where the led emits light from on the 370. You'll notice its identical to the GTR's - id imagine they'd use a 360degree led

check out this thread where they open it up, this is going to be easy

http://www.the370z.com/diy-section-do-your...html#post519440

post-73522-1279236440_thumb.jpg

Edited by domino_z

Im a huge fan of interior lighting when its done correct, i was in a Current S class the other night and it is stunning, 3 different color choices really classy in my honest opinion

i couldnt find any photos of the Zed but here is the S class in the "warm" mode

08c971_002-1280.jpg

s-class_overview_comfort_ambianceli.jpg

agree, the s-class (and the new e-class) under dash lighting looks amazing at night

the euro's have definitely moved on from putting leds under rear view mirrors and inside door handles

even our exterior needs attention, i put leds in the numberplate and parkers, and fixed the rear tail lights to illuminate all 4 stove burners

IMG_4710.jpg

my m3 has the soft red downlighting as well, and illuminating onto white leather it looks great at night

would look really good in the GTR with red light illuminating the flat silver console

just strange that nissan put the same map light centre piece in the 370 as the GTR but pull the led out :)

ill go past jaycar and buy a few different angle 3mm red leds and see what works, otherwise i might see if buying the 370 map light isnt too expensive at the dealer

oh, and another thing i need to do is footwell lighting, yet another euro feature ive taken for granted

edit - this is where the led emits light from on the 370. You'll notice its identical to the GTR's - id imagine they'd use a 360degree led

check out this thread where they open it up, this is going to be easy

http://www.the370z.com/diy-section-do-your...html#post519440

And I always thought thats where the bluetooth microphone was! :)

Edited by fungoolie
And I always thought thats where the bluetooth microphone was! :D

the bluetooth mic is behind the vent/slats to the right of the OFF switch position

pulled the map light piece out today, its identical to the 370, even has the groves to slot the oem 370 led module into it

i shown a small led torch through the hole and think i know why they didnt put a led in

the light is dispersed back near the handbrake lever rather than over the gear trim surround. However this can be fixed by using a 180 degree led and playing around with the positioning to push the light forward, not too hard

ill get started next weekend, too bust trying out a new wax today

Edited by domino_z

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drive beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • Yeah good luck out there! Will be good to see a mighty GTST going harder than the GTRs
    • i will be there 😁
    • Hello!  i just finished manual swaping my r34 skyline with a r33 rb20de box(RB71C)box  When the car is running it squeaks crazy loud and it was smoking from the gearbox area. The gearbox is fine it was tested. The clutch slave cylinder seems like it doesn't fully releases the clutch. I want to ask if this noise is from the throw out bearing or could it be the clutch assembly or disk att.xFliq87Gzw6kImKBVqDebXkj0fBqymk0JaYeP3_3SlM.mp4
×
×
  • Create New...