Jump to content
SAU Community

Recommended Posts

Motec M800 wideband lamba enable and datalogging

Full Loom with all the sensors

The custom loom has been marked for easy install (set up for rb25/26)

Bosch Super sports 491 leads

Bosch coils

CDI AEM Ignition module

Basicaly this stuff is all new or seen very little use,I picked it up for a project car that i have since sold as of today.

The motec has been tested and is unlocked in perfect working order.

I will fully refund any ones money if there is any problems at all with this gear.

To buy all of this stuff and have the added extras opened on the motec will cost you over 6g

Every thing is in perfect working order and is as new so grab your self a bargin.

My motec installer told me i did not need to buy a single thing every thing is here and ready to install.

I would post pictures but my phone wont connect to the pc,If any one wants pictures of the gear im more then willing to send them via text

Price $3850 ono

Trust Greddy T517z's

Serial number 021008012

Direct bolt on replacement for your gtr skyline.

I picked these up for a project that was sold today,One turbo was damaged so i simply had new cores/cartidges put in both turbos

Again these turbos are bascialy new and have had no use at all since rebuild.

Comes with acuators drains and so on,Also ill throw in the old cartridges and spare parts,There would be enuff parts to rebuild one turbo if you ever needed to.

These turbos retail new for around 4 grand

Price $2850 ono

Edited by Gtir-keiron
What size rear on the T517Z's? Also, what were the new cartridges, from Greddy/Trust or MHI equivalent?

Mike

the cartridges came from jpn mate.

I just paided a performance mechanic to put them together.

Ill have to check the rear on the t571zs is there any kind of marking i should be looking for mate?

They will have a 8cm or 10cm exhaust housing; should be on the casting. Can you post some pics?

They are 8cm rear housing mate approx 360 hp worth around the same 25/30 hks turbo

pms replied.

Please stop the lowballing on the motec guys every one knows what its worth to buy and have all that stuff upgraded.

Even in the 2 upgrades alone with the motec unit and just the upgrades your out of pocket over 4g.

If your really keen on the best computer on the market for your car with all the extras shoot me a text or give me a call on

0427284275

Edited by Gtir-keiron
Is the aem a 4 channel or 8 channel, and would you consider seperating?

I don t really want to mate if i can help it.

Id rather sell the package complete.

Enable M800

Hi/lo injection

Lamba Single

Logging 1M

Servo control

LSU4.0 (6066) Lambda sensor3 bar MAP sensor2 x 63CP0220 - 250AUNAOC TI or Honeywell sensors (oil and fuel pressure) approx $200 eaDelco Air Temp sensor (Brass)Bosch Engine Temp SensorMotec Mx00 series wiring loom6 x Bosch supersport ignition leads AEM 2801 4ch CDI6 x Bosch EL faclon coils (with bosch LJET 2 pin plug connection)

My motec dealer just price listed every thing up and the grand total is just over $6500.00

So grab your self a bargin at near half the price for as new items.

Enable M800

Hi/lo injection

Lamba Single

Logging 1M

Servo control

LSU4.0 (6066) Lambda sensor

3 bar MAP sensor

2 x 63CP0220 - 250AUNAOC TI or Honeywell sensors (oil and fuel pressure) approx $200 ea

Delco Air Temp sensor (Brass)

Bosch Engine Temp Sensor

Motec Mx00 series wiring loom

6 x Bosch supersport ignition leads .

AEM 2801 4ch CDI6 x Bosch EL faclon coils (with bosch LJET 2 pin plug connection)

My motec dealer just price listed every thing up and the grand total is just over $6500.00

So grab your self a bargin at near half the price for as new items.

bump

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Clutch is a spec brand, new clutch system,( PP, flywheel, friction disc, etc. pull type) installed 100 miles ago, with no problems.
    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drove beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • Yeah good luck out there! Will be good to see a mighty GTST going harder than the GTRs
    • i will be there 😁
×
×
  • Create New...