Jump to content
SAU Community

sw33t 33t damaged

chrisroi

By chrisroi,
in Western Australia

 Share

Recommended Posts

chrisroi Enthusiast

chrisroi

Posted
Posted

last night my wife was driving in pinjarra rd, centre lane as there was a car turning into a drive way [liquorland ] when a falcon driver pulled out of the same driveway to turn left and collected the front of the skyline, the girl in the falcon stated that my wife was speeding although she didnt see the skyline [clever girl able to tell if a car is speeding without seeing it] anyway damage is fairly minor as she hit just behind the headlight. the reply when asked which insurance they were with was [we aint got none] so its now in the hands of hbf.

Link to comment
https://www.sau.com.au/forums/topic/33572-sw33t-33t-damaged/
Share on other sites
bully Experienced

bully

Posted
Posted
last night my wife was driving in pinjarra rd, centre lane as there was a car turning into a drive way [liquorland ] when a falcon driver pulled out of the same driveway to turn left and collected the front of the skyline, the girl in the falcon  stated that my wife was speeding although she didnt see the skyline [clever girl able to tell if a car is speeding without seeing it] anyway damage is fairly minor as she hit just behind the headlight. the reply when asked which insurance they were with was [we aint got none] so its now in the hands of hbf.

Typical can afford piss but not insurance

Link to comment
https://www.sau.com.au/forums/topic/33572-sw33t-33t-damaged/#findComment-674489
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • GTSBoy
      Chris' Toyota Mark ii JZX110

      By GTSBoy · Posted

      I don't care for these at all, but at least the underside looks straight and not rusty. A good basis for a long life. Many cars from Japan have been lifted with forklifts and f**ked almost irrepairably.
    • GTSBoy
      RB26DETT Sketchy boost mod?

      By GTSBoy · Posted

      Yes, but it's not dumb or dodgy. You can build a perfectly good boost controller from a pressure reg, a relief valve (looks same same as a reg if all from Norgren or SMC, for example) and a check valve. I ran one for years. Only superceded with  EBC because I could get one for cheaps and wanted finer control.   THis mod is certainly not a sketchy boost mod, provided the boost is kept below the "spin to death" threshold of the turbos.
    • MBS206
      R32 update from 1990's spec.

      By MBS206 · Posted

      With ordering the belt, you're doing water pump and the idler and tensioner at the same time too yes?
    • joshuaho96
      RB26DETT Sketchy boost mod?

      By joshuaho96 · Posted

      This is just a dumb way of keeping the wastegate closed to make more boost. Undo it and either follow the factory setup or redo it properly. Manual boost controllers just use a spring preload to determine when to close in response to boost pressure so it no longer vents to atmosphere.
    • djr81
      R32 update from 1990's spec.

      By djr81 · Posted

      So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
×
×
  • Create New...