Jump to content
SAU Community

R34 Turbo Op6 Perfect Condition

Harey
 Share

Recommended Posts

Harey Veteran

Harey

Posted
Posted

Hey all,

I just had my turbo pulled off my R34 GT-T. It is the factory R34 turbo with OP6 rear housing.

It is in perfect condition, no shaft play at all.

Located in Richmond, Melbourne.

$350

Jeff 0400648813

I will take some photos tomorrow

Link to comment
https://www.sau.com.au/forums/topic/337304-r34-turbo-op6-perfect-condition/
Share on other sites
Harey Veteran

Harey

Posted
  • Author
Posted

Here are the promised pics!

Car has just clicked over 96,000kms and is in very good condition. Turbo was performing great and made 190rwkw on only 10psi dropping to 9psi. Only reason I took it off was that I am on the hunt for big power.

Happy to post.

post-29432-1284955431_thumb.jpg

post-29432-1284955443_thumb.jpg

post-29432-1284955447_thumb.jpg

chiksluvit Experienced

chiksluvit

Posted
Posted (edited)

high flowed R34 turbos make more power than high flowed R33 turbos, it has bigger exhaust housing

you'll need to put up with a little bit more lag but nothing major, tuned well it should peak around 20rwkw more or so than R33 high flow

Edited by chiksluvit
Harey Veteran

Harey

Posted
  • Author
Posted
when you say laggy... it still wouldnt be as laggy as a 3076...

also is the nissan 6 bolt stud pattern the same for r33/r34 ?

My understanding is that the OP6 housing is smaller then the 0.63 housing of the GT30 series so will definitely not be as laggy as a 0.82 on a 3076.

Yes the nissan 6 bolt stud pattern is the same for r33 and r34. 'Chicksluvit' runs an R34 hiflowed turbo on his R33.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • GTSBoy
      What brakes on R34 GTT(Europe)

      By GTSBoy · Posted

      The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Kapr
      What brakes on R34 GTT(Europe)

      By Kapr · Posted

      Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
    • Marek
      Hi everyone.

      By Marek · Posted

      Since winter isn't that harsh anymore in Poland, i will definetely drive it 365 days a year 😉. But if the snow hits i will try it for sure and let U know. Only swap i am planning to do is of course R34 GTR front 😍.
    • Marek
      WGNC34 - floor mats

      By Marek · Posted

      Hey. Very valuable information about pitwork, I will pay attention when buying any consumable parts 🙏 As for the carpets - I got a handful of information from nengun, from which it appears that indeed the carpets for the driver's side are OEM. They are not able to show me any pictures due to the long chain of different sales entities but after I place the order, as soon as the goods arrive at the nengun warehouse from which they will send the shipment to me they can send me photos and if my purchase differs from OEM I can immediately return it / cancel the purchase. I think I will give it a try 😉. Of course i'll let you know what's what as soon as i get them P.s. I know the topic is not relevant to the thread, but both nengun and amayama have these SICK 😍 trunk room lamps available. Do you know anyone who ordered them? I need to have one in my car
    • ARB26
      S1 Autech 260RS Wiring Diagrams

      By ARB26 · Posted

      I've managed to find this: Nissan_Stagea_AutechVersion260RS (1).pdf
×
×
  • Create New...