Jump to content
SAU Community

Recommended Posts

russ's car?

Yep.

also is it better to get my cams license insted

not sure if all tracks accept aasa for future events

and i left my memb no. empty cos i dont have one yet is that ok?

If you want to do anything other than winton and Deca then get a cams licence. It costs more though. Get it sorted sooner rather than later.

That sold out in record time!

No where near a previous one a few years ago. It was like 45mins!

  • Replies 165
  • Created
  • Last Reply

Top Posters In This Topic

My forms should have been faxed through now. ._.

Payment already made, as per my previous posts.

If I don't make it into this one, can payment go towards the next DECA or whatever? :blush:

send a PM to Belsil80 and your money will be refunded.

ppl will drop out. they always do so maybe hang on for a little bit?

as ppl drop the reserves make it in and those that didnt make the reserves get a spot in the reserve.

Entry Form & Supp. Regs. : SOLD OUT

FILL OUT FORMS COMPLETELY. INCOMPLETE FORMS WILL NOT GO ONTO ENTRY LIST.

***Also, if you are emailing you entry, please name the attached file after your full name and what page it is. eg. 'Ryan Bell Disclaimer'.

Event Schedule: Not yet available

Results: Not yet available

All withdrawles will be refunded after the event. Refunds will not be given after 5pm Monday 15th November.

That's what special guest appearances by the Fang Artists will do for ya. We're hyped. With the exception of Ash & Dave coz they may not have vehicle of choice at the time. In fact, Ash has NO chance :blush:

Sorry, who are the Fang Artists? Are you guys like painters or sculpters? :D

Rule 1 of Fang Artists: Don't talk about Fang Artists

Rule 2 of Fang Artists: See rule 1.

Apparently word has it that back in the day, they all had sweet rides. That is until most of them grew up and had families.

They still do the occasional Sunday lunch together and go to garden shows when time permits.

Sorry, who are the Fang Artists? Are you guys like painters or sculpters? :P
Guest
This topic is now closed to further replies.



  • Latest Posts

    • Ok guys thank you very much. GCG highflow it is then 🙂 
    • forgot to mention that when it does this it does not kill the engine, but I have not kept the pedal down long enough to let it, as I see no reason to beat up on it as its got to be something simple, small and dumb causing this.  And as soon as I let off pedal, the engine returns to its normal super smooth operation and rpms re-stabilize quickly, once below 4k. 
    • neither stumble or cut really seem to be an appropriate term....hard to explain its like a rev limiter but at 4k, but it violently shakes engine and entire vehicle as the rpms will not rise over 4k, even with slow acceleration. as soon as it hits 4k, it sounds like entire spark is lost entirely. plugs were 1.1 which I used as such, but later put in new plugs gapped down to .8 changed back after issue arose when I replaced the coils, still does it with either plug gap...damn and it was all running so good.
    • Oh how times have changed! I actually lean it out relative to my water/methanol injector duty cycle. The methanol adds a lot of fueling and you can then lean it out even more due to reduced knock. 
    • Yeah my thoughts are the same, a well thought out WMI setup, would be slightly ahead of just straight E85 and you're also chemically intercooling the charged air, dropping it even further. This is why you need to add so much more fuel as soon as you spray. I remember someone taking me through their set up before (Dennis, has a R33, lives around Cabramatta - no idea if he's still around on this forum). He would target AFR 10:1 on 98, then as WMI ramped on, AFR would lean back up to 11:1. Amazingly, he did this all through his PowerFC, a relay to cut power to his EBC solenoid if there was not enough line pressure on his WMI kit. And of course, if there wasn't any boost made above gate pressure, you wouldn't be accessing the load cells with heaps of timing for WMI. One downside to that rudimentary setup, once the WMI came on, the EBC would unleash the dragon, and of course all the timing. Tyres would fry lol.
×
×
  • Create New...