Jump to content
SAU Community

Recommended Posts

  • Replies 92
  • Created
  • Last Reply

Top Posters In This Topic

I'm open to suggestions for other cars so bring 'em on. Been considering an R32 GTR as well. Any massive don'ts on a $15,000 GTR?

um yeah. don't buy a $15,000 GTR and expect it to be a 'cheap' car. I'd go as far to say don't buy a $15K GTR full stop. unless you really know GTRs or plan to build a race car etc.

and it won't be any torquier under 2,000rpm than your S14. in fact standard GTR is quite laggy. even stock the fun is not on till 4,500rpm or so.

stock for stock you wont notice the difference between vvti and non. many mons ago i raced a vvti with my non vvti and it was pretty much a dead heat (as it should be). remember even the non vvti starts boosting at 1.5k.

personally i think your better of with a clean optioned up 95 with a non vvti engine but all the late model perks (bigger brakes, recaros etc).

if you ever plan on going single then scrap the vvti completely as there is very little aftermarket knowledge and most end up turning it off. remember supras were designed for the US market and they have modified them for every concivable thing from road racing to 185mph texas mile 1200hp straight line fear. also the US didnt get the vvti model only JDM hence there is very little way of keeping vvti when modifying. it can be done but make sure you have very deep pockets.

either way you wont be dissapointed and when you have over 400rwkws without building the motor while remaining reliable enough for daily driving...you wont stop :D

kristian. you. me. kitchen. talk. now.

hahah

and yes it's true.. only knobs drive soarers.

in all honesty - you probably shouldn't have said you're "open to suggestion" to cars in a thread that i'm reading. because i'll talk the leg off a chair.

i'll keep my opinions simple for you.. and TRY not to bore you

i got my car yesterday by the way.. soarers were a popular import from the mid 1990's up through to about maybe 2005 then dropped off the radar really - mainly because as their value dwindled.. as did their target market.. the biggest problem with soarers is they are now usually seen blowing bright blue smoke out of their exhausts being driven by a somalian with a hat to the side playing 10 year old DMX music.

but - there ARE gems out there. what you're craving would be fixed by a VVT soarer (so i beleive)

first of all, read this paragraph:

The high-performance turbocharged version uses a 2.5 litre straight six (coded 1JZ-GTE). Early models are fitted with parallel twin turbochargers which give 206kW at 6200 rpm and 363Nm at 4800 rpm. Unfortunately, the TT engine is quite doughy at the bottom end of the rev range - the transmission’s torque converter needs to flare to get the engine revving (a trait that becomes tiresome, especially when a loud aftermarket exhaust is fitted). A 5-speed manual gearbox was fitted to a small number of examples.

that was penned by autospeed about 5 years ago.. then: read this article

http://autospeed.com/cms/title_The-Highest...57/article.html

to summarize - after mid 1996 the soarer went to a single turbo VVTi motor, torque was doubled.. and found at 2400RPM instead of 5000RPM

power was increased. fuel consumption was pretty much halved.

to summarize, the VVTi 1JZ has a HUGE difference.. the VVTi 2JZ not so much..

in addition to this the whole range got a facelift and certain "quivles" were fixed and revised.

priced for these vary like mental. i don't want to even tell you difference between the soarer i just bought my parents vs the soarer i just bought me.. but put it bluntly.. both my soarers were imported WELL under your budget.

and to summarize..

soarer - you get pretty much every luxury feature imaginable

here's what is sitting in my driveway now..

I think if 'coq' factor is a problem for you most imports aren't so great... I could live with a Soarer if it were great to drive. Still gonna aim for a Supra but if I can't muster any more funds soon it sounds like a good alternative.

Has anyone here driven a twin turbo Mitsubishi GTO? Might just be thinking out loud but I've seen late 90s models around the $15k mark before. I'd imagine they'd use a ton of fuel though being so heavy. And so complicated they might be hard to keep going.

Edit:

Not planning on modifying too heavily. It'll be a daily so will do a better but not too loud exhaust and maybe some minor stuff around the engine but not huge. I'd like to do some Tein EDFC in the future when finances permit.

Edited by Nissinja

Just want to add left field choice...

Mitsubishi GTO, Mates got one and it very decently equipped and goes well.

because your limited budget the mitsu might be worth it, but you can get 1997 - 1998 Mitsubishi GTO "updated headlights version" for around 18K in Australia. Also there are shops that will do work on them for reasonable dosh...

on another matter, you Got to be very patient when importing. my car is getting landed in Australia on the 19th Nov, then its waiting still for complance, though this is my second import, so i will

get used to the waiting by now ..oh... how wrong i was

^^^samesies.

i rage quitted after i joined their "cruise" and had a go at them all for dropping skids in front of kids on bikes. and one dipshit in a Z20 decided to try drift around a roundabout n ran into a gutter.

i said to them be careful on cruises last thing we need is attention from police.

that was like throwing a rock at a beehive.

soarer drivers are knuckle dragging mouth breathers. just sayin.

Aside from the atypical owner, Soarers are very good value for what you get. Very capable all rounders (performance-luxury-looks-reliability-cost) and one of the few Jap cars where you won't be cursing the Japanese tradition of designing a car's backseat for kids that never grow up.

^^^ +1

but the conclusion that i've come to notice is - there is a massive soarer revival trend occuring.. but it's quiet and small..

even my broker said yesterday on the phone that when he had the car in his shop, people's jaws would drop and they couldn't beleive that it was a soarer of all things

infact yesterday i was out front and this guy in a van stopped outside my house with his family and started telling me how much he absolutely LOVES our soarers and how he's always been into imports ever since we've had "the orange" 180 parked outside ten years ago..

he said he just bought an aristo a few months back from Jspec but said that if he had've known soarers could be like that then he would've got one - true story.

but anyway.. conclusion i've come to is - if people like soarers, great.. if they think they are boats and dirty old ho-hum imports then that's their opinion.. i'll just wind up my electric seats tilt my electric sunroof and drive away smiling while they sit there and curse their broken silvia :D

only a late model V8. :D

actually there's this one for sale - UZZ32 active with 106xxx genuine km.. only mods are - brand new headlights and tail lights from toyota... and a 97 body conversion

for those of you unfamiliar with soarers, the UZZ32 is the rarest of the build codes, only a run of about 700 odd i beleive. toyota were losing money on each one sold apparently.. active suspesnion, 4 wheel steering, reverse cameras.. these guys had it all!!!

IMGP3191.JPG

IMGP3197.JPG

IMGP3199.JPG

IMGP3205.JPG

IMGP3211.JPG

Edited by Mr Eps

few moar pix in case you don't beleive it's condition:

IMGP3226.JPG

IMGP3227.JPG

IMGP3228.JPG

IMGP3232.JPG

IMGP3235.JPG

IMGP3237.JPG

sorry to go off topic from supras - i'm just mkaing the point that soarer are definitely the underdog - not all soarers are driven by some 17 year old somalian kid wearing RuffRyder clothing.

^I prefer a LS400/Celsior over a soarer. More usability.

BTW V8 as a daily isn't as stupid as you think... Get a LS400 - built like tanks, srsly. Dad had someone rear end him between 80-100kmh and he was stationary, and he didnt even get whiplash... (206 GTI hit him)=, they wrote it off from a financial point of view cause the car is worth so little and the panels were pushed a few mm at each back door)

So impressed, bought another one. Last tank, did 11.2L/100km around town. <Paid $7800 for a 1998 LS400 from the UK (minimal rust, mostly on exhaust mufflers) - 131k miles, engine is so quiet, just the other day at the fuel station, he turned it on, put seatbelt on, then tried to turn it on again....

Edited by Ten Four
lol let me guess. dark green 1992 V8 that's got three oem wheels and one wheel that has an inexplicable hubcap?

lol nah, its a silver V8 uzz30 with EMV and speedy mesh wheels lol 91 or 92 model.

does look nice i'll admit but typical soarer owner lol.

There are plenty of those around Canberra though, Dark green or dark blue UZZ30s with bald tyres, broken exhaust hangers cracked front bars.

Oh PS how much for that UZZ32?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • And finally, the front lower mount. It was doubly weird. Firstly, the lower mount is held in with a bracket that has 3 bolts (it also acts as the steering lock stop), and then a nut on the shock lower mount itself. So, remove the 3x 14mm head bolts , then the 17mm nut that holds the shock in. From there, you can't actually remove the shock from the lower mount bolt (took me a while to work that out....) Sadly I don't have a pic of the other side, but the swaybar mounts to the same bolt that holds the shock in. You need to push that swaybar mount/bolt back so the shock can be pulled out past the lower control arm.  In this pic you can see the bolt partly pushed back, but it had to go further than that to release the shock. Once the shock is out, putting the new one in is "reverse of disassembly". Put the top of the shock through at least one hole and put a nut on loosely to hold it in place. Put the lower end in place and push the swaybar mount / shock bolt back in place, then loosely attach the other 2 top nuts. Bolt the bracket back in place with the 14mm head bolts and finally put the nut onto the lower bolt. Done....you have new suspension on your v37!
    • And now to the front.  No pics of the 3 nuts holding the front struts on, they are easy to spot. Undo 2 and leave the closest one on loosely. Underneath we have to deal with the wiring again, but this time its worse because the plug is behind the guard liner. You'll have to decide how much of the guard liner to remove, I undid the lower liner's top, inside and lower clips, but didn't pull it full off the guard. Same issue undoing the plug as at the rear, you need to firmly push the release clip from below while equally firmly gripping the plug body and pulling it out of  the socket. I used my fancy electrical disconnect pliers to get in there There is also one clip for the wiring, unlike at the rear I could not get behind it so just had to lever it up and out.....not in great condition to re-use in future.
    • Onto the rear lower shock mount. It's worth starting with a decent degrease to remove 10+ years of road grime, and perhaps also spray a penetrating oil on the shock lower nut. Don't forget to include the shock wiring and plug in the clean.... Deal with the wiring first; you need to release 2 clips where the wiring goes into the bracket (use long nose pliers behind the bracket to compress the clip so you can reuse it), and the rubber mount slides out, then release the plug.  I found it very hard to unplug, from underneath you can compress the tab with a screwdriver or similar, and gently but firmly pull the plug out of the socket (regular pliers may help but don't put too much pressure on the plastic. The lower mount is straightforward, 17mm nut and you can pull the shock out. As I wasn't putting a standard shock back in, I gave the car side wiring socket a generous gob of dialectric grease to keep crap out in the future. Putting the new shock in is straightforward, feed it into at least 1 of the bolt holes at the top and reach around to put a nut on it to hold it up. Then put on the other 2 top nuts loosely and put the shock onto the lower mounting bolt (you may need to lift the hub a little if the new shock is shorter). Tighten the lower nut and 3 upper nuts and you are done. In my case the BC Racing shocks came assembled for the fronts, but the rears needed to re-use the factory strut tops. For that you need spring compressors to take the pressure off the top nut (they are compressed enough when the spring can move between the top and bottom spring seats. Then a 17mm ring spanner to undo the nut while using an 8mm open spanner to stop the shaft turning (or, if you are really lucky you might get it off with a rattle gun).
    • You will now be able to lift the parcel shelf trim enough to get to the shock cover bolts; if you need to full remove the parcel shelf trim for some reason you also remove the escutcheons around the rear seat release and you will have to unplug the high stop light wiring from the boot. Next up is removal of the bracket; 6 nuts and a bolt Good news, you've finally got to the strut top! Remove the dust cover and the 3 shock mount nuts (perhaps leave 1 on lightly for now....) Same on the other side, but easier now you've done it all before
    • OK, so a bunch of trim needs to come off to get to the rear shock top mounts. Once the seat is out of the way, the plastic trim needs to come off. Remove 2 clips at the top then slide the trim towards the centre of the car to clear the lower clip Next you need to be able to lift the parcel shelf, which means you need to remove the mid dark trim around the door, and then the upper light trim above the parcel shelf. The mid trim has a clip in the middle to remove first, then lift the lowest trim off the top of the mid trim (unclips). At the top there is a hidden clip on the inner side to release first by pulling inwards, then the main clip releases by pulling the top towards the front of the car. The door seal comes off with the trim, just put them aside. The the lighter upper trim, this is easy to break to top clips so take it carefully. There is a hidden clip towards the bottom and another in the middle to release first by pulling inwards. Once they are out, there are 3 clips along the rear windscreen side of the panel that are hard to get under. This is what the rear of the panel looks like to assist:
×
×
  • Create New...