Jump to content
SAU Community

Recommended Posts

I bought some ramps yesterday to do my gearbox oil, then discovered I couldn't drive up them with my front bar, so had to do some dodgy manouvering so that they were on a downslope before I could drive up them....when the car was up on the ramps, the base of one ramp was like only half on the ground due to the dodgy incline......safety first:rofl:

* extremely slow clap*

  • Replies 62.7k
  • Created
  • Last Reply

Top Posters In This Topic

  • chaos

    7164

  • Ska

    5791

  • BelGarion

    3645

  • Nexus9

    3590

Top Posters In This Topic

james.. ya noe you will be the first one i called if we are going down....  

but yeah... who you going with, Warwick?

thought I might go there with the missus on the way back from the airport....you wanna come?...prolly around the 8.30 mark

*remembers Glenn eats at midnight*

thought I might go there with the missus on the way back from the airport....you wanna come?...prolly around the 8.30 mark

*remembers Glenn eats at midnight*

ok.... if you go @ 8.30. There's gonna be plenty of cars and ppl cos its friday nite. I reckon its best you parked @ the multistorey carpark.

you still got the address of the place? i will give you a call if i can make it down.

you sure its your wife and not some hot 18yr chick? :)

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...