Jump to content
SAU Community

Recommended Posts

words.gif

imagezjf.gif

Proudly Presents:

Import Monster SAU-Vic DECA Motorkhana ROUND 2 of 4 of the 2011 DECA CHAMPIONSHIP

When : Saturday 4th June 2011

Where : DECA - Shepparton, 145 Wanganui Road, Shepparton, VIC 3630

Cost : $85

Max Entries : 50 + Reserves

-= PLEASE NOTE =-

The insurer of the event (AASA) has issued supplimentary regulations that require all entrants to wear helmets during all competition. This includes the skidpan and all battles.

This also impacts passengers, as they must also now wear a helmet prior to entering a competition vehicle.

A fire extinguisher is required by all entrants. This is for your own safety.

Please re-read the supplimentary regulations before entering the event.

Entry Form & Supp. Regs. : HERE

FILL OUT FORMS COMPLETELY. INCOMPLETE FORMS WILL NOT GO ONTO ENTRY LIST.

***Also, if you are emailing you entry, please name the attached file after your full name and what page it is. eg. 'Ryan Bell Disclaimer'.

Event Schedule: Event Schedule

Results: Not yet available

All withdrawles will be refunded after the event. Refunds will not be given after 5pm Monday 30th May.

Anyone paying by cheque MUST make the cheque out to Skylines Australia Victoria. Cheques made out to anything else WILL BE REJECTED.

Please support our sponsors : Import Monster Pty. Ltd. Factory 3, 6 Wigan Road Bayswater VIC 3153 (03) 9008 0031

--------------------------------------------------------------------------------

  • Replies 221
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

ENTRY LIST:

1 IMPORT MONSTER Aaron Klaver

2 IMPORT MONSTER Ash Cosgriff R33 GTR

3 Leon Stapley 180sx

4 Ryan Bell Sileighty

5 Jimmy Wong Liberty

6 Martin Sullivan 200sx

7 David Hurst R32 GTS4

8 Winston Ho Toyota Chaser

9 Ashneel Prasad Toyota Chaser

10 Glynn Matthews WRX

11 Luke Schulze R33 GTST

12 Dinusha Herath

13 Stan Lubinkov Forester

14 Terence Ho R33 GTST

15 Reade Clouston Ford XR4

16 Simon Wilcox Toyota Chaser

17 Jake (Mike) Lowry S14

18 Phil Mak S13

19 Charlie Cheng Mark II

20 Jett Benson Fairmont

21 Mark Homer 944

22 Russell Cunningham R32 GTST

23 Brendan Pryor R33 GTST

24 Joesph Pezzimenti 180SX

25 Kieran Robinson Supra

26 Nghia Nguyen Liberty

27 Harsh Gupta R33 GTR

28 Roman Plotnikov 180SX

29 Joshua Robins Clubman MS8

30 Gerald Tan Supra

31 Bart Kohler R32 GTR

32 John To Mark II

33 Akshay Rajan 911

34 Mario West Evo 8

35 Brent Germain R33 GTST

36 Sanjay Subramanian R33 GTST

37 Jeremy Taylor 200SX

38 Dean Taylor 200SX

39 Byron Scott S13

40 Rhys Solomons R33 GTST

41 John Packham S14

42 Ashley Stacey R33 GTR

43 Sean Power S14

44 Justine Schuller S14

45 Shane Janssen

46 Campbell Shobbrook 180sx

47 Chirs Stacey E30

48 Marcus Stacey E30

49 Chris Taylor

50 James Newton R34 GTT

Reserves:

1

2

3

4

5

6

7

8

9

10

Just first reminder for those entering..(first of prob many)

Competitors must wear non-flammable clothing extended from ankles to neck to wrists. Nylon clothing is not

permitted. Shoes must be closed toe.

this will be strictly enforced. and we will be checking during scrutinizing.

Driver and passenger have to wear long sleeves and pants and be non flammable..turn up in shorts and tshirt and you will be on a mission to kmart prior to racing!!!

Guest
This topic is now closed to further replies.



  • Latest Posts

    • @666DAN sorry to bring you and old thread.     I've got my de+t done and it's all running great other than 1 small issue.    Car has remained auto with the na auto and tcm, I've used a stagea ecu with. NIstune board and everything is great other than my gear selection on the dash. It illuminates park, reverse, neutral, 3rd and 2nd when selected . But nothing when in  drive or what gear your in when you pop it into tiptronic. I'm sure there is maybe 1 wire in the ecu plug I need to move to rectify this. Do ya have any ideas?     Cheers man
    • Well I recently changed my rear axles and was thinking if I bumped anything, I have been driving the car for a while now though... But it has been raining today so everything is wet under the wheel arches. Brakes feel fine and can't hear any of the metal screamers, I had a squeak coming from one of the handbrake drums but that seems to have gone away a while ago. I was going down a hill when it lit up and I did feel the abs bite for a second and question why it did it?
    • Correct. Um. I dunno. I haven't cared enough about the way that the NA cars work to know for sure. But..... The 33/34 turbo manual cars have an electronic speed sensor in the gearbox that outputs a +/- (ie, sawtooth AC) voltage signal. That is connected to the speedo. The speedo then outputs a 0-5v square wave (ie, PWM) signal that the ECU (and any other CU on the bus) sees. The speed sensor is NOT directly connected to the ECU. So here's the problem. Your new ECU expects to see the PWM signal, but must somehow be getting a direct signal from the diff speed sensor. Which would suggest that the wiring of the NA car is not the same as the turbo cars. I think you will need to spend some time with (hopefully the wiring diagram for the car) and a multimeter to see what is connected to what. Then, presuming I am correct**, you would then want to separate the ECU speed signal input from the rest of the car's wiring, and probably either buy a speed signal converter, or build one using an arduino (or similar). That would take in the speed sensor signal and output a scaled (and suitably rearranged) signal for the ECU. ** We shouldn't presume that I am correct here, because there might be something else crazy going on. I don't think you could convert the speedo to be fed from the gearbox sensor, because the pulse rate from that sensor is probably different to the diff sensor and then the speedo would read wrongly. And this also wouldn't fix the ECU's problem either, because the ECU doesn't want to see the gearbox signal direct either (assuming that they are all on the same wiring, for some odd NA related reason, see above caveat!) Does this help? Probably not. Can you make it work? Almost certainly. With the above work. You should buy a handheld oscilloscope from Aliexpress so that you can view these signals directly. Connect up the probes and drive the car. Show photos of the screen when drving at known speeds and connected to different places, and we'll see what we can learn about it.
    • Assuming your brake pads are not worn right down, I'd add a little brake fluid. Is there any sign of a brake fluid leak?
    • Hello all,  I need of some help. On my drive home my handbrake light lit up and started flashing. When I got home I checked my handbrake sensor under the centre console and nothing seemed out of the ordinary. I have scanned my car via the consult port, no codes shown. Checked my brake fluid as well which is half full. Tried unplugging the brake master but it didn't change anything. Thoughts on what it could be? The master float doesn't seem to be stuck. My car is an 1998 ER34 sedan GT. No hicas but has ABS Photos below 👇🏾 
×
×
  • Create New...