Jump to content
SAU Community

Recommended Posts

honestly do a search....this has come up several times.

brent is online here as nengun anyways. i have only heard good things about nengun...and the last time i bought a ttimer+harness...when the harness was sourced it arived roughly 2-3 days later via ems or something like that. i find his service to be professional and from that i wouldnt have second thoughts buyin from them again. well thats my review anyways.

honestly do a search....this has come up several times.

brent is online here as nengun anyways.  i have only heard good things about nengun...and the last time i bought a ttimer+harness...when the harness was sourced it arived roughly 2-3 days later via ems or something like that.  i find his service to be professional and from that i wouldnt have second thoughts buyin from them again. well thats my review anyways.

i did a searchand found at least a lot of people have orderd but couldn't find any info on larger orders, or problems which i suppose is a good thing,

so ordering turbos for 3500 shouldn't be risky then?

cheers feelas

Hi tribex, I have bought a few things from Nengun, never had a problem. Small items come in no Import Duty or GST but larger items sometimes get caught. So budget for 10% Duty and then 10% GST on top of that. If you don't have to pay it, you're lucky.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...