R32 Clutch fork pivot and thrust bearing assy sizes

[ScarifieR]

hey

as the topic says

i got a gearbox conversion and the first box had problems

so they put another in

now since then the clutch doesnt grip as good as it used to

ive changed all the hydralics and the only reasons ican put it down to is the pivot or thrust assy because we didnt use the stuff out of the old box

the fork sits right near edge of the bellhousing and the slave is forced hard up against the fork , that bad its on a angle

All my mates R32's have atleast 2mm clearance from the fork and the fork has a clearance of 10-15mm from the bellhousing

i been told by about 3 mechanics now its the thrust assy and pivot

so whats the sizes of these and where could i get 1 from?

also if anyone had a dead rb20 box it would be great if i could have yours

thanks