Jump to content
SAU Community

Recommended Posts

hey guys

here we have my r34 GTT wide body for sale it is a write off and can not be re regersted in qld as it was still regod there at time of crash.

was a nice car to drive. there is no damage top engine or drive line can here running

spec

HDS coilovers in GC $600

rb25det neo 135,000kms runs like a dream $1500 complete

5 speed gear box EC $1400 or can make u a kit to make u auto a manual for $$

hks turbo timer $60

front strut brace x2 $70 ea

rear strut brace $70

FMIC trust i think in GC $ 300

Turbo sx BOV $50

Spit fire coil packs 10,000 km old $350

17' mags front tyres like new $500

full 3' straight throw exhaust system sounds nice with a bolt on muffler at rear if to loud $350

hicas lock out bar $50

wide front grauds $100 rhs cracked

rear grauds $300 bear rear cut

Alloy radiator $250

full set of brakes $500

rear cradle with diff centre $300

steering wheel in gc $250

cluster with 135000 on it $150

anything else u can like of let me no what u want and what ur offering

ALL PRICES A NEG AS NEED IT ALL GONE ASAP

ANYWAY WANTS WHOLE CAR BEFORE I CUT IT URS GFOR $3800 FIRM

bendigo vic call sms 0424897340 or pm

Attached thumbnail(s)

i wanted the left tail light.. damn

shoty if it falls through

my offer is $130 including postage?

Edited by Blue R34 GT
  • 4 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...