Garrett Gtx3071R

[Mick_o]

Close up of my fabricated bend welded up ">

[Mick_o]

Heres what the inside looks like of stainless when its all purged up">

[Mick_o]

Heres the line that runs to the throttle body all welded up with the BOV flange and other branch for the other line that came off original factory line">

[Mick_o]

The complete lines all welded up ">

[Mick_o]

I hadnt actually put any beads of weld on the ends of the pipe there but i did do that cos im planning to run good boost and dont wanna be blowing hoses

[Mick_o]

The 2 lines are my new setup on the left and the 3 pipes on the right side are your standard kinda kits i suppose my work is actually just over 400mm shorter than the old set up just on 1 side alone!">

[Mick_o]

Another close up of a few of my welds ">

[Mick_o]

">another angle of the flange for the bov all welded up with a bead of weld on the end of the pipe

[Mick_o]

2 lines all cleaned and polished up">

[Mick_o]

BOV line all cleaned up nicely">

[Mick_o]

another close up of my welds after they were pickled and hit with some scotch brite">

[Mick_o]

Heres the bov basically in the factory position so it still plumbs back ">

[Mick_o]

The end result all sitting in place ">

[Mick_o]

Ive got 1 more hole and a weld for the boost control line to go in before its completely finished yet but once ive done that im going to make some caps to block off either end of the system and pump it up to 35psi and check for leaks to make sure its right for next week hopefully when it hits the dyno again

[wolverine]

Nice work Mick.

(can you hang on to your old cross over pipe I might need one in a week or so)

[Mick_o]

Thanks Andy all thats missing is a plazmaman sticker now lol

Nice work Mick.

(can you hang on to your old cross over pipe I might need one in a week or so)

[Mick_o]

No probs mate

Nice work Mick.

(can you hang on to your old cross over pipe I might need one in a week or so)

[GTScotT]

Micks, too sexy for his shirt, too sexy for his shirt... Oh sorry I meant the pipes

[Mick_o]

Lol thanks Jase its so sexy it hurts

Micks, too sexy for his shirt, too sexy for his shirt... Oh sorry I meant the pipes

[Dale FZ1]

Looks like you're pretty handy in the fabrication stakes there Mick. Well done, now get into running this thing up with some boost into it.