Jump to content
SAU Community

Recommended Posts

@MrStabby: Can you define 'Rough running' for me?

Missfire/hesitation. You'll notice it when vacuum hits zero (unless you're just at 0. Since one turbo is not turning, it becomes a hole to atmosphere so the gauge wont go past zero). The car should run normally if you have some vacuum (that is, at low throttle - you're boost gauge also shows vacuum). Normal when your turbo is gone will top out at ~90kw...

Okay, so $250 and a day later... I have found out the following:

Rear Turbo blew out a bearing... I have the remnants in a plastic ziplock bag ;)

Fuel injectors are leaking

And there's an oil leak into the rear turbo...

When it rains, it pours :(

Tell me about it... Worst part is... I got quoted about $6,500 all up to fix it.

$4K+ for the injectors & Oil leak, $2200 to rebuild both turbo's with steel ball bearings. ($2800 to go hi-flow)

Seems a little expensive to me, even if it is an import car... Any suggestions would be greatly appreciated!

New -7s should be $2200 for the pair, so $2800 for high flows is pointless. Leaking is common with GTR injectors, as is rear turbo failure...

Fatz - is $40 to stop the leaking through the body of the injector? (that is not dribbling into the cylinder). Who does that sort of repair?

Yeah, basically... They quoted $2200 to rebuild the Turbo's as Steel Ball Bearing Turbo's using the original housing. $2800 to do the same as Hi-Flow.

I'm not looking to spend heaps and heaps on the engine, it's why I'd go for the $2200 Turbo's. It's the Injector rebuild I'm not looking forward to, but it will need to be done, it's causing issues with my fuel consumption... Getting about 350km a tank from moderate driving

Also, I think that $40 is just for a new injector head.

Edited by Methor

Welcome to gtr ownership. From here on your wallet does all the talking

^HAHA! Yeah isn't that the truth lol.

DO NOT spend $2200 on rebuilt steel wheel standard turbos.

Get some Garrett -7's or -9's for that price and reap the benefits instead of burning money on turbos that are barely even suited to the RB26.

And where did 4k! come from for fixing some injectors and an oil leak?! Unless it was a new piston job or something deep. You should be able to find some aftermarket, second hand, bigger injectors for about $500 in decent condition or simply get a used set of std injectors - always available, and cheap as chips. Oil leak into rear turbo?, doesn't the factory rocker breather plumb into the rear turbo inlet? my rear turbo was oily beacuse of this too - didn't mean it was a leak though. Who did the diagnosis on the engine faults?

Depending on tunes, 350km out of a tank isn't all that bad. Dont get me wrong, its not great by any means, but I was running close to that (380-400) with std turbos on a "super duper" safe tune by Croydon! Then changed tuners to JEM and am getting closer to 420/430 with more power. Food for thought.

those prices you got quoted are crazy high !!

pick up a good set of 2860-7 turbos for about $1500 (theres afew for sale at the moment)

+ labour to remove and install turbos

then fix leaking injectors for cheap

Thanks everybody for confirming that the place was ripping me off... Or just doing a shitload of work to the injectors that I didn't fully understand, which if I could explain properly you'd probably go "Ohhh... Maybe..."

All I have to do now is find a place that isn't going to rip me off that's somewhat close to me. (Vic, S.E Burbs)

If its just the injector seals leaking then check out the DIY in my sig and do it yourself. However, its common for old GTR injectors to leak through the body, which you'll see as wetness on the injector body. I had 3 doing this, so I got a set of new 550 seimens for ~600 (ebay, from US), but of course you need to have an aftermarket ECU to run different injectors. If you're strapped for cash, just do the turbos and live with the leaky injectors a bit longer (keep an eye on them tho).

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Shouldn't need a "base map" for anything other than guidance to ignition tuning. You just need the engine capacity right, the injector size right, and something, almost anything, for a VE map. On an NA engine, fuelling is almost completely a function of load signal & rpm. It should run and drive with a completely flat fuel map. It will be too lean under load, but that's easily fixed. We used to tune all ECUs without any base map. There were no such things (until someone had tuned a near stock engine on one, and then they had a "base map".
    • What did you actually buy/how much did it cost? When I got mine in like.. 2017...? 2019? the aim was to run Torque for gauges via ODB2 and things like Track Addict/Laptimers/Dashcam/Reversecam/Spotify etc. Mine never broke, but I wonder if you've got the same needs (it sounds like it). Cause I liked the idea of being able to do anything with it. That said, yours also cost 3x the cost of what I spent so... food for thought.  
    • For me there is a massive difference in manufacturer or big brand crippled android (Sony, Kenwood etc) vs the sort of thing I've installed here, which is basically just a tablet in DIN form factor with open Android, and the other model of course is mirroring - Android Auto/Carplay. I hate the locked down manufacturer and AA options where they decide what apps I'm allowed to install, including the Launcher but also importantly things like Ecutek (for this car) or Real Dash (Stagea) are not supported. Plus those crippled versions tend to be slower due to both overheads and lower spec hardware. On the other hand, when this breaks I'll likely be in trouble for support....but how is that different to owning an Infiniti anyway
    • Yeah, Duncan is helping sell me back to Android devices. I've hated the whole Android head units due to their speed issues. Even in my old Hyundai Kona (2022 model), it behind the scenes was Android, and slow and shitty to start up. Once running wasn't bad, but still a good 15 to 30 seconds.
    • My roof rails are off atm on the E39 until the rust is fixed. I did find another little bit of surface rust under the rails when I took them off. As @soviet_merlin said I'd just leave them alone unless you're planning on ensuring they're properly sealed. I was on the fence about leaving them off as the delete is still a thing in BMW E39's but I feel like the car is missing something (er, it is, der) with them off and I'm looking forward to putting them back on.
×
×
  • Create New...