Jump to content
SAU Community

Recommended Posts

  • Replies 203
  • Created
  • Last Reply

Top Posters In This Topic

what about just tacking it together and getting someone else to weld it up? worst case they can grind off your tacks after retacking it themselves - doesnt help the DIY aspect but it will be nicer finished product from your last pic :P

wait, doesn't the soarer share parts with the supra? shurley you can get the pedals from a supra and put it in your soarer.

btw this is a reply conversation in the wasteland.

edit found this clicky

Edited by tweety bird

It does, so most of the Supra stuff fits or goes close.

The main issue is the JZA80 never had the R154 5 speed, only the X chassis and 70 series Supras had the 154, which are slightly different to the the Soarer spec box (Soarers have a remote shifter)

But yeah, the pedals are a 99% bolt in

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • R34DE as in R34 with an RB25DE? So did you get this? Or you planning to?  I'm not really sure what you're saying. 
    • Possibly avoid using a Cometic one unless the deck/head surface are perfectly flat. I did have a look just then and forgiving gaskets such as Tomei or Nitto don't exist for the FJ20, however the Bar-Tek or Kameari ones look good and might do the trick.
    • Because pipe threads for pipe things. M threads for bolt things. Throw some teflon sealant onto it and dust your hands off knowing you did the right thing, instead of going twice around the block to achieve a result using the wrong things. Of course, all of these solutions are ignoring the fact that the minimum thread pitch we're talking about here is 1.25mm, with the 1/4" in NPT or BPS being out around 1.4mm. You will need to know that the boss you're tapping has enough thickness for at least a few threads. That's one of the reasons that 1/8" is commonly used - because the pitch is <1mm. And why would you look to use 1/4" NPT in a BSP country anyway? Ugh.
    • Just throwing around ideas, does it need to be in the compressor cover? Why not the hot side piping?
    • 1/8NPT drill size = 8.7mm. Since the hole got messed up by me, it’s probably around 9mm.    So 1/4” NPT would be next step. A drill size of around 11mm would be preferred there which is not way of my M12 (drill 10.5mm and tap M12 threads) 
×
×
  • Create New...