Jump to content
SAU Community

Recommended Posts

Hey guys.

So im ditching my Nistune in favour of the Haltech mainly for logging/features and so forth. oh and losing the AFM is a bonus.

Several questions.. i got a Platinum Sport 1000 and a Rackpak IQ3 dash on order. so now for the questions.

- I want to be able to have fuel and oil pressure switches in line. Haltech sell them for 250 bucks EACH.. pretty pricy and from what my understanding is they are only a common 0-5 volt switch. So can any sender be used and then calibrated to perform this?

- With the oil and fuel pressure imputs... can i set the haltech to take action on low readings? and will they be displayed on the dash?

- whats involved in setting the anti lag up?

think thats it for now haha

Link to comment
https://www.sau.com.au/forums/topic/383636-haltech-platium-sport-questions/
Share on other sites

We thought the same thing when we were trying to set up fuel and oil pressure feedback to the ECU/Dash and to be honest we spent quite a lot of time trying to find a cheaper fuel pressure sender. The sender in question is made by honeywell. You could try searching overseas (America) for this but I think you'll come to the same conclusion we did and that it's better to just buy the sender they provide.

There may be another sender available somewhere but we couldn't find it. Someone on here might know though

aem do a cheaper 0-5 volt pressure sender. like 60 bucks on ebay. its just not as compact as the other style sensors. same plug etc etc. 24mm hex.

being a linnear sensor it will be in the haltech sensor archive.

aem 10 bar

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Put a fuel pressure gauge on it. Replace the turbos. Probably completely separate issues.
    • What copper washer do you guys use on the bleeder bolts? The existing one I have I had no idea where to find it in a local store, I did buy some online but that are only 1mm thick whereas my old one is 2mm+ thick and when I put the new washer out and squeeze the top radiator hose I can hear a bit of air but not with the old one. Does this matter? The new one doesn't leak, but the inner diameter is a bit loose whereas the old one threads on the bolt.
    • Howdy all, after being out a few weeks ago on a spirited drive in my GTR I have 2 issues that oddly have appeared at the same time. Whilst accelerating quickly through the gears all of a sudden i’ve lost power at the top of third gear (below redline around 6000rpm) for no obvious reason.    From that point onwards the car has been running rich on idle, won’t really rev under load without a ton of black smoke and the odd backfire, and dying as a pull up to a set of lights unless I keep the revs up around 1500rpm. In addition when shutting down the car that same night (I was 10 minutes from home) I noticed one of the turbos was significantly noisy on wind down when shutting off the engine. After letting the car cool down overnight it starts up fine, although once it gets to temp the revs start to creep up and down, the exhaust is darker than it should be and it also sounds like it’s running rich (fat note) I’ve put a new set of plugs in it - no change, the old plugs all seemed OK with two of them being somewhat richer/fueled up than the other 3 with 1 being borderline. I’ve smoked tested the intake system via the front of the Turbos, found a split vacuum hose going to the factory boost gauge sender, which I have since replaced.  Also found another leak on the gasket coming off the rear turbo outlet, have also replaced this. After fixing both of these leaks - still have the running rich issue. I’ve also tried another pair of AFM’s - no change here After pulling off the front turbo intake pipes, there is obvious shaft play in the front turbo, which now hisses loudly on light revvs although I can’t see why this would make the car run funny even under idle. I’m curious to know why it’s running rich before I potentially replace/rebuild turbos. The car is completely stock <50,000kms  other than an exhaust. Oil and coolant are all clear. I haven’t bothered with coil packs as it looks like they won’t be the issue due to condition of the plugs. Any help appreciated as I cry myself to sleep!
    • No probs at all. I used to love trying to dig up obscure info for those in need where possible going back 20+ years on SAU.  I did have another look and couldn't come up with any closer match. I'm leaning towards those skirts in your first pic are custom fitments, cut down/extended or from another car entirely and modded to fit an R34 sedan. I would've thought someone in Japan had them and taken a photo at some stage over the last 2 decades but there's nothing. Someone out there must know surely.
×
×
  • Create New...