Jump to content
SAU Community

Recommended Posts

Yo GOT BOOST, :headspin:

Watched your runs and they were mad. It looked like you were going great after the first 11.7 run. Gald we left when we did as the track got even more slippery as it started to rain. That last run of 11.5 was outstanding well done.

As you could see from my times the NEW ECU is on song and now for some dyno time and Nitto's then back to the track for some PB times.

I did a 13.4 untuned ECU (thanks Fane for the yahoo's), but what was important was the terminal speed of 108mph/175kph that has me the most excited. So back to the track. hope everyone gets down and has a run.

Paully are you going to have a run next week????

GTRRRR, great run dude nice 12.5 , shame you are selling the car and the drift damage sux.

FANE, thanks for the support, get your car there next week. :)

Link to comment
https://www.sau.com.au/forums/topic/38585-slicks/#findComment-783826
Share on other sites

sean,

I don't know if you already do this but, if you wait till the last couple of orange lights with the clutch pushed in , when in gear, and mash the go pedal in one hit and as the revs jump to 7000 sidestep the clutch. This works a little better than holding the rev limiter because you get a smallish amount of boost built as the engine experiences light load from accellerating itself. Next step antilag ? :)

Link to comment
https://www.sau.com.au/forums/topic/38585-slicks/#findComment-785765
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Ok thanks..that was my second question if i can somehow bypass this even with Nistune(that is all i have right now...aparat from stock ECU. So with some aftemarket it can by "bypassed" or make it work?  I know there is Link or Haltech (mainly used). We have ECUmaster here so i will gather some info about it.
    • Yes. You will need to get the original boost sensor and wire it in. That is.... if you plan to use a stock ECU - even a Nistuned ECU. The Nissan ECU will not operate correctly without it connected. And yes, it will do annoying stuff like you are experiencing. You will almost certainly be better off with some aftermarket ECU, than trying to hunt down rare sensors.
    • Ok so ABS/TCS is "not" the problem. Yeah i know now about the ABS with Nistune(i told that to the Nistune guy) but iam not 100% why or why i dont have ABS. ABS cube is in the engine (always has been) but i had braked couple of times rly hard and brakes just locked and scream. Does all Skylines have ABS cube? That boost sensor https://www.sau.com.au/forums/topic/367633-wtb-r34-gtt-turbo-pressure-sensor-pics-inside/ Is this it? I need to ask but i have a picture of engine bay and i do not see that (100% is not in that place) If i do not have this the car can do what mine is?(cutting around 4000 rpm) Here is the pic of my engine bay(only one i have) BUT i think i dont have that cuz loom was used from my RB20DE NEO and i know (obviously) that it does not have boost control or any wire to that...) so maybe that is the problem? (i dont know for 100% if that car where the engine is from had that)...but i dont have the loom from that
×
×
  • Create New...