Jump to content
SAU Community

Recommended Posts

Righto, I'd like to clear out all the shit in my current shed before I knock it down to build a new big arsed man hole....

I'll keep updating what's sold /what's left at the last page of the thread so check there if you want something rather than trying to read through all the pages.

Pick up Valley Heights Sydney or can ship most parts at your cost.

Generic stuff:

-SAAS Steering wheel (no boss kit) $80

-Quick release boss kit $40

-SAAS gear knob $40 (as new condition)

-Nismo metal gearknob $20 (couple of scratches)

-Wilwood 4 piston Superlight front brakes with Brembo 324mm drilled discs $1,100

Includes three brand new sets of spare pads, bracket adapter kit and braided lines

-Sony Xplod Stereo $40-Comes with remote control and manual

-M's turbo timer $40

-Apexi 2” Power Meter gauge $60

-Speco Meter 2.5" tacho $50

-Pivot 80 mm boost gauge $40

-Racetech oil pressure gauge $50

-Jetspeed EGT sensor/gauge brand new in box $50

-5Zigen tip $20 (pick up only, muffler is damaged but tip could be reused)

-Cat to muffler 3” exhaust pipe $40 pick up only

-Raizin Volt Stabiliser $20

-Genuine Defi Link gauge set $1000 posted with insurance:

No I won't separate and yes this is the lowest I'll go on price. These are genuine Defi items, not bok choy China shit. Oil temp and pressure come with mount so you can just bolt on (fits Gtr and Rb30). Water temp comes with a mount to plug straight into Gtr. All sensors and an extra 2m link wire included as well.

Condition is excellent, used items have only been in the vehicle for approx 400km before removal.

Set includes:

80 mm boost (brand new in box)

80 mm tacho (used)

60 mm oil pressure (used)

60 mm oil temp (used)

60 mm water temp (used)

Defi Link controller (used)

Defi warning indicator light (brand new in box)

IMG_0790.jpg

R32 Gtst (coupe and 4 door bits):

-Tomei 300km dash $300

-Greddy strut brace front $100

-Custom strut brace rear $70

-Nismo control link set $550

-5Zigen 3”stainless steel turbo back exhaust $250 (from 4 door sedan)

-Intank Gtst fuel pump $80

R32 Gtr parts (Wrecked whole car so ask away even if it's not listed here):

-Rb26dett engine with good compression $2,900 includes wiring loom, ECU, intake, exhaust, clutch, everything to bolt in and drive away

-Intake kit including copy Greddy pipe to intercooler, twin pod filters $400

-Nismo rubber front brake air guides $150

-R32 Gtr N1 turbos, good condition $1,000

-Exedy Clutch, good condition $250

-Apexi Power FC (no hand controller) $550

-R32 Gtr Garrett -5 turbos done approx 15,000km $1,500

-Greddy type R plumback setup $350

-Intercooler 600x400x100mm $150

-BOV setup including stock Rb26 BOVs (return pipe now sold) $200

-Fibreglass bonnet $500. Top condition with N1 lip and aero catches

-Gearbox in good condition $500

-Stock tail shaft $70

-Driveshafts $150 each

-Stock Rb26 front pipes $120

-Stock Rb26 exhaust manifolds and dump pipes $40 each

-Front hubs $150 for the pair

-Lower control arms $50 pair

-Attessa pump $100

-Brake booster $60

-Air con compressor $50

-Alternator $120

-Power steering rack $100

-Steering column $80

-Ignition barrel with key $50

-Indicator and wiper stalks $15 each

-Rear bar reo $170

-Pair of tail lights (gunmetal grey) $50 each or both for $80

-Pair of doors in excellent condition (gunmetal grey) $200 each or $350 pair

-Drivers door card, a couple of indentations where something has rested against it but otherwise perfect $50 (pick up only)

-Passenger front guard $100 no dents but a couple of scratches on the paint

-Side Mirrors (white) $30 pair paint is faded

-Front and rear windows $200 each (pick up only)

-Rear quarter windows $50 each

-Triple gauge cluster $60

-Climate control unit $40

-Stereo/console surround, has one crack but otherwise ok $30

-Sun visors $20 bux pair

-Kick panels $10 each

-Skyline door sill plastics $20 pair

-Fabric under bonnet trim $20

-17 x 9 +24 offset Modena rims (full set with rubber) $600

-Front lip $90, painted black has a fair few scratches, chips and a couple of broken clips (pick up only)

R33 Gtst parts:

-Hubs front only $150 or $250 front and rear

-Rear sway bar $50

-Rear cradle $100 (no brakes or diff, one bent control arm, includes hubs)

-Side skirts $80 pair

-Rear wing $80

-Passenger door $100

-Passenger side mirror $20

-Wiper stalk $15

-Passenger airbag $50 prefer pick up as I'm not sure how well it would go in post

-Ignition barrel with key $50

-Front & rear seatbelts $20 each or $50 for all four

-Climate control unit $30

-B/C pillar trims $30 each or both for $50 (awesome condition)

-ABS unit $50

-ABS bracket $20 (or free if you buy the ABS unit)

-Aftermarket castor rods $50

-Power steering rack $50

-Nissan tool kit $10 (a little rusty but ok)

-Pair of R33 Gtr rims with rubber $450

R33 Gtr (Black 95 non V spec model)

I've got a heap of parts left, pm me with what you need. I don't have front end stuff (except a drivers guard), gearbox or front seats but do have many other bits still.

S13/180sx (removed from a Sileighty) CHEAP!!!!

-5 stud hub conversion $500

-S13 body loom (from Ca18det) $50

-Speedo cable $20

-Corner indicators $30 pair

-Front bumper indicators $20 pair

-Climate control unit $30

-Rear 180sx bar (white) $50

-Rear tail light garnish (the metal bit that goes between the bumper and tail lights) $20 or free if you buy the bumper

-Rear plastic garnish (the red plastic bit that has 180sx on it) $10

-Wiper and indicator stalks (a bit grubby but work fine) $10 each

-Earthing kit $20

-Unbroken radiator overflow bottle $20

-Locked diff with ABS $200

-Rear hubs $50 pair

Link to comment
https://www.sau.com.au/forums/topic/391221-the-fatz-mega-shed-a-thon/
Share on other sites

  • Replies 104
  • Created
  • Last Reply

Top Posters In This Topic

hey mate can i get a pic of the piping kit? what pipes are they exactly? intercooler ones with afm to turbo intake? does it replace the twin turbo pipe ect? thanks

hey mate can i get a pic of the piping kit? what pipes are they exactly? intercooler ones with afm to turbo intake? does it replace the twin turbo pipe ect? thanks

see pic, doesn't include AFM but all pipes and pods shown

IMG_1024.jpg

Pic (and brand) of intercooler? Do you have the radiator fan shroud for R32 GTR? Also looking for a stock 32 GTR ecu, let me now if you'd sell separately. Ta

Edited by doo doo

Pic (and brand) of intercooler? Do you have the radiator fan shroud for R32 GTR? Also looking for a stock 32 GTR ecu, let me now if you'd sell separately. Ta

Intercooler is some bok choy brand, no shroud, stock ecu $200

IMG_1103.jpg

I'll take jetspeed egt if it comes with sensor :-). Pm sent

pm replied and yes it comes with sensor etc

pics of greddy type-r bov kit

shit pic but you get the idea:

Greddybov.jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Ok so after much research and talking with knowledgeable people I've got my turbo conversion done and it's all running great other than 1 small issue.  Car has remained auto with the na auto and tcm, I've used a stagea ecu with. NIstune board and everything is great other than my gear selection on the dash. It illuminates park, reverse, neutral, 3rd and 2nd. But nothing drive or what gear your in when you pop it into tiptronic.  I'm sure there is may e 1 wire in the ecu plug I need to move to rectify this. Dose anyone here have any ideas?   Cheers guys
    • Sorry I haven't been following all the detail, so you may have tried this. Does it idle with the tiniest bit of throttle you can add? You've mentioned the IACV, does it have an AAC valve and have you adjusted it at all (ie, screw the idle adjust screw all the way in, then back it out a couple of turns until idle is stable)?
    • My bad, I unplugged the one underlined in red instead of yellow before. With the car started, after unplugging the IACV (the one underlined in yellow), it idled at around 400/500 for 3 seconds before stalling. Attempting to start the car without the IACV will not start the car.   It does stutter and sputter for around 5 seconds before dying. However, immediately after starting it, you can already hear some slight sputters from the exhaust.   It won't start with the AFM unplugged. If it is when the car has already started, it stalls in a few seconds.   Yesterday, I did take some logs using Nistune of 3 scenarios. Car idling till it stalls Car idling and unplugging the IACV Car idling and removing the AFM I also have some previous logs of when the Car is idling till it stalls and when driving and it cuts. I am not really knowledgeable enough to understand what to look for. After every test, car idles rougher and rougher, until I have to stop. It will be fine the day after.
    • There is no difference between a 17x8 and an 18x8. The total diameter of the tyre needs to remain +/- the same (so you don't mess up the gearing, speedo reading, and clearance when turning front wheels..... so you just need to use a lower profile tyre on th 18 than you do on the 17. /rocket surgery.
    • I thought the same to start with. But then I thought it was one of those LCAs where the end of the ARB goes through a bushing in the LCA itself, instead of having an end link.
×
×
  • Create New...