Jump to content
SAU Community

Recommended Posts

exhaust temp, washer fluid level, monster tacho.

In all seriousness think about what you are using the car for which vitals it's most imperative you keep an eye on and if you'll even have a chance to look at them any time other than when you're sitting at the maccas drive through.

Not point asking people on the net what gauges you should get for hektik pointz

exhaust temp, washer fluid level, monster tacho.

In all seriousness think about what you are using the car for which vitals it's most imperative you keep an eye on and if you'll even have a chance to look at them any time other than when you're sitting at the maccas drive through.

Not point asking people on the net what gauges you should get for hektik pointz

Very true. I too am not a fan of pillar and dash gauges. I like the stock look. My R33 is a weekend car which I have my 2 month old bub in the back. So I certantly wont be doing any hektik drifting.

So far Im thinking boost and oil temp (as I have noticed after a short 5 minute drive and the engine is hot as)

Im deciding between water temp and oil pressure but I dont even know what the later is meant for? Can someone explain?

If you go to an EBC you will generally have a boost guage on them somewhere... If its working properly you shouldn't need a boost reading anyway....

If its just the temp you are concerned about get oil

And water temp guages but if it's getting hot forget spending money on a guage and take it to

A mechanic ;)

Another useless 2c post :D

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yea - I mean I've seen my fuel pump which is decades old and uh, while I'm not saying this with real knowledge... but I sure get the ick at using anything in the fuel system that produced the state of that pump. Many years ago I went through multiple pumps (and strainers) before I dropped the tank to clean it out with extreme violence. I'm talking the car would do maybe 50km before coming to a halt, which resulted in me cleaning out the filter with some brake cleaner and going on my way. None of my stuff ever looked like what came out of your fuel tank. I don't think I'd be happy with it unless every single component was replaced (or at least checked/cleaned/confirmed to be clean here).
    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
    • Agreed, and in particular the earth strap that should go from the subframe to the chassis but it often broken or left off. There is a section in the R32 workshop manual you can follow for troubleshooting if you don't see anything suspicious, and depending where you are (there is no location on your user profile) you should be able to get your hands on a second hand replacement unit still if needed
    • Yeah they mention as a R34 for 2.5 Turbo...but then again thos "small" were also for R34 by that different site. But i look into it and that 310mm EBC is for R34 GTT. And by those you linked the specs are the same 🙂    EDIT: I found these on one site here: DBA 4000 series T3 DBA42304S They are 310mm...and it says are for R34GTT...are there good? EDIT2: ok they have pads too.  What "color" should i get for street use? I dont want/need some noisy ones...(and if they are not that dusty that is good too)
    • Yeah, shame. Maybe  driver's carpet is available 🙏. I am waiting for both amayama and nangun to confirm.
×
×
  • Create New...