Jump to content
SAU Community

Recommended Posts

I had a battery on charge in the garage that got tipped over. I didn't realize it immediately :( but i was on it's side for no less than an hour. It's an Exide sealed battery, you know those yellow top ones you see in K-Mart. Now the battery is good, but it got low due to alot of cranking. So I figured it would be good to give it a nice trickle charge.

I don't want to cause any damage to this battery by doing the wrong thing. So am asking advice on how to check the water levels, and if I should put in some Inox Battery Conditioner as well?

Should I get one of those glass tube things with the rubber ball on the end to test the avid levels too?

Link to comment
https://www.sau.com.au/forums/topic/401808-battery-tipped-and-spilt-some-acid/
Share on other sites

If you can open the top you can put some distilled water in an charge it up.but don't fill it right up. Usually about an inch from the top. You don't need a hydrometer to check it. If you can't open it how much leaked out?

It didn't seem like alot leaked out. Not sure on the measurement, but at least a couple of tablespoons full. The smell was quite strong when I cleaned it up.

Is there a more precise measurement to fill it up to, or just go an inch from the top?

I'm just reading on the Exide website how my battery is supposed to be spill resistant. Hmm time to give them a call I think. Maybe somethings wrong with the battery. Granted it should have ever been on its side, but it's fairly new and supposed to be a decent one.

endurance-large.jpg

Ah it's not a sealed battery. All batteries will have a breather so don't stress. When you remove the caps the plastic below the threads goes down about another inch. Fill till it just reaches the plastic.

Water or add soap if you really wanna get bling on it. I would just put the hose on it

Have never used that stuff. Adding distilled water then charging will turn it into acid. Cheap n easy

Just read product statement and it's designed for rarely used batteries to prevent them dying from sitting stagnant.

Edited by t_revz

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • What copper washer do you guys use on the bleeder bolts? The existing one I have I had no idea where to find it in a local store, I did buy some online but that are only 1mm thick whereas my old one is 2mm+ thick and when I put the new washer out and squeeze the top radiator hose I can hear a bit of air but not with the old one. Does this matter? The new one doesn't leak, but the inner diameter is a bit loose whereas the old one threads on the bolt.
    • Howdy all, after being out a few weeks ago on a spirited drive in my GTR I have 2 issues that oddly have appeared at the same time. Whilst accelerating quickly through the gears all of a sudden i’ve lost power at the top of third gear (below redline around 6000rpm) for no obvious reason.    From that point onwards the car has been running rich on idle, won’t really rev under load without a ton of black smoke and the odd backfire, and dying as a pull up to a set of lights unless I keep the revs up around 1500rpm. In addition when shutting down the car that same night (I was 10 minutes from home) I noticed one of the turbos was significantly noisy on wind down when shutting off the engine. After letting the car cool down overnight it starts up fine, although once it gets to temp the revs start to creep up and down, the exhaust is darker than it should be and it also sounds like it’s running rich (fat note) I’ve put a new set of plugs in it - no change, the old plugs all seemed OK with two of them being somewhat richer/fueled up than the other 3 with 1 being borderline. I’ve smoked tested the intake system via the front of the Turbos, found a split vacuum hose going to the factory boost gauge sender, which I have since replaced.  Also found another leak on the gasket coming off the rear turbo outlet, have also replaced this. After fixing both of these leaks - still have the running rich issue. I’ve also tried another pair of AFM’s - no change here After pulling off the front turbo intake pipes, there is obvious shaft play in the front turbo, which now hisses loudly on light revvs although I can’t see why this would make the car run funny even under idle. I’m curious to know why it’s running rich before I potentially replace/rebuild turbos. The car is completely stock <50,000kms  other than an exhaust. Oil and coolant are all clear. I haven’t bothered with coil packs as it looks like they won’t be the issue due to condition of the plugs. Any help appreciated as I cry myself to sleep!
    • No probs at all. I used to love trying to dig up obscure info for those in need where possible going back 20+ years on SAU.  I did have another look and couldn't come up with any closer match. I'm leaning towards those skirts in your first pic are custom fitments, cut down/extended or from another car entirely and modded to fit an R34 sedan. I would've thought someone in Japan had them and taken a photo at some stage over the last 2 decades but there's nothing. Someone out there must know surely.
    • Welcome mate. Any pics? Even with a DE I'd be well happy if I had that as a 1st car. 
×
×
  • Create New...