Jump to content
SAU Community

Recommended Posts

Channel 10 feed is up and down, but I am enjoying streaming it to my TV from iPad, great to see so much of Le Mans this year, can't believe those Audi's both so close together.

Whoa, that was a horrible accident, hope he's ok.

Edited by cherring

Very depressing watching LeMans this year, was meant to have some of my design work and sponsorship out on track ( again ) but the deal fell through at the last minute :(

Driver attempts to repair the delta wing to get it back to the pits.

378 laps by the winners

5151.8 km distance covered by the winners

40th victory of a French driver

33 pit stops for the winning car

29th victory for a German car

29th victory for a closed car

27th victory for a German driver

21 retirements

21st victory for Michelin and 15th consecutive

12th victory for a car with race number 1

11th victory for Audi (00, 01, 02, 04, 05, 06, 07, 08, 10, 11, 12)

8th victory for a pole position car

8th victory for a team that won the previous year

7th victory for a diesel powered car

5th the position of the best rookie in 2012, Marco Bonanomi.

3:24.180 : The fastest lap of the race by Marc Gené

3rd consecutive podium for Lotterer-Tréluyer-Fässler

3rd consecutive class win for Julien Canal (GTE Am).

2nd consecutive victory for Lotterer-Tréluyer-Fässler

2nd victory for a Swiss driver

1st victory for a hybrid powered car

1st victory for a car with non-permanant 4 wheel drive.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Thanks GTSboy. I will inspect the valves actually, is this something I can do while they are still in the head? The block/bores don’t look bad to be honest hey, I can still see the cross hatches in the bores and they still measure 86.5mm. I’m not sure how to measure the installed ring gaps but I will do that and take it to someone who can. 
    • I’ve had the same headache with my lowered car, scissor jack first then floor jack every time. Ended up grabbing an extra-low profile aluminum jack (about 70mm entry height) and it finally slides under the lip without drama.
    • No sync errors , i have installed AEM disk will return original 360 slot disk and check if there’s any one with running AEM disk could share setup 
    • Its been a while! Finally thought to do something on this car, so here we go. This will be a slow burning, multiple posts as I spend 0.5-1hr a day on this job, over multiple days... Full set of GKTech suspension arms!   Step 1: Buy Arms, done! Step 2: Start removing stuff. HICAS was easy. Rear suspension arms are now gone, they were a bitch but breaker bars with long handle extensions, 2 1.5hr slots later, stock arms are off! Next step, remove the hubs and take them to work to press out the bearings and bushings!  
×
×
  • Create New...