Jump to content
SAU Community

Power Steering Cut And Idling Issues!

EarthShore

By EarthShore,
in General Maintenance

 Share

Recommended Posts

EarthShore Contributor

EarthShore

Posted
Posted (edited)

Power steering cut off while i was driving today. Took a tonne of muscle to move the steering wheel but it came back on after i straightened the wheel out. Also my RPM fluctuates up and down whilst idling. These issues don't always occur, it is really random.

Please help. Kind regards, Simon.

Also the RPM's dip low enough for the engine to cut off.

Edited by EarthShore
Sinista32 Grand Master

Sinista32

Posted
Posted

Obviously you know this is serious from having an accident point of view. brakes and steering affected.

By the time you feel it your engine has alsmost if not already stalled.

Normally I found when it happend to me to occur on corners. Seriously scary !!

Very rare when traveling in a straight line but occasionally had to keep the revs up at the lights.

I was thinking lack of fuel at one stage as it was normaly at qtr of a tank or less or round corners.

I didn't get to the bottom of it before significant work was undertaken on my GTR.

Sinista32 Grand Master

Sinista32

Posted
Posted

No Unfortuantely. I did a big end bearing.

Therefore had an engine rebuild. Whilst it was being rebuilt I had a lot of additioanl work done.

Personally I'd start by checking the flow of your fuel pump.

Could be time to replace fuel pump and repalce your fuel filter.

Hopefully someone like Jez and others can jump in on this thread.

bluey33 Experienced

bluey33

Posted
Posted

I had the same issue whilst drifting. Car would cut out on entries and all the lights would come on dash for split second then it would come back to me.

Caused a lot if straightening and frustrating. Wouldnt as such surge/splutter and carry on. More just cut out and turn back on within a second or so.

Even did it with full tank. Changed fuel pump still no different, checked earths all seemed fine. Never got to the bottom of it.

Plattsy Grand Master

Plattsy

Posted
Posted

my power steering becomes heavy after about 5 mins of driving, and im getting the rev drop when i stop, ive cleaned and resoldered afm, and changed the o2 sensor, ive also cleaned the aac valve which was black as the ace of spades! now im getting it but not as bad, ie its not stalling anymore! i think it could be a fuel pump earth issue, or the tps is not set correctly. ill be investigating this weekend.

Plattsy Grand Master

Plattsy

Posted
Posted

It was the fix I least expected! But I think the gear box on the auto ha something todo with the peer steering fluid???????????? I'd check afm AAc and tps sensors and I suppose a gear box oil change couldn't hurt! I was genuinely shocked when I topped it up and 10 mins later the car was driving like new! Let us know how you get on tomorro mate!

EarthShore Contributor

EarthShore

Posted
  • Author
Posted

Cleaned the AAC and checked the AFM but still didnt fix the idling issue. However I saw that the engines RPM could be manipulated by wiggling the bottom cord which connected to the TPS. I'm really starting to think it's the TPS. I ordered a new TPS and will fit it ASAP. I'll let you guys know how it goes. Cheers!

Plattsy Grand Master

Plattsy

Posted
Posted

Make sure it's positioned right, I don't know how to do it but there is a thread on here about how to set your tps, even if you put a new one on but it's in the wrong position, it still wont work properly x

EarthShore Contributor

EarthShore

Posted
  • Author
Posted (edited)

Thnx found it! Set the TPS to the correct voltage. It appears to have fixed the Idling problem, however it does idle too high now. I'm gonna have to do an idle reset tomorrow. Will let u know how it goes.

Also i lowered the idle using the screw on the AAC valve as much as I could. The idle still sits at a high 1200 rpm so I'm assuming I need to adjust the Idle using the idle screw on the ECU?

Edited by EarthShore
EarthShore Contributor

EarthShore

Posted
  • Author
Posted
http://www.skylinesaustralia.com/forums/topic/404812-help-setting-tps-on-r33-s2/ if u have a S2 its the brown plug (bottom one) and the middle red wire :) cheers for the help. After setting the correct voltage to my new tps the car runs like a dream. As for the power steering problem it seems to have subsided for now :P

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • MBS206
      NC MX5

      By MBS206 · Posted

      There's a good German place in Brisbane if youre up for the drive 😛
    • Dose Pipe Sutututu
      NC MX5

      By Dose Pipe Sutututu · Posted

      The German place in Cabramatta was rock solid, fresh pretzel cooked to order back then. Then it went all quiet, after all the poker machines were removed, then I believe it closed for good. I did drive past the other week and noticed outdoor lighting a big screen, but no idea what is there now.  
    • joshuaho96
      R33 GTR running -9 with no tune

      By joshuaho96 · Posted

      Yeah I suspect even if you hold airmass per cycle/cylinder constant if you get too far away from stock you're still going to have problems running the factory tune within the bounds of the factory load scale. Cams, different displacement/rod ratio, etc. I'm just lucky that the GTIII-SS with wastegate boost + CA compliance cats is pretty much equivalent to stock turbos. When I have actual space I can finally get it tuned and modify the fuel system for flex fuel to 100% handle any detonation concerns when cranking the boost to whatever those dinky turbos can put out.
    • The Bogan
      NC MX5

      By The Bogan · Posted

      I would say no, why, because my daughter, who also lives in Goulburn, hasn't recommended us going there Pity, as we miss all the German joints around in Sydney, actually, the restaurants are the only thing I really miss about Sydney, and a special mention to Ishibanboshi at Bondi Junction, their Kara-age Don is heart cloggingly deliciousness (always added a special boiled egg...or 2) 😋 
    • GTSBoy
      NC MX5

      By GTSBoy · Posted

      Does that German restaurant still exist in the old place out the NW end of Goulburn? When I say "out the NW end of"...I am really being vague. It was 1997 when I was last there, and the only point of reference I can recall is that it was on the opposite side of the main drag from the big merino. And when I say "opposite side of the main drag", I don't mean "on the main drag". It was either a couple of streets back from there, or might have even been out in the sticks a bit further. Was an old farm building or mill or somesuch. And when I say "the big merino" I might actually be thinking of a completely different part of town, because I just looked on maps and the big bugger is not where I remembered him to be! The food was good, consisting largely of various German mystery-meat sausage/loaf things and kartofflen.
×
×
  • Create New...