Jump to content
SAU Community

Recommended Posts

Prob going to sell this rather then use it. Neo bottom end with the following mods

- crank grub screwed and crank collar fitted.

- new acl race bearings

- Hastings rings fitted

- arp rod bolts with rb26 prepped rods

- oil restricters and block of fitted

- mls head gasket

- block has been washed, cleaned, honed and decked.

-brand new nitto oil pump.

Motor has perfect compression, works well. decided to go down a different path.

$1700 as is or $700 with no oil pump.

located Para Hills SA

Contact me via PM

602585_3901204761958_233297064_n.jpg

interested! when I get my head off in the next few days and inspect the bottom end ill know if I need this.

Would shipping be an issue to NSW?

i thought the neo pistons were diff and you could only use the neo head?

im keen on the block with pump, if a 33 head can def be used here :yes:

from wat im aware u can fit any head on a neo bottom end but not a neo head with any pistons.. they need to be domed for clearance

hope this helps

Cheers

I had a 26 head on this with no problems.

The Neo and non Neo pistons are same deck height and pin height but Neo piston is stronger. The difference is in the Neo head.

so all in all. Any 25 or 26 head will work

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • If it (the code) wasn't still current, it should have gone away by itself by now. No, nothing it 10/10. But it is quite likely. Everything else to do with the ignition could still be responsible (which is wires and connectors). The car is an old piece of shit now, so all the wires and connectors are also old pieces of shit.
    • Lock me in mate, although I'm not sure if I'll be heading up from Goulburn or down from Sydney, either way, return will be back to Goulburn 
    • Sounds good, we will aim to be there! @The Bogan I'll give you a shout if you are heading up to campbelltown for the meet too.
    • Before I get to the test day, just to finish off the android head unit. This is a demo from car start up....the standard/host system takes a few seconds to boot (same as all v37) but Android comes up quickly. In this vid I'm using the delivered launcher but have set the default to Agami since which is easier to navigate when if use primarily 5 apps. You can see the host system still takes over when required eg putting it in reverse, and you can switch between Android and not by holding the back button 3 sec. It is pretty responsive (fast) but you can see I had to press harder than expected a couple of times.  I still have the phone connected to the stock system, and that also seamlessly takes over Android music playing. v37-android-demo.mp4 The bigger reason that I put this in though is so that I can use Ecutek directly on the head unit. That gives me a dash with logging (up to 20MB only), high and low value warnings on any parameter etc etc. I've run a USB cable from the Ecutek OBD dongle to a USB input on the unit, easy. v37-ecutek-demo.mp4   The unit did freeze on the launcher the other day, I think Agami was trying to verify the license when it didn't have a data connection...will monitor and report back if there are any other problems but so far I'm very happy with the upgrade.
    • Nah that is just crappy GPS mapping, I did have a small excursion (cold tyres, damp track, surprise!), will post up that when I get a chance.
×
×
  • Create New...