Jump to content
SAU Community

Recommended Posts

Hi all,

My r32 started acting up today and I wanted to see if anyone has had similar symptoms before pulling things apart.

The car is difficult to start and needs a little pumping of the accelerator to get it going.

It 'hunts' at idle from 500 to 1000rpm on about a 1sec cycle but only when in nuetral or park.

when in gear it idles smoothly at around 800rpm as it always has.

I can accellerate very very very slowly (trucks full of soil pull away from me) and get to about 70kph.

if i put my foot down even the slightest bit it cuts out and sounds like the air intake has been blocked.

Tends to cut out after about 20mins, in the way it would if it had no fuel

The issue first started when stuck in very heavy traffic.

My guesses are injectors, MAF, TPS. perhaps even fuel pressure reg, but i doubt that one.

Hopefully it's not something internal like a bent valve.

Cheers, ROB.

Link to comment
https://www.sau.com.au/forums/topic/405925-r32-gts4-rb20det-at-engine-issue/
Share on other sites

Thanks guys, Turned out the AFM just needed a good clean which, coincidently, is a far cheaper problem than bent valves would have been. I am amazed though that a little bit of errant road grime could cause such a massive and sudden effect.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yea - I mean I've seen my fuel pump which is decades old and uh, while I'm not saying this with real knowledge... but I sure get the ick at using anything in the fuel system that produced the state of that pump. Many years ago I went through multiple pumps (and strainers) before I dropped the tank to clean it out with extreme violence. I'm talking the car would do maybe 50km before coming to a halt, which resulted in me cleaning out the filter with some brake cleaner and going on my way. None of my stuff ever looked like what came out of your fuel tank. I don't think I'd be happy with it unless every single component was replaced (or at least checked/cleaned/confirmed to be clean here).
    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
    • Agreed, and in particular the earth strap that should go from the subframe to the chassis but it often broken or left off. There is a section in the R32 workshop manual you can follow for troubleshooting if you don't see anything suspicious, and depending where you are (there is no location on your user profile) you should be able to get your hands on a second hand replacement unit still if needed
    • Yeah they mention as a R34 for 2.5 Turbo...but then again thos "small" were also for R34 by that different site. But i look into it and that 310mm EBC is for R34 GTT. And by those you linked the specs are the same 🙂    EDIT: I found these on one site here: DBA 4000 series T3 DBA42304S They are 310mm...and it says are for R34GTT...are there good? EDIT2: ok they have pads too.  What "color" should i get for street use? I dont want/need some noisy ones...(and if they are not that dusty that is good too)
    • Yeah, shame. Maybe  driver's carpet is available 🙏. I am waiting for both amayama and nangun to confirm.
×
×
  • Create New...