Jump to content
SAU Community

Recommended Posts

hey guys ive got a heap of spares that im selling to make more room in the garage

Rb25det s2 turbo off a low kms r33 - $300

rb20det engine loom - $140

rb20det flywheel - $60

r32 LCA's - $70

various autometer gauges - $60 each

apexi turbo timer - $50

pod filters - $20 each

r32 5 stud front hubs - $70

r32 centre A/c vent (average) - $50

RB20DET intake manifold with throttle body, tps and fuel rail - $100

RB20DET exhaust manifold - $60

rb20 manifold heat sheild - $30

rb20 turbo oil and water lines set - $40

rb20 turbo heat sheild - $30

r32 gtr fuel pump - $80

RB20DET - harmonic balancer - $60

RB25DET starter motor - $65

RB20DET starter motor - $65

RB25DET cas - $100

RB20DET cas - $100

RB25DET crossover pipe no bov - $40

RB20DET engine mount brackets - $60

RB25DET engine mount brackets - $60

rb20 p/s pump bracket - $20

RB20DET hicas p/s pump - $80

rb20 a/c pump bracket - $20

RB20DET afm - $60

R32 GTST dash cluster blue type - $90

R32 GTST dash cluster grey type - $90

RB20/25 dump pipe - $30

RB20/25 turbo intake pipe - $30

RB20 crossover pipe with stock bov - $60

RB25 crossover pipe with stock bov - $60

R32 sedan power window switch - $100

R32 coupe power window switch - $60

R32 boot lid needs some holes fixed and a paint - $50

RB20 aac valve - $50

RB20 coilpack loom - $80

RB20DET coilpacks all working perfect - $130

RB20DET ingiter - $90

R32 cusco strut brace - $100

R32 stereo/shifter surround $120

R32 window wipers - $20

R32 manual crossmember - $50

R32 clutch fork with throw out bearing carrier - $70

R32 manual sandwich plate - $40

RB20 fuel rail with stock fpr -$20

RB20 a/c compressor - $90

RB20 injectors - $60

RB20 exhaust manifold - $60

RB20det ecu (mines tuned)- $150

RB20 timing belt covers (both covers) - $60

R32 headlights projector type - $240

R32 indicators orange type - $140

R32 indicators clear type - $140

R32 coupe rear bar - $70

R32 rear calipers with new pads - $80

rb20 cas mounting bracket - $30

r32 sedan tail lights - $40 each

r32 sedan rear bumper poor cond $30

r32 rb26 cas - $100

r32 rb26 ignitor - $100

r32 rb26 coilpacks - $130

I have more stuff lying around heaps of interior bits and random stuff so if you need something just ask

pickup from springwood

Link to comment
https://www.sau.com.au/forums/topic/408700-rb20det-and-r32-parts/
Share on other sites

ignitor in total working order? Post to Adel 5114?

are the clear indicators totally clear or with the orange part?

if their totally clear ill have them toorb20 ignitor

Edited by GH05T
  • 2 weeks later...


  • Similar Content

  • Latest Posts

    • What copper washer do you guys use on the bleeder bolts? The existing one I have I had no idea where to find it in a local store, I did buy some online but that are only 1mm thick whereas my old one is 2mm+ thick and when I put the new washer out and squeeze the top radiator hose I can hear a bit of air but not with the old one. Does this matter? The new one doesn't leak, but the inner diameter is a bit loose whereas the old one threads on the bolt.
    • Howdy all, after being out a few weeks ago on a spirited drive in my GTR I have 2 issues that oddly have appeared at the same time. Whilst accelerating quickly through the gears all of a sudden i’ve lost power at the top of third gear (below redline around 6000rpm) for no obvious reason.    From that point onwards the car has been running rich on idle, won’t really rev under load without a ton of black smoke and the odd backfire, and dying as a pull up to a set of lights unless I keep the revs up around 1500rpm. In addition when shutting down the car that same night (I was 10 minutes from home) I noticed one of the turbos was significantly noisy on wind down when shutting off the engine. After letting the car cool down overnight it starts up fine, although once it gets to temp the revs start to creep up and down, the exhaust is darker than it should be and it also sounds like it’s running rich (fat note) I’ve put a new set of plugs in it - no change, the old plugs all seemed OK with two of them being somewhat richer/fueled up than the other 3 with 1 being borderline. I’ve smoked tested the intake system via the front of the Turbos, found a split vacuum hose going to the factory boost gauge sender, which I have since replaced.  Also found another leak on the gasket coming off the rear turbo outlet, have also replaced this. After fixing both of these leaks - still have the running rich issue. I’ve also tried another pair of AFM’s - no change here After pulling off the front turbo intake pipes, there is obvious shaft play in the front turbo, which now hisses loudly on light revvs although I can’t see why this would make the car run funny even under idle. I’m curious to know why it’s running rich before I potentially replace/rebuild turbos. The car is completely stock <50,000kms  other than an exhaust. Oil and coolant are all clear. I haven’t bothered with coil packs as it looks like they won’t be the issue due to condition of the plugs. Any help appreciated as I cry myself to sleep!
    • No probs at all. I used to love trying to dig up obscure info for those in need where possible going back 20+ years on SAU.  I did have another look and couldn't come up with any closer match. I'm leaning towards those skirts in your first pic are custom fitments, cut down/extended or from another car entirely and modded to fit an R34 sedan. I would've thought someone in Japan had them and taken a photo at some stage over the last 2 decades but there's nothing. Someone out there must know surely.
    • Welcome mate. Any pics? Even with a DE I'd be well happy if I had that as a 1st car. 
×
×
  • Create New...