Jump to content
SAU Community

Recommended Posts

So, i've been away for a month and a bit, i came back, and sure enough, my battery is dead.

I tried to jump it off a friend's car, but no luck, my interior and dash lights turn on, volt meter shows that good current is being passed to my battery, but when i try to start, she barely cranks.

could it be that the battery is just so dead that even when hooked up to another car, it doesn't have enough juice to start?

should i leave it connected to my friends car while its running for a few minutes to try to charge the battery, and then try to turn the key?

ps, the jumper cables i got from my friend were a little thin, any possibility that the cables are just not thick enough to enough amps to crank my engine?

any input would be appreciated, thanks

Link to comment
https://www.sau.com.au/forums/topic/409104-help-dead-battery-wont-start/
Share on other sites

As the fellas above me have said ^^

Ps How much Volts are you getting across the battery ?? Also what car is it ? If its a 33GTST or 33/4 GTR try using the contacts on the fuse box instead to jump it worth a shot..

Edited by nomnomv8

ps, the jumper cables i got from my friend were a little thin, any possibility that the cables are just not thick enough to enough amps to crank my engine?

^^You will know this 'cos they'll be too hot to handle, maybe even smoke up. Trickle charge (30bux from Supercrap) or new battery (bat may be stuffed anyway), like wives & girlfriends they do not take kindly to being left sitting around & ignored.

If you go away again for any length of time, disconnect or remove battery & store somewhere safe, preferably off the concrete floor. Works for me. :thumbsup:

My 2c

GW

When we get REALLY dead cars at work we use a few methods-

Strap 2 heavy duty jump packs onto it + jumper cables to another car and have someone reving the other car at around 3-4000rpm to charge it a bit.

From memory, i think you need more than 12.4 volts to start a car.

trickle charger wont do as its not meant to be used on near dead batteries..

goto battery world and for $20 bucks they will recharge your battery with their chargers and after that request a free load test when starting the car

otherwise u may need to replace it if it does not hold charge anymore

Whether a trickle charger (4 ~ 6 amps continous) is meant to be used on near dead (flat) batteries or not is neither here nor there.

For around 30bux you can get a trickle charger & try it. Worst case scenario you have this handy piece of gear in your arsenal for future calamities.

The only time a trickle charger will not do the job over some period of time & usually 8 ~ 24 hours is if the battery is rooted in the first place.

With reference to multi-cell batteries of any type, "rooted" = shorted (or reversed charged) individual cells, individual plates consumed/completely sulphated, full of..........etc. Obviously if your battery is past it's "use-by" date/old in the first place you will be outta luck.

For the price of a carton of Crownies it's worth a try.

My 2c

Cheers, GW

It has been my experience that the battery in the car being jumped needs to have at least some charge in it. A completely dead battery needs to be connected to the (running) jumper car for around 10 minutes to get some charge before you can even think about trying to start it.

And yes, HD cables are worth the investment. I've had lightweight cables become quite hot during even the simplest of jump starts. You can do an easy jump start with HD cables, but you can't do a difficult start with lightweight cables.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Even more fun, leave all the ADAS stuff plugged in, but in different locations, hopefully avoid any codes!   And honestly, all these new cars with their weird electronics. Pull all the electronics out Duncan, and just shove an aftermarket ECU and if needed a trans controller in, along with a PDM. Make it run basic but race car styled!
    • To follow up a question from earlier too since I had the front bar off again (fking!) This is what is between the bumper and the drivers side wheel And this is the navigator side, only one thing but its a biggy! So basically....no putting coolers in the wheel arches without a lot of moving other stuff. Assuming I move to properly race prepping this car I'll take that job on and see how the computers respond to removing a whole bunch of ADAS modules
    • So I prepped the car for another track day on Wednesday (will be interesting to see coolant temps post flushing out and the larger reservoir, with a forecast of 3-14 being 20o cooler than last time I took it out). Couple of things to mention; since I am just driving the car and not taking a support vehicle, I took the rear seats out and just loaded the back up Team Trackday style. Look at all that space! To cover off removing the rear seat....it is weird (note the hybrid is probably different because it wouldn't have folding rear seats) Basically, you remove the lower seat base, very similar to a r series but it is a clip that pulls forward to release the base rather than it being bolted down. Easy Then, you need to remove the side section of the rear seat on each side. There is a 14mm head nut at the bottom of the side piece, the it slides upwards off a hook at the top to release; you also need to unhook the seatbelt from the loop at the top. Then the centre piece is weird. You need to release/fold the seats forward with the tab in the boot on each side From there, there are 2,x12mm headed bolts holding the rear of each seat to the folding bracket, under the trim between the rear seat and the boot (4x christmas tree clips there, they suck). The seat is out but you can see where the bolts attach to the bracket
    • As discussed in the previous post, the bushes in the 110 needed replacing. I took this opportunity to replace the castor bushes, the front lower control arm, lower the car and get the alignment dialled in with new tyres. I took it down to Alignment Motorsports on the GC to get this work done and also get more out of the Shockworks as I felt like I wasn't getting the full use out of them.  To cut a very long story short, it ended up being the case the passenger side castor arm wouldn't accept the brand new bush as the sleeve had worn badly enough to the point you could push the new bush in by hand and completely through. Trying a pair of TRD bushes didn't fix the issue either (I had originally gone with Hardrace bushes). We needed to urgently source another castor arm, and thankfully this was sourced and the guys at the shop worked on my car until 7pm on a Saturday to get everything done. The car rides a lot nicer now with the suspension dialled in properly. Lowered the car a little as well to suit the lower profile front tyres, and just bring the car down generally. Eternally thankful for the guys down at the shop to get the car sorted, we both pulled big favours from our contacts to get it done on the Saturday.  Also plugged in the new Stedi foglights into the S15, and even from a quick test in the garage I'm keen to see how they look out on the road. I had some concerns about the length of the LED body and whether it'd fit in the foglight housing but it's fine.  I've got a small window coming up next month where I'll likely get a little paint work done on the 110 to remove the rear wing, add a boot wing and roof wing, get the side skirt fixed up and colour match the little panel on the tail lights so that I can install some badges that I've kept in storage. I'm also tempted to put in a new pair of headlights on the 110.  Until then, here's some more pictures from Easter this year. 
    • I would put a fuel pressure gauge between the filter and the fuel rail, see if it's maintaining good fuel pressure at idle going up to the point when it stalls. Do you see any strange behavior in commanded fuel leading up to the point when it stalls? You might have to start going through the service manual and doing a long list of sensor tests if it's not the fuel system for whatever reason.
×
×
  • Create New...