Jump to content
SAU Community

Recommended Posts

I'm my experience the rears are ball! If it is an NA. Hicas models used forks. The easiest way to check is to get down and have a look under the car for yourself :) it would probably take you less time to do that than read this reply :)

So if your buying coilovers you will probably be looking at ones that are reccomended for 33gtst

For a R34GTT its definately a fork type because they have the 4WS (HICAS ) like what Daniel said.I ordered mine yesterday this time from garage7 should have them by Friday. There are coilovers for GT from Justjap and they're ball type

Edited by B-rice

So if your buying coilovers you will probably be looking at ones that are reccomended for 33gtst

This.

The front struts are the same in the R33s and the R34s. On the rear the R33 and N/A R34 runs a eyelet at the bottom of the rear strut and the R33 GT-R and R34 GT-T run a fork at the bottom of the rear strut.

Plenty of different kits out there for the R33 GTS-T that will bolt in, it's now just a case of choosing the correct one for your application ;)

  • 3 weeks later...

I'm my experience the rears are ball! If it is an NA. Hicas models used forks. The easiest way to check is to get down and have a look under the car for yourself :) it would probably take you less time to do that than read this reply :)

So if your buying coilovers you will probably be looking at ones that are reccomended for 33gtst

I think its forks on the rear, but not 100% sure. What am i looking for?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...