Jump to content
SAU Community

Bought An Rs4

fatz

By fatz,
in Four Door Family & Wagoneers

 Share

Recommended Posts

fatz Grand Master

fatz

Posted
Posted

after hanging shit on drunkan for years i decided to buy one of these for a laugh.

anyway it has a lunched motor, and i have an rs260 frontcut in my shed that just wants to go into it to make it a little bit more fun.

so ill slap the conversion it in over the next few weeks and have some fun.

any tips would be appreciated on stuff to look out for during the conversion.

bought off a local sydney sau guy.

stag2.jpg

Link to comment
https://www.sau.com.au/forums/topic/413114-bought-an-rs4/
Share on other sites
  • Replies 58
  • Created
  • Last Reply

Top Posters In This Topic

Popular Days

Top Posters In This Topic

Popular Days

pipster11 Grand Master

pipster11

Posted
Posted (edited)

haha, welcome to the club fatz

also, you have a lot of project cars

my tips would be:

use the 34 clutch master (without the gtr/260rs booster) and you don't have to recess the firewall

get a manual cradle so the front and rear tracks are the same, i think gtr may also be the same or s14

also, maybe take the auto radiator out and put a 33 one in to piss off the heat exchanger

oh, and check for rust under the wing mirrors

and if its got only 1 reverse light check for epic rust

Edited by pipster11
Link to comment
https://www.sau.com.au/forums/topic/413114-bought-an-rs4/#findComment-6610916
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Dose Pipe Sutututu
      What brakes on R34 GTT(Europe)

      By Dose Pipe Sutututu · Posted

      Pads for R32 GTS-t, R32 GT-R non V-Spec (Sumitomo), R33 GTS-t and R34 GT-t are all interchangeable. R34 GT uses a 2x piston caliper, hence it didn't fit.
    • soviet_merlin
      WGNC34 - floor mats

      By soviet_merlin · Posted

      Checked with amayama and nope, the full S2 manual set is not available anymore. Unsurprising, but still disappointing as the ? on availability gave a glimmer of hope.
    • joshuaho96
      Tomei gasket

      By joshuaho96 · Posted

      I've heard the Tomei USA head gaskets are decent if you want to o-ring the heads but otherwise not recommended.
    • GTSBoy
      What brakes on R34 GTT(Europe)

      By GTSBoy · Posted

      The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Kapr
      What brakes on R34 GTT(Europe)

      By Kapr · Posted

      Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
×
×
  • Create New...