Jump to content
SAU Community

Removing rear bar - need help

LaL

By LaL,
in General Automotive Discussion

 Share

Recommended Posts

Craved Grand Master

Craved

Posted
Posted

6 nuts to be undone from inside the boot ... 3 either side below the lights towards the outside of the car.. 12mm if i remember right... then you have to remove the "skyline" from between the lights (4 nuts from behind plastic panel near latch) then there will be 2-3 clips on a shelf the bar sits on......... then slide it out!!

oh and check out the number plate mount.. will have to remove plate and possibly the mount too... i removed mine but not sure if essential!!

hope this helps

myr332 Enthusiast

myr332

Posted
Posted
6 nuts to be undone from inside the boot ...  3 either side below the lights towards the outside of the car.. 12mm if i remember right... then you have to remove the "skyline" from between the lights (4 nuts from behind plastic panel near latch) then there will be 2-3 clips on a shelf the bar sits on......... then slide it out!!

oh and check out the number plate mount.. will have to remove plate and possibly the mount too... i removed mine but not sure if essential!!

hope this helps

cool... i'll use this when my bodykit finally arrives.

you mention the "skyline" between the lights. do you know where I can get a hold of the "skyline" that actually illuminates? i don't know if this is an extra thing or if it's part of the series 1 skylines?

be very interested in getting a hold of one of those...

LaL Rising Star

LaL

Posted
  • Author
Posted
cool... i'll use this when my bodykit finally arrives.

you mention the "skyline" between the lights.  do you know where I can get a hold of the "skyline" that actually illuminates?  i don't know if this is an extra thing or if it's part of the series 1 skylines?

be very interested in getting a hold of one of those...

i have the SKYLINE PART off this gtr i am wrecking. what you wanna pay for it? its silver

myr332 Enthusiast

myr332

Posted
Posted
i have the SKYLINE PART off this gtr i am wrecking. what you wanna pay for it? its silver

really? nice... so it is the "skyline" section that is of the see-through type indicator plastic material type thingo-ma-boby-ma-jig (beware; i'm getting highly technical here)...? i'm not interested unless it lights up, because i've seen a few of them and they do look very cool and very rice'y..

cost? no idea... what's the going rate?

Craved Grand Master

Craved

Posted
Posted

myr332, the ones that light up are from series 1 gtst's cause they are clear, just have to install led's behind it.. i put a neon back there but it's not big enough.. will be hooking up led's soon!

you also have to paint the panel around the letters if you only want the letters lighting up, or leave it if you want all of it (skyline has silver chrome paint on it standard)..

Craved Grand Master

Craved

Posted
Posted
i think they go for about $250 F-Off-Buckaroos at a wreckers.  thats just too much for rice in my oppinion...hehe.  its only 20bucks or so here per sack at the local groceries:D:D

LOL, but does it GLOW??? :headbang:

myr332 Enthusiast

myr332

Posted
Posted
myr332, the ones that light up are from series 1 gtst's cause they are clear, just have to install led's behind it.. i put a neon back there but it's not big enough.. will be hooking up led's soon!  

you also have to paint the panel around the letters if you only want the letters lighting up, or leave it if you want all of it (skyline has silver chrome paint on it standard)..

so all I have to do is go to a wreckers and buy the see-through variety skyline plate? do they have these packaged anywhere (including the required neon) that I can buy off the shelf, or will it be a bit of a DIY job?

thanks for your help! :)

Blitz Grand Master

Blitz

Posted
Posted
no hes not. heslooking for a Series 1 R33 GTSt centre skline panel. stop acting like MR KNOW IT ALL.

Learn to read you rude little twat

cool... i'll use this when my bodykit finally arrives.

you mention the "skyline" between the lights.  do you know where I can get a hold of the "skyline" that actually illuminates?  i don't know if this is an extra thing or if it's part of the series 1 skylines?

be very interested in getting a hold of one of those...

Blitz Grand Master

Blitz

Posted
Posted
offcourse i read what he said, i was offering him something and you don thave to interupt like on all of my other sales.

You are a moron that clearly has an issue comprehending plain english.

I was clarifying what myr332 appeared to be looking for to assist your thread and attempt to prevent confusion.

Enough crying

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • GTSBoy
      Leak from Tokico BM50 Brake Master Cylinder

      By GTSBoy · Posted

      HFM BM57 has a "bad" knee point, IIRC. It's not the same thing as the later R chassis MC.
    • Duncan
      Who has a Infiniti Q60, Q50 (V37)?

      By Duncan · Posted

      The ATTESSA is functionally identical to R34; there were a bunch of JDM models that continued ATTESSA including Fuga/Q70, Skyline/Q50, Cima etc as an option. All with Auto only and I think mostly for snow regions. AFAIK there were no AWD VR30DDTT sold in Australia - it is on my to do list to check regs for racing a LHD car in Targa/ATR/AASA/CAMS events because if I can get the auto to work it would be interesting to run a 4wd car The Ecuteck TCM tuning is the same model as their ECU tuning, they already have it for R35 and Dose's favourite, BMW. You buy "points" to allow your computer to be tuned, buy either a bluetooth (phone app) or bluetooth+USB+Key (phone and PC) dongle, and pay for a tune that will be locked to your tuner ( ). You can also access the tuning software yourself but 1. it is mega expensive and 2. these computers have a billion parameters that intersect, so how could you ever spend enough time on it to get a decent result.
    • MBS206
      Who has a Infiniti Q60, Q50 (V37)?

      By MBS206 · Posted

      Or, is it a case of what it is like owning an R series Skyline? NFI what the previous owner has done or fiddled with... Ha ha ha After reading through this thread, I went on a bit of a research about the Q50/Q60. Now I'm quite intrigued by them! Is the AWD in them more like a WRX where it's always AWD, or is it more like the ATTESSA in the GTRs? By the sound of this TCU tuning, this sounds like a case of someone has made some real software for it, and you just need the right piece of hardware, and then you license that specific vehicle/TCU. Or is this a case of the software will be really expensive so only a few tuners have it, and you still have to pay a license per vehicle?
    • CF.Panda
      R34 25GT Engine Light 21

      By CF.Panda · Posted

      By popular demand.. it was a coil. Got my hands on 1 new OEM coil, replaced with the one that made the less noise difference when I unplugged it while the car was running and started the car up. No stutter and the engine light was gone. I guess I’ll buy the other 5 they have lol
    • joshuaho96
      R34 25GT Engine Light 21

      By joshuaho96 · Posted

      No, code 21 is very straightforward. It can only be the things described in that diagnostic flow. In fact it has no way of knowing that the spark plug resistance is out of spec.
×
×
  • Create New...