Jump to content
SAU Community

Recommended Posts

Badben your sig say's you drive a 32 GTR. You mustn't do much night driving.

Get any modern car behind an old R32 at night and the 32 driver is driving in his own shadow.

Unfortunately their headlamp design is 20+ years old.

Add the sad wiring design and you've got poor lights, especially on low beam.

But fitting 6500+ HID's is just asking for trouble from the law who can pick the way overblue colour a mile off.

And what driver wants to be blinded by road sign reflection from his your own lights.

Stay with 4300 max. on low beam only.

  • 2 weeks later...

R31 projectors are better than R32 ones!

I have 4300K in my 32, make sure you aim the lights properly (should be juust below horizontal, as the car is low).

Heaps of glare, but that's just poor projector design to begin with.

I'm in the process of going back to halogens, going to test out a few bulbs.

BTW, if you have reflectors, I hope you're not using aftermarket HID kit. 'Blue Power' halogens work well.

The factory R34 HID's have a nice clean light cut-off, they don't dazzle at all. If you stick to 4300K bulbs and leave the level adjustment to the lowest setting you're not likely to ever get any unwanted attention.

That sux bro - I'm in the middle of putting GTR HID's in my ER34 :\ hope the same doesn't happen to me. On that note, if anyone has done this before can you let me know - i'd like to run a couple things by you as I'm having trouble.

Cheers.

  • 5 months later...

I know this thread is a bit old so apologies for necro posting but everywhere I search I see people repeating the same "must have auto levelling" line.

However, from the relevant ADR:

http://www.comlaw.gov.au/Details/F2013C00238

Vehicle Standard (Australian Design Rule 13/00 - Installation of Lighting and Light Signalling Devices on other than L-Group Vehicles) 2005

6.2.6.2.1. In the case where a headlamp levelling device is necessary to satisfy the requirements of paragraphs 6.2.6.1.1. and 6.2.6.1.2., the device shall be automatic.



6.2.6.2.2. However, devices which are adjusted manually, either continuously or non‑continuously, shall be permitted, provided they have a stop position at which the lamps can be returned to the initial inclination defined in paragraph 6.2.6.1.1. by means of the usual adjusting screws or similar means.



These manually adjustable devices must be operable from the driver's seat.



Continually adjustable devices must have reference marks indicating the loading conditions that require adjustment of the dipped-beam.



The number of positions on devices which are not continuously adjustable must be such as to ensure compliance with the range of values prescribed in paragraph 6.2.6.1.2. in all the loading conditions defined in Annex 5.



For these devices also, the loading conditions of Annex 5 that require adjustment of the dipped-beam shall be clearly marked near the control of the device (see Annex 8).

Of course this doesn't automatically mean the R34's xenons are legal but at first glance they seem to meet the basic requirements of levelling (not sure about specifics like max. adjustments etc.) There is definitely wiggle room with regards to levelling requirements.

If I'm incorrect on any of this please let me know.

I know this thread is a bit old so apologies for necro posting but everywhere I search I see people repeating the same "must have auto levelling" line.

However, from the relevant ADR:

http://www.comlaw.gov.au/Details/F2013C00238

Vehicle Standard (Australian Design Rule 13/00 - Installation of Lighting and Light Signalling Devices on other than L-Group Vehicles) 2005

Of course this doesn't automatically mean the R34's xenons are legal but at first glance they seem to meet the basic requirements of levelling (not sure about specifics like max. adjustments etc.) There is definitely wiggle room with regards to levelling requirements.

If I'm incorrect on any of this please let me know.

Don't know why I'm posting in an old thread as well or how you found this but some food for thought, some R34's with OEM Xenon headlights DON'T have the leveling switch where the switch panels is next to the driver window switch, then again some HAS. My car is equipped with it so I think that would be the bare minimum. Also have been told that there needs to be "washers" for the headlights, incase the dust can dazzle oncoming drivers..

Came across this thread looking for headlight parts for my R34. Agree that washers are required too, was just pointing out that lack of auto leveling isn't necessarily a reason for being defected :happy: .

Don't know why I'm posting in an old thread as well or how you found this but some food for thought, some R34's with OEM Xenon headlights DON'T have the leveling switch where the switch panels is next to the driver window switch, then again some HAS. My car is equipped with it so I think that would be the bare minimum. Also have been told that there needs to be "washers" for the headlights, incase the dust can dazzle oncoming drivers..

Fair enough if that's the case..were these cars coupes or sedans? It just seems a bit odd because according to Nissan data, xenons + adjusters went hand in hand together and were standard equipment on the coupes, OPTIONAL package for certain sedans (see links below). That would lead me to believe any xenon cars without adjusters were not factory xenons, i.e. xenons were fitted afterwards by the owner (aftermarket kits or swapped with OEM xenon headlights), or with switches taken out (duno why somone would do that though).. who knows. But of course I could be totally wrong as I'm relying on the accuracy of nissan's own data.. :)

Sedans:

http://translate.googleusercontent.com/translate_c?depth=1&hl=en&prev=/search%3Fq%3Dnissan%2Bhistory%2Bjp%26safe%3Doff%26client%3Dopera%26hs%3Db4W%26hl%3Den%26channel%3Dsuggest%26biw%3D2560%26bih%3D1284&rurl=translate.google.com.au&sl=ja&u=http://history.nissan.co.jp/SKYLINE/R34/9805/SPEC/frame4d.html&usg=ALkJrhjf7Ao5yxBJiPHYxg09cx6_KcTWYQ

Coupes:

http://translate.googleusercontent.com/translate_c?depth=1&hl=en&prev=/search%3Fq%3Dnissan%2Bhistory%2Bjp%26safe%3Doff%26client%3Dopera%26hs%3Db4W%26hl%3Den%26channel%3Dsuggest%26biw%3D2560%26bih%3D1284&rurl=translate.google.com.au&sl=ja&u=http://history.nissan.co.jp/SKYLINE/R34/9805/SPEC/frame2d.html&usg=ALkJrhi1Hak3JHxDbRjCB-upgf_C8BIsvg

Edit: Series 2 page on the same website doesn't state risers with the xenons, not sure if just not mentioned out actually removed from the car. Have seen series 2 with the switch though

Edited by fusion07

Is there any chance you can just buy a pair of 4300k or lower globes, so they look more yellow/halogen like and HOPEFULLY it can pass? haha

How will testers actually test whether the light is HID or not? Because the factory ballast is hidden underneath the headlight...


i thought it was pretty obvious for a qualified person to be able to tell if it's HID or not. if you look behind the lights in the engine bay its totally different

The ballasts are also easily visible if you look from the middle where the Grille is towards the bottom of the lights, sticking out quite clearly

Is there any chance you can just buy a pair of 4300k or lower globes, so they look more yellow/halogen like and HOPEFULLY it can pass? haha

How will testers actually test whether the light is HID or not? Because the factory ballast is hidden underneath the headlight...

Philips 85122 is 4300K, be careful of ebay ones, most are fake. You can get 4300K from ebay as well for about $20 each. Alignment is usually slightly out on those ebay ones. The 85122 gave a better cutoff and slightly better spread on my headlights (not OEM, Morimoto projectors).\

It's pretty easy to tell whether your headlights are HID or not. Colour, warm up, sharp cut-off, blue cut-off line (which is what dumb arses running 8,000-10,000K bulbs want in their halogen reflectors).

Ahhh... Guess that wouldn't work then....

When I first bought my car (car was complied back in 2004 when compliance was strict), my headlights were converted to H1, ballast taken out, globe cover has a hole drilled to wire in the H1. But i eventually bought a pair of stock Xenon headlights. I think nowadays, you'd have to be real unlucky to get done for HID's... Unless you have some blinding 10000k purple HID's lol

I've seen way to many blinding blue/purple headlights on the roads to think the police aren't doing much. A factory set will hardly get picked on, unless the officer didn't really like you or your car. I've been through a couple of RBTs with my HIDs and they didn't even give it a second look (4300K, projectors, properly aligned so it doesn't hit them in the face like half the cars in Sydney).

Nothing beats OEM HIDs though. Takes like 5 seconds to warm up, and you get a nice white, non-ricer light with even spread and a nice cut-off.

I love my bi-xenons though.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
    • You haven't driven many modern cars then have you? Most of them have sfa steering feel with their stupid electric bullshit steering systems.
×
×
  • Create New...