Jump to content
SAU Community

Recommended Posts

Hi There,

I got a nissan 350gt (v35). Recently I took it for a service and the mechanic came back with the following feedback:

1. Auto transmission oil discoloured brown. (I believe its meant to be red?)

2. Both front lower rear link arms inner bushes worn - Large Bush on subframe

3. Slight power steering oil leak from Pinion seal

Now i'm wondering how severe this is and how soon should i get it fixed. And does anyone know how much it would roughly cost?

Any comments are appreciated.

Link to comment
https://www.sau.com.au/forums/topic/413662-service-report-serious-or-not/
Share on other sites

none of that is imminently life threatening - to you or the car.

1. trans fluid will discolour naturally - highly likely it's never been changed. for peace of mind its always good to do all the fluids when you get a new car. trans fluid isn't cheap though, budget a few hundred for a full flush.

2. trailing arm bushes - only worry about it if it starts to make any large knocking noises on acceleration or deceleration - also watch your rear tyre wear. beyond that - just put it on the list of 'to do' when you can afford.

3. p/s leak - depends on how much fluid it's dropping. check under where you park. if you don't give a sh1t about your driveway then it's really only a case of keeping the reservoir topped up. If you let the levels get too low you'll stuff the p/s pump. If it gets to the point where it's coming out faster than you're putting it in - that's probably when you need to look at getting your rack replaced.

all pretty much as you'd expect of car of this age - wouldn't stress.

only thing i'd point out is that if you've just bought the car recently - items 2 and 3 are road worthy items - if you bought it froma dealer i'd be asking for a 'please explain'.

Are you happy with the mechanic you've used? if you are, why not save the money used getting a second opinion on fixing the stuff listed.

If the trans oil is getting old and brown it is old and brown, change it. And as smokey said if your power steering fluid leak and trailing arm bush wear are manageable then you can get away with still driving your car. Just plan to do them later on.

@SMOKEYC34: thanks mate.

yup had it for about 3 years now. Do you think its good idea to have another mechanic check it out n give me a second opinion?

No need for a 2nd opinion if the mechanic is trustworthy as Nick mentioned.

How many Kms are you doing/yr? And how many Kms has your car done in total?

These answers will indicate whether or not you should attend to the above at the next major service or even before.

def get a full flush on the trans if its cactus, did this at home in my driveway on my R32 gtst with some simple handtools and two car ramps, piece of piss

There is a difference between a transmission flush and a dropping/filling the fluid.

Trans flush gets all the old fluid out of the torque converter - needs to be done with the right equipment.

If you plan on doing the auto trans by yourself you can still get the old fluid out of the torque converter however when filling the fluid up you have to get it exactly 100% right when filling it, it cant be just under or just over

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • As discussed in the previous post, the bushes in the 110 needed replacing. I took this opportunity to replace the castor bushes, the front lower control arm, lower the car and get the alignment dialled in with new tyres. I took it down to Alignment Motorsports on the GC to get this work done and also get more out of the Shockworks as I felt like I wasn't getting the full use out of them.  To cut a very long story short, it ended up being the case the passenger side castor arm wouldn't accept the brand new bush as the sleeve had worn badly enough to the point you could push the new bush in by hand and completely through. Trying a pair of TRD bushes didn't fix the issue either (I had originally gone with Hardrace bushes). We needed to urgently source another castor arm, and thankfully this was sourced and the guys at the shop worked on my car until 7pm on a Saturday to get everything done. The car rides a lot nicer now with the suspension dialled in properly. Lowered the car a little as well to suit the lower profile front tyres, and just bring the car down generally. Eternally thankful for the guys down at the shop to get the car sorted, we both pulled big favours from our contacts to get it done on the Saturday.  Also plugged in the new Stedi foglights into the S15, and even from a quick test in the garage I'm keen to see how they look out on the road. I had some concerns about the length of the LED body and whether it'd fit in the foglight housing but it's fine.  I've got a small window coming up next month where I'll likely get a little paint work done on the 110 to remove the rear wing, add a boot wing and roof wing, get the side skirt fixed up and colour match the little panel on the tail lights so that I can install some badges that I've kept in storage. I'm also tempted to put in a new pair of headlights on the 110.  Until then, here's some more pictures from Easter this year. 
    • I would put a fuel pressure gauge between the filter and the fuel rail, see if it's maintaining good fuel pressure at idle going up to the point when it stalls. Do you see any strange behavior in commanded fuel leading up to the point when it stalls? You might have to start going through the service manual and doing a long list of sensor tests if it's not the fuel system for whatever reason.
    • Hi,  Just joined the forum so I could share my "fix" of this problem. Might be of use to someone. Had the same hunting at idle issue on my V36 with VQ35HR engine after swapping the engine because the original one got overheated.  While changing the engine I made the mistake of cleaning the throttle bodies and tried all the tricks i could find to do a throttle relearn with no luck. Gave in and took it to a shop and they couldn't sort it. Then took it to my local Nissan dealership and they couldn't get it to idle properly. They said I'd need to replace the throttle bodies and the ecu probably costing more than the car is worth. So I had the idea of replacing the carbon I cleaned out with a thin layer of super glue and it's back to normal idle now. Bit rough but saved the car from the wreckers 🤣
    • After my last update, I went ahead with cleaning and restoring the entire fuel system. This included removing the tank and cleaning it with the Beyond Balistics solution, power washing it multiple times, drying it thoroughly, rinsing with IPA, drying again with heat gun and compressed air. Also, cleaning out the lines, fuel rail, and replacing the fuel pump with an OEM-style one. During the cleaning process, I replaced several hoses - including the breather hose on the fuel tank, which turned out to be the cause of the earlier fuel leak. This is what the old fuel filter looked like: Fuel tank before cleaning: Dirty Fuel Tank.mp4   Fuel tank after cleaning (some staining remains): Clean Fuel Tank.mp4 Both the OEM 270cc and new DeatschWerks 550cc injectors were cleaned professionally by a shop. Before reassembling everything, I tested the fuel flow by running the pump output into a container at the fuel filter location - flow looked good. I then fitted the new fuel filter and reassembled the rest of the system. Fuel Flow Test.mp4 Test 1 - 550cc injectors Ran the new fuel pump with its supplied diagonal strainer (different from OEM’s flat strainer) and my 550cc injectors using the same resized-injector map I had successfully used before. At first, it idled roughly and stalled when I applied throttle. Checked the spark plugs and found that they were fouled with carbon (likely from the earlier overly rich running when the injectors were clogged). After cleaning the plugs, the car started fine. However, it would only idle for 30–60 seconds before stalling, and while driving it would feel like a “fuel cut” after a few seconds - though it wouldn’t fully stall. Test 2 – Strainer swap Suspecting the diagonal strainer might not be reaching the tank bottom, I swapped it for the original flat strainer and filled the tank with ~45L of fuel. The issue persisted exactly the same. Test 3 – OEM injectors To eliminate tuning variables, I reinstalled the OEM 270cc injectors and reverted to the original map. Cleaned the spark plugs again just in-case. The stalling and “fuel cut” still remained.   At this stage, I suspect an intermittent power or connection fault at the fuel pump hanger, caused during the cleaning process. This has led me to look into getting Frenchy’s fuel hanger and replacing the unit entirely. TL;DR: Cleaned and restored the fuel system (tank, lines, rail, pump). Tested 550cc injectors with the same resized-injector map as before, but the car stalls at idle and experiences what feels like “fuel cut” after a few seconds of driving. Swapped back to OEM injectors with original map to rule out tuning, but the issue persists. Now suspecting an intermittent power or connection fault at the fuel pump hanger, possibly cause by the cleaning process.  
×
×
  • Create New...