Jump to content
SAU Community

Recommended Posts

mate this feller is the go if u want any rb25/26 rebuilt I just got mine done for a absolutely amazing price I highly recommend this feller over any rebuilder in the western suburbs of sydney I won't go no other builder !!! He has done the job and he done it perfect :) I'd be taken our engines to him and him only

Link to comment
https://www.sau.com.au/forums/topic/414112-st-marys-engines-nsw/
Share on other sites

Mate it's a fully forged build all brand new brand new turbos with steel wheel obviously new fuel pump and brand new injectors yes it's will be getting run in on the dyno had experience with lots of rebuilds

Using new parts is not evidence of a good build. Bad engine builders also use new parts. He may be great engine builder, or the opposite, but if you cant mount an explanation of why you believe he's good, you're just some guy on the Internet saying stuff.

I actually know the guys at St Mary's Engines well. Geoff & Brett mainly specialise is Mopar stuff but yes they are very good at what they do, very down to earth people.

They know how to build engines. Any of the Mopar days you'll see them down at the drags.

Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • 9" wheels are a little too wide for a RWD 32. They can fit. People have put R33 GTR wheels on 32s for years and years. But they are a very tight squeeze. This has been known for about 30 years. As I said - there is no difference between a 17 and an 18 in terms of what will fit. The rolling diameter needs to stay about the same as stock - not very much larger. If you increase that, you will start to have problems. If you increae rolling diamater at the same time as yo increase width, you will have problems earlier. as 9" wheels are pushing the boundaries already, you would need to be careful with tyre choice. I would put 8.5s on the front of mine, but would expect problems with 9s.
    • post up screen shots of your injector tables
    • Diagnostic flow for a code 21 says check signal at the ECU pins, on a voltmeter of some kind it should read 0.1V at idle, 0.12V cranking, 0.15-0.25V at 2000 rpm. Check each coil such that +1, -3 is infinite or very high resistance, -3, +2 should do the same. (-1, +3), (+3, -2), (+1, -2), and (-1, +2) should all be somewhere between 0 ohms and high resistance. If you trace the path from the coil pin all the way back to the ECU in the diagram the resistance you measure at the coil vs connected to the harness should be pretty much the same. 
    • I have an elite 2500 running an adapter harness on an rb25de neo r34. I took the butterfly out and removed all that junk. But I also went Plus+t at the same time. The butterfly thing works in reverse to the boost solenoid on the Gtt if that makes sense
    • yeh they are 235/45/17 up front and 255/40/17 in the rears. I still didn't get my answer if i can fit a 18x9 up front. I want to get 4 of this and see if they will fit before committing as they didn't see an 18x8 as an option but there is a 18x9.5 also.   Enkei RS05-RR 18x9 35mm ET 5x114.3 75.0 Bore Matte Gunmetal Wheel
×
×
  • Create New...