Jump to content
SAU Community

Recommended Posts

  • Replies 146
  • Created
  • Last Reply

Top Posters In This Topic

Also want to know what track day.....double please

The way its going i may have to organise 2 lol

Its NOT done yet but i will be organising one, seems mostly skylines with a side of Evo and Silvia

Just happend to find a park near this car show thingy. Shocked me alot seriously

Haha same when they called Best Overall GTST :P

lets us know matt, super keen for some time behind the wheel.

Np at all mate, will let you know how i go!

You both should've been up for the "Leave the Noob Stranded Award".

Oooh... and if there's a trackday a comin' I would KILL to see Grumblebee Fangin'.

I might even consider slowly pinning lines around some curves.

Edited by Not a Pulsar

You both should've been up for the "Leave the Noob Stranded Award".

Haha i made him feel real bad for ya too! :P You poor bastard lol

Thats why it DOESNT pay to help others lol.... Well except in Mani's case as he pays with sexual favours :woot:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Also build this EH ute with 370z motor and gearbox with a couple of turbos just for fun.  
    • Got the passenger door on plus the master cylinder and booster. Loaded up to take it home. At home, the colour changes a lot in the light.
    • Nothing cheap, but I have seen the AC Hydraulic DK13HLQ which is pretty close to what you're asking for. The problem is the hydraulic cylinder mandates that the back of the jack be a certain height and Skylines have fairly deep inset floor jack points. A more certain and cheap option is to get some nominal 2x10 inch lumber boards and have one board be 1.5 feet, the other board 3 feet. Glue it all together with lots of clamps to maintain pressure. Make two of these. The ramp suggested above is a good idea, it takes quite a bit of clutch slip to get over each of the boards. I only need the first ~1.5 inches for my low profile jack on a standard ride height car but a lowered car you want to go up to the full ~3-3.5 inches. Paint it or store indoors if you want it to last.
    • Ok. And Nistune? I read (here too) mainly on Stagea threads that it can by "turn off" with Nistune. But they say they still had the sensor plug in. Next week iam going to the Nistune(and other ECUs) tuner so i can finally make it work. I drove the car home and apart from the cut it drove great. No misfire no smoke no hesitation or rough start...so hoping it is this sensor that is missing  
    • I just stack 2 pieces of 200x50 timber on top of each other. Total length about 900mm, with the top one being a little shorter and both having a 45° angle cut on them to make the front edge a bit of a ramp. Put these in front of each front wheel, drive up on them, throw the trolley jack under. Takes 1 minute. Scissor jacks can eat a bowl of dicks. I never use on under my car unless desperate.
×
×
  • Create New...