Jump to content
SAU Community

Out Of The Game!

GravyGarage
 Share

Recommended Posts

GravyGarage Community Regular

GravyGarage

Posted
Posted

Hey guys heres whats left of my shitbox.

Boot $100

Standard rear bar with extensions $100

Series 3 tail lights $300

Series 1 tail lights $100

Rear seats $50

Tail shaft rb20det $150

Dash cluster 135290kms $50

Dash (4 gauge holes in passenger side) $50

Dash matt $100

Carpet $50

Front gaurds 2 x rh, 1 x lh $200 for the lot

Air con condenser, pump and lines $30

Fiberglass front bar needs repair $50

Also have complete trim minus the usual lh air vent. Let me know what you want and can go from there.

If there is something else you are chasing let me know have heaps of spares. Located on the Gold Coast.

Not holding parts. First in best dressed!

Thanks,

Joel

0409706186

Link to comment
https://www.sau.com.au/forums/topic/414838-out-of-the-game/
Share on other sites
Cefiro Panch Apprentice

Cefiro Panch

Posted
Posted (edited)

Centre console and stereo surround are gone. Aswell as carpet...

Will try and get a pic of the dash this weekend. Really not motivated to pull it out....

Ha I know, pain in the ass alright!!

Just mine got the horrible dash bubble and all the plastic is cracking!!

I got it flocked like a rally car but that started to peel aswell!!

Edited by Cefiro Panch
Link to comment
https://www.sau.com.au/forums/topic/414838-out-of-the-game/#findComment-6658024
Share on other sites
GravyGarage Community Regular

GravyGarage

Posted
  • Author
Posted (edited)

List updated

Boot $100 $80

Standard rear bar with extensions $100

Series 3 tail lights $300 $250

Series 1 tail lights $100 $80

Rear seats $50 $30

Tail shaft rb20det $150 $100

Dash cluster 135290kms $50

Dash mat $100 $70

Carpet $50

Front gaurds 2 x rh, 1 x lh $200 for the lot

Air con condenser, pump and lines $30

Fiberglass front bar needs repair $50

Have sold parts of the trim. Let me know what you want and can go from there.

If there is something else you are chasing let me know have heaps of spares. Located on the Gold Coast.

Not holding parts. First in best dressed!

Thanks,

Joel

0409706186

No handbrake cables. May have heater suround will let you know.

Edited by GravyGarage
Link to comment
https://www.sau.com.au/forums/topic/414838-out-of-the-game/#findComment-6661308
Share on other sites
GravyGarage Community Regular

GravyGarage

Posted
  • Author
Posted

Yeah all still here bar the dash mat. Have been busy so havnt been proactive with pulling bits off and selling them.

Other project is done so will have some time again!

Link to comment
https://www.sau.com.au/forums/topic/414838-out-of-the-game/#findComment-6670380
Share on other sites
  • 2 weeks later...
GravyGarage Community Regular

GravyGarage

Posted
  • Author
Posted

Dash mat : Sold

S3 taillights : Sold pending payment

Front guards : Sold

More trim sold, let me know what you need!

Still have:

Boot $100 $80

Series 1 tail lights $100 $80

Rear seats $50 $30

Tail shaft rb20det $150 $100

Air con condenser, pump and lines $30

Also have:

Engine loom to suit rb25 - $250ono (Usually like $400 to get modded)

Fuel pump cradle - $70

Fuel tank - $50

Climate control unit - $50

Rear reo - $50

Parcel shelf - $30

Link to comment
https://www.sau.com.au/forums/topic/414838-out-of-the-game/#findComment-6682526
Share on other sites
GravyGarage Community Regular

GravyGarage

Posted
  • Author
Posted

Still have:

Boot $100 $80

Series 1 tail lights $100 $80

Rear seats $50 $30

Tail shaft rb20det $150 $100

Air con condenser, pump and lines $30

Engine loom to suit rb25 - $250ono (Usually like $400 to get modded)

Fuel pump cradle - $70

Fuel tank - $50

Climate control unit - $50

Rear reo - $50

Parcel shelf - $30

And the shell if anyone wants the glass ect take it away!

Link to comment
https://www.sau.com.au/forums/topic/414838-out-of-the-game/#findComment-6687266
Share on other sites
  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • drifter17a
      R34 gtt rb25det neo timing belt kit

      By drifter17a · Posted

      I am being real ocd and do not want to make amy mistakes so appreciate all help provided. I am overly cautious so asking for opinion even if i know the answer   few questions,   1.re tensioner, should spring be greased lightly?    2.tensioner has two washers , one pressure washer and other has recessed/ seat. I am going to put the recessed one facing tensioner where edges are cut out and pressure washer on top   3. my car has custom triger kit sold few years ago by guy who initially built the engine. I moved the crank gear and it moved in and out easy, only way to remove belt is to slide the crankshaft gear forward which I did. I have seen these being very tough to move , anything to do with my woodruff key?   it has a crank sensor shown in purple which I assume reads from the 12 teeth position mounted to the crankcase gear   4. timing belt doesn’t have arrow stating front or back just a arrow which I think is direction of rotation . Do you agree?   5.i figured out why my crankcase cover was worn as there was no washer installed over the crankcase cover before the harmonic balancer was put in place. It is missing, anyone knows the part number? It looks like this https://justjap.com/products/genuine-nissan-crankshaft-timing-gear-rear-plate-washer-nissan-s13-ca18-a31-r32-rb20-r33-r34-c33-c34-c35-rb25?currency=USD   https://tinypic.host/image/IMG-4535.382Zy2 https://tinypic.host/image/IMG-4537.382dSz https://tinypic.host/image/IMG-4534.382q4U  
    • TurboTapin
      New fix for low tyre pressure from bmw

      By TurboTapin · Posted

      CTIS (Central Tire Inflation System) has existed since the 80's. I'm looking into buying a Hummer H1 and they generally included it. 
    • Kinkstaah
      Mistakes were made, my R34 Story

      By Kinkstaah · Posted

      My idle is set at 950rpm though - Moving the timing around 20 degrees is not really what I'd call a calm idle. That said... neither is chop, by definition. The LS ECU likes to adjust timing to hold idle as opposed to air. It'd work, but generally speaking there'd be a discrepancy in the base idle and the IACV would want to move the timing around anyway to maintain said idle. I think I'm just going to keep the timing steady anyway. Preserve my engine mounts.  My aircon is now officially regassed. As the guy was reversing I noticed my reverse lights do not operate, along with my reverse cam. This is a bit distressing, because 100% of guides talk about which wire to connect to backup cams as "the goes with the [other color] wire". Often when doing conversions. Unfortunately the R34 colour wires aren't documented Unfortunately I had a T56 Magnum gearbox with it's reverse switch, which also isn't documented. Unfortunately there's definitely not documentation for people with both of these in the one car. Unfortunately I forgot. After many hours of this, I have a reverse cam and reverse lights again. The wire going through the trans tunnel to the reverse switch had broken. Upon inspection, it looks like this one wire had about 7 spade terminals and extensions in it.. for reasons I cannot possibly comprehend. I also spent the 750 hours required to clean up the wiring behind my head unit which now looks like this: This is a monumental improvement relative to what used to be there WRT triple gauges, head unit, traction control, wideband controller, and whatever the f**k OEM stuff still exists there in various states of connectivity/needed. Next step is to check in at the Exhaust shop to see/confirm how much clearance I have, to decide what mid mufflers or 'resonators' (which are just straight through, narrower mufflers) I can add and hopefully cut out a lot of exhaust leaks, pinhole, v-band or otherwise. But first step will be to 'take a look' before the next step.
    • Dose Pipe Sutututu
      Another little story of weird shit happening

      By Dose Pipe Sutututu · Posted

      Fark the AFM card and Nistune, Haltech Nexus S3, DBW, cruise control, flex fuel, dis dat.  
    • MBS206
      R34 gtt rb25det neo timing belt kit

      By MBS206 · Posted

      It's most likely the bolt/bush where the cover bolts back wore and allowed cover to move forward.
×
×
  • Create New...