Jump to content
SAU Community

Recommended Posts

I need to do my drivers door too. Gonna try undoing the bolts on the hinges, lift and tighten.

I have a Forklift at work if you wanna go Industrial. :D

oh and I'm licensed to lift.

yea I have forklifts at work as well!

I do need to get my licence for it, the OHNS guys hate it!

if that's not industrial enough we can also use a bobcat for it, or if your after an overkill solution a 16 ton excavator will do the job ;)

a trolley jack will do the job with a block of soft wood between the to...

2nd hand hinges, or

get a hoist arm, or

fork lift to "gently" lift it

:yes:

Your welcome if your game to use my trolley jack :cheers:

I need to do my drivers door too. Gonna try undoing the bolts on the hinges, lift and tighten.

I have a Forklift at work if you wanna go Industrial. :D

oh and I'm licensed to lift.

Awesome :D

Rob we should both buy some and get it done together :touch:

Even Sin could come do it and then :3some:

I need to do my drivers door too. Gonna try undoing the bolts on the hinges, lift and tighten.

I have a Forklift at work if you wanna go Industrial. :D

oh and I'm licensed to lift.

12p please

I just noticed that, its got like 500kw, of cause it has been thrashed haha !!!

well I snapped a rca head thingo on my sub when I was putting a case of coke in... so I spent about an hour in traffic on Canberra ave trying to get to jcar and finally got one.. it cost more in fuel then it did for the plug... and almost got taken out by a f**kking taxi, if the paint was any thicker id be stuffed... those assholes need to learn to drive!!

I repaied a cylinder head yesterday for the 300 dollar shit box.

Total cost 32 bucks for a vrs kit.

Going to be the most awesome car for the money.. .after I get the brakes working. Re paint the whole thing and find out if the trans and diff is ok.....

Then finish the veeeeee eeeiiigghhhttt and give it some spray.

11 sec cheap car ftmfw

Drove Mum & Dad over here to Orange.

They are very impressed with the 33s comfort and road noise Quietness. Much better than my Uncles Mitsubishi Outlander apparently.

Flogged it from 20km to 120km/hr and they loved it. :woot:

4WD light came on after 10mins of driving last night. Will need to check it out - Fluid or Speed sensor I'm guessing.

Have to take a moulded sub box out to get to the reservoir - never fun (a dozen allen key bolts and 3 self tapers)

Will change bonnet over and get rid of a rattle around cluster - cluster will have to come out.

4WD light came on after 10mins of driving last night. Will need to check it out - Fluid or Speed sensor I'm guessing.

Have to take a moulded sub box out to get to the reservoir - never fun (a dozen allen key bolts and 3 self tapers)

Will change bonnet over and get rid of a rattle around cluster - cluster will have to come out.

Hope you'll be sporting the R34 GTR wing still - looks pretty awesome.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • For race cars, this is one part where I find having the roll cage bar having gone through a hole in the floor better than the build it up on a ledge inside... The Merc I help on, the main hoop ends are marked on the car, and the jack is marked... Jack goes under a few inches and lifts one whole side of the car up... Removes that fight for long slim jacks for race car duties!   My biggest issue for the daily drivers I work on, is my jacks don't go high enough. The jacks start out on a few blocks, jack it up, then start a second jack under it on more blocks, and then I can get an axle stand under it. My axle stands are presently in use, and are nearly fully extended. The car is sitting with barely more than a cm of clearance to get the wheel off the studs! Sarah's Kluger is the same, as it has an ungodly amount of droop available in the suspension and a distinct lack of good jacking points!
    • Happy? Yep, my to do list is getting shorter and shorter. Either this light approaching is the end of the tunnel, or I'm about to be hit by a train... Ha ha ha   Also, Duncan isn't that far out of town that you need to make a multi day drive out of it. 😛
    • Sorry I meant that we are building the EH for a client.
    • LOL, when one "money pit" is never enough Noice, and excellent work mate
    • I have more than enough digging, laying blocks, moving gravel, airrating, feeding and top soiling the grass, and setting up the veggie gardens growing some seedlings,  and then removing all the unused rock to keep me busy for the next few months at least,  hopefully the rain stops soon so I can get a few hours in this arvo, but, before that Sunday is washing day, is every body happy, you bet your life we are Nice country road day drives are a day off whenever I'm muscle sore from all the landscaping at the moment, but, more epic multiple day drives will start once the majority of the big jobs outside are completed
×
×
  • Create New...