Jump to content
SAU Community

Recommended Posts

I need to do my drivers door too. Gonna try undoing the bolts on the hinges, lift and tighten.

I have a Forklift at work if you wanna go Industrial. :D

oh and I'm licensed to lift.

yea I have forklifts at work as well!

I do need to get my licence for it, the OHNS guys hate it!

if that's not industrial enough we can also use a bobcat for it, or if your after an overkill solution a 16 ton excavator will do the job ;)

a trolley jack will do the job with a block of soft wood between the to...

2nd hand hinges, or

get a hoist arm, or

fork lift to "gently" lift it

:yes:

Your welcome if your game to use my trolley jack :cheers:

I need to do my drivers door too. Gonna try undoing the bolts on the hinges, lift and tighten.

I have a Forklift at work if you wanna go Industrial. :D

oh and I'm licensed to lift.

Awesome :D

Rob we should both buy some and get it done together :touch:

Even Sin could come do it and then :3some:

I need to do my drivers door too. Gonna try undoing the bolts on the hinges, lift and tighten.

I have a Forklift at work if you wanna go Industrial. :D

oh and I'm licensed to lift.

12p please

I just noticed that, its got like 500kw, of cause it has been thrashed haha !!!

well I snapped a rca head thingo on my sub when I was putting a case of coke in... so I spent about an hour in traffic on Canberra ave trying to get to jcar and finally got one.. it cost more in fuel then it did for the plug... and almost got taken out by a f**kking taxi, if the paint was any thicker id be stuffed... those assholes need to learn to drive!!

I repaied a cylinder head yesterday for the 300 dollar shit box.

Total cost 32 bucks for a vrs kit.

Going to be the most awesome car for the money.. .after I get the brakes working. Re paint the whole thing and find out if the trans and diff is ok.....

Then finish the veeeeee eeeiiigghhhttt and give it some spray.

11 sec cheap car ftmfw

Drove Mum & Dad over here to Orange.

They are very impressed with the 33s comfort and road noise Quietness. Much better than my Uncles Mitsubishi Outlander apparently.

Flogged it from 20km to 120km/hr and they loved it. :woot:

4WD light came on after 10mins of driving last night. Will need to check it out - Fluid or Speed sensor I'm guessing.

Have to take a moulded sub box out to get to the reservoir - never fun (a dozen allen key bolts and 3 self tapers)

Will change bonnet over and get rid of a rattle around cluster - cluster will have to come out.

4WD light came on after 10mins of driving last night. Will need to check it out - Fluid or Speed sensor I'm guessing.

Have to take a moulded sub box out to get to the reservoir - never fun (a dozen allen key bolts and 3 self tapers)

Will change bonnet over and get rid of a rattle around cluster - cluster will have to come out.

Hope you'll be sporting the R34 GTR wing still - looks pretty awesome.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Have a vb in honour of the car comming back
    • It was a great, but typical track day, and some VB was ingested at the night time debrief 🤪
    • And so, to round this out, I couldn't be happier to confirm @MBS206 has decided to buy the car. He drove down from sunny QLD with a trailer last week and it is off to its new home today. I'll let Matt confirm on next steps but I understand broadly that the plan is to leave it pretty much as is, and just get some quality wheel time with a nicely balanced car that is pretty much track ready. There are a few a jobs still to be done first but nothing too major and I think its a very smart buy Dinner last night at the Paragon with a round of VBs (mostly) for Neil
    • Well, 50 pages and the end of a chapter for this car. We took it out for a shakedown at Wakie yesterday, and everything went well. There were a couple of niggles: - Oil cooler fitting leak - tightened, cleaned, stopped leaking - Radiator cap overflow fitting was leaking....Mark called it, the overflow fitting was threaded in and not tight....tightened, tested and held pressure - Small oil leak at the rear of the block, probably the turbo oil feed - too hot to get at it comfortably but probably just needs to be nipped up - leak at the driver's side rear brake line where it meets the hardline. Fitting wasn't loose, so Matt backed it off and back on, no further leaks - there's also a leak somewhere on the top of the fuel tank, maybe that cross over fuel line - that was has been left to fix when its on a hoist Otherwise than those niggles the car went great, turned great and stopped great so it was a very successful day out. I'm always really nervous when a car first hits the track after a long break, especially with a brand new engine as well but it was great. VID-20251011-WA0007.mp4  Big thanks to @The Bogan who dropped by and helped out, @MBS206 and my nephew Lachlan the apprentice.  Neil's wife Mel also surprised the hell out of all of us by dropping by; she's up in Tamworth these days but was travelling to Melbourne so had plausible deniability for turning up at the garage, it was great to see her but also obviously a bit sad all round.
    • Skyline R33 Series 2 sedan tail lights in excellent condition. These are becoming harder to find, especially in this state.    BOTH SETS ARE IN FANTASTIC CONDITION (REFER TO PHOTOS)    ✅ No broken covers or cracks ✅ Lenses are in flawless condition ✅ All rear mounting lugs intact ✅ Comes complete as pictured ✅ Perfect for restoration, replacement, or upgrade   These lights are ready to go, no surprises just quality OEM parts.   These are definitely one of the better sets we have seen in a while. With minimal wear and tear they will come as you see. Bear in mind they are not brand new they are almost 30 years old now. To find them in this condition isn’t easy they can only be obtained on the second hand market.   Australia Wide Postage Available At Buyers Expense. Silver Set:$850 Grey Set:$850 PM Me for purchase or any other questions  IMG_2166.dng IMG_2165.dng IMG_2172.dng IMG_2173.dng IMG_2174.dng IMG_2179.dng IMG_2180.dng IMG_2260.dng IMG_2258.dng IMG_2259.dng IMG_2261.dng IMG_2266.dng IMG_2273.dng IMG_2274.dng IMG_2276.dng
×
×
  • Create New...