Jump to content
SAU Community

Recommended Posts

Do ceva have a height limit on how low a car can be? Looking at shipping a car from perth to melb and all the companies I've found so far all say the cars have to be above 140mm.

Nope, i remember seeing an SLS AMG that got sent through them and they are effing low, they just add ramps, and make sure you get heaps of pics before they load the car up so you know if(unlikely) any damage is made

there are different options.

if you go for standered transport then the requirement is for the cars lowest point to be 140mm.

if you go for the race and prestige option then no height requirement cause as juliette mentioned they use hydrolyic lifts etc but you do pay through the arse for that.

well if your determined to get a tow truck

most of the members here use:

Jack from Citywide towing.. 0419 877 437

He has been a long term member owning a bunch of imports and knows how to look after them.

that said don't get a shock when he quotes.

this will be thousands, remember it's at least 2 days prob 3 days of just driving, fuel, food and the rest.

remember he looks after us so you best be nice as well. (plus he big and scary..just kidding jack)

actually I could be wrong, if you found one that had a one way trip the other direction then that would be very fair.

else

melb - syd 10-12 hours driving.

add in 1-2 hours on each end for load/unload.

looking 22-30 hours non stop

800$ = noway I would do that.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • If you mean the alarm immobiliser; theyre internal to the alarm itself which makes that difficult; I couldnt even see where he put it; its not in the same place as last time; but with all black wiring it might be very challenging to trace  I had someone turn the key for me as I know it only primes for a couple of seconds As my post above; I am getting no voltage to the pump at all; but I am testing continuity of the power line (SB) from the pump plug to the relay fine. As well as the negative from the pump plug to a 12V constant.    Yeah; he blammed the no start on a bad battery; said I needed to get a new battery and it'll start. Turns out the battery drained because the tail lights had been on for half the day during the install (the rubber cushion on the brake switch gave out while he was testing it as I have a picture of the car from that morning with the tail lights off..i've replaced that). The battery was turning over the engine just fine for a long time; but got low since lights were draining it so it was too low to test a start after he finished. I bought a new one on his advice...$250 wasted. My original battery charged up just fine and is healthy.    It was running perfectly fine when I messed up the old alarm (programmed out the remotes). He couldnt start it after removing the old alarm; my assumption is that when he unhooked it; he didnt bridge the circuit back when trying to start it. Its always been perfectly fine. The ECU swap and pump were 2 years ago. It's never missed a beat in that time. 
    • This is a big issue for me without the diff. I just have zero drive from the passenger side when drivers side has no traction. Bec's parents place has a crazy steep driveway with odd camber and I have never been able to get up. My bro-in-law's 130i with an (unknown brand) LSD gets up fine as does their dad's Hiace. My car stays at the bottom. We have other odd camber roads around here as we're elevated a bit and if it's raining I can get totally stuck around some hairpins. 
    • Yeah, I am super excited for this.
    • Was the car running before he touched the car?
×
×
  • Create New...