Jump to content
SAU Community

1993 R33 M-Spec Wrecking All Parts

kriddy311dft32

By kriddy311dft32,
in Classifieds

 Share

Recommended Posts

kriddy311dft32 Rookie

kriddy311dft32

Posted
Posted

Rb25 engine $1000 vgc, Rb25 manual gearbox $1200 vgc,Wiring looms $500,4x17inch nismo rims$250 4x18inch 20spoke rims$500,T.Smart BOV$100,T.Smart low high B.Controller$100,Radiator 32&33 $75each,Factory air purifier(4 rear parcel shelf)with remote$50,Sunroof$50,Ignition 2xKeys&all locks$200, A.Market intercooler&piping$80,boot lining&carpet$100,carpet$50,roof lining$50,altenator$50,starter motor$50,door rubbers$20,GTR boot&spoiler$250,dash$300,centre console$75,tail lights$100,both back door cards$100,manual&auto 32&33 computers$40each,fusebox$10,door trims$50,driver&passenger windows$100,front&rear windows$150,backseat$100,headlights$80both.

Link to comment
https://www.sau.com.au/forums/topic/419270-1993-r33-m-spec-wrecking-all-parts/
Share on other sites
Captain Natro Grand Master

Captain Natro

Posted
Posted

too expensive for you pal.

5 stud.

Quiet Paul!

And they are multifit so they may fit/will do 5 stud swap in time lol. Who needs brakes anyway, they only slow you down right lol

  • 2 weeks later...
  • 2 months later...
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Ozdavroz
      WTAC 2025

      By Ozdavroz · Posted

      Yeah good luck out there! Will be good to see a mighty GTST going harder than the GTRs
    • bcozican
      WTAC 2025

      By bcozican · Posted

      i will be there 😁
    • patrickxdf12
      Squeaking clutch/throw out bearing

      By patrickxdf12 · Posted

      Hello!  i just finished manual swaping my r34 skyline with a r33 rb20de box(RB71C)box  When the car is running it squeaks crazy loud and it was smoking from the gearbox area. The gearbox is fine it was tested. The clutch slave cylinder seems like it doesn't fully releases the clutch. I want to ask if this noise is from the throw out bearing or could it be the clutch assembly or disk att.xFliq87Gzw6kImKBVqDebXkj0fBqymk0JaYeP3_3SlM.mp4
    • RP1421
      S15 Spec R

      By RP1421 · Posted

      A few small updates since the previous post and lessons. I decided to do a little interior light upgrade on the 110. I quite like the iilumo items, even if they're a bit of a premium over other brands. You'll also note the Stedi Fogs, that will go into the S15 fog lights as I needed to match the bulbs since I got the new ones earlier. I hope they fit as the body is quite a bit longer than your normal bulb.  Annoyingly, I managed to trip the fuse, which normally wouldn't be an issue until I located the fuse. I can't say I've ever come across this. I had lucked out that someone nearby had a spare, but oddly enough Toyota dealerships seem to keep this in stock. I ordered some to keep in my stash and as luck would have it, someone else nearby tripped the same fuse so I passed on the favour.  I also did a little service on the 110 ahead of some additional work coming up. It's been annoying that Goleby's stopped carrying this particular HKS filter for the 110, so now I need to keep them on order from Japan. I also took the opportunity to install a bash plate and number plate riser. The plate riser is such a cheap but nice fix to help really tidy up the car. I'm tempted to now also replace my headlights, on this car. Both items were from Project Aero.    I also needed to replace the rear tyres on the 110, and after trying to get it aligned learnt that I need to replace some bushes in the front end, so that's next.  Closing out this update with a nicer picture as always! 
    • Murray_Calavera
      WTAC 2025

      By Murray_Calavera · Posted

      Yeah mate, never miss it.
×
×
  • Create New...