Jump to content
SAU Community

Recommended Posts

Hi there

For years I've been filling up with 98 octane and for the most part when it came to my 308rwkw 180sx and my super sport bikes "GSXR1000, ZX6R" it seemed to be the logical thing to do

Until the last 3 tanks I have been doing the same with my V35, however I decided to give the 95 a go and see if I noticed any difference

As far as I can tell the car runs exactly the same which is no surprise I guess given that its running the factory ECU, interestingly enough I seem to be getting slightly better fuel economy as well on the 95 compared to the 98 :/

So my thinking is that the factory ECU will do things such as advance/retard the timing on its own depending on how much knock it is detecting, however there is only so far that it can advance the timing. Perhaps the factory ECU is limited/unable to advance the timing past the point where any benefit would be noticed running the higher 98 octane ?

Perhaps the factory ECU is limited/unable to advance the timing past the point where any benefit would be noticed running the higher 98 octane ?

from my understanding, the logic for running 98 is that the fuel in Japan is higher octane than 95, dont know what it is, and its confusing on the net as they talk of different scales / measurements. I think most people are actually concerned that the ECU can't stop the pre-detonation. These engines have pretty high compression.

In USA the g35 coupes run 93 octane and its considered the premium fuel over there... So I see why not you could run 95 octane..

Although I always use shell v power in mine to be safe, might try a tank of 95 next time see how That goes..

US octane ratings are different to ours, their 93 is the equivalent of our 98.

The idea of using 98 comes from the fact that Japanese base fuel is 97 octane. Hence their cars are produced to work on that level of fuel. 98 is the closest thing that we have so, that's why most people use it.

the difference between 95 and 98 is 4 cents.

Oi! Get back to the wasteland! :domokun:

LOL.

Yeh you raise a fair point.

But I also go through a tank of fuel a week. at $0.04c a litre difference, that equates to $170 p/a - which means i need to earn $300 before tax to pay for it - which means I work half a day a year for free, just to pay for that 4c difference....Ok i'm over thinking this.

But I always run 98.........even on my LS400 which had a 90L tank......$150 fills make you want to cry!!

IMO the ECU is not smart enough to reduce timing for 95 oct fuel. It has a knock sensor in the middle of the valley, and if that senses too much knock, it will retard. It doesn't sense your fuel and adjust.

The knock sensor doesn't work very well either, as shown by the fact we had a car with a hole through #6 piston to replace the engine on, from too much det.

4 cents a litre, or risk having to change a motor if you get it wrong. I know what I'm doing.

Anyone who is seriously affected by paying an extra 4c per litre should not have bought the car in the first place. I hear that most of the cars built by Great Wall will run on 93, go and buy one of those.

I would imagine that almost everyone here would have spent at LEAST $1000 in aftermarket parts and mods for their car, somehow the extra few $$$ on each tank of fuel just seems really trivial in the grand scheme of things.

IMO the ECU is not smart enough to reduce timing for 95 oct fuel.

^^ this. the FSM states the knock sensor is only a last line of defence device, it is not used for tuning.. the ECU ignition maps are preset and don't change unless the knock sensor detects knock, then it switches to a 'knock map'.

The manual for my car says to use 96RON fuel, which I assume is what they have in Japan?.. I have been using 95RON since I have had my V35 without issue.. I ran a test of 98 for 3 consecutive tanks about 6 months ago, I couldn't detect any improvement in performance and it didn't make any changes to fuel economy, so I have gone back to 95.

^^ this. the FSM states the knock sensor is only a last line of defence device, it is not used for tuning.. the ECU ignition maps are preset and don't change unless the knock sensor detects knock, then it switches to a 'knock map'.

The manual for my car says to use 96RON fuel, which I assume is what they have in Japan?.. I have been using 95RON since I have had my V35 without issue.. I ran a test of 98 for 3 consecutive tanks about 6 months ago, I couldn't detect any improvement in performance and it didn't make any changes to fuel economy, so I have gone back to 95.

This is exactly my point

I have run 98 for years and now that I have started to run 95 I can't detect ANY difference, everything feels and sounds the same and yet I am getting slightly better fuel economy which is one of the main reasons why I have raised this point

technically, running a fuel with considerably higher octane than the ECU is tuned for, can result in reduced fuel economy.. I found this when I tried my old J30 maxima on 98 for a bit.. but I wouldn't expect to see any change between 95 and 98 on a car that is tuned for 96.

So I can't say why you are acheiving better economy on 95..

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I seem to the be only person that is using a Haltech 2500 on an NA motor, I've installed a Bosch DBW throttle body to the OEM intake manifold and am having problems maintaining AFR even with the wideband o2.  It will run extremely rich at idle and up to redline, but under load it will go extremely lean in the 20s and i'm essentially having to rev it over 4k and feather the clutch to get it up to speed.  I've read a few other threads of about the butterfly, it seems removing the vacuum to it is supposed to have it remain open, i've noticed no difference under 4k with the vacuum line to it plugged.  I'm hoping someone here has had luck using the NA manifold with Haltech, and if they happen to have a tune for it.  
    • I don't know any details, but I really wouldn't be surprised if they do it as a LHD only version, at least initially.
    • Thanks for the replies everyone. Definitely a coolant push. Oil catch can is empty and always has been. As the engine is out now I'll be having a good look over things. I do have some detonation on the piston tops from a trigger issue back about 5 years ago. I felt it and shut off then bought a new ecu and changed the trigger. Never been an issue since. It never hurt the power, its made almost 80hp more since that incident but I will pull the bearing caps to take a look. If the bearings are damaged I will do a bottom end refresh. Head is being re conditioned at the moment and the block will be cleaned and checked to ensure it's flat. I'll go with a kameari gasket and see how it ends up. The other thing I'm not super keen on is the cylinder colours. I suspect this is from the inlet manifold. The plan will be to put it back together, retune and then stick a plazmaman billet inlet on it and retune. I'm happy with the power, if it makes a little more, then great, but I would rather just make everything more efficient at this stage.
    • Maybe they'll look to do a bunch of presales to help inject some cash fast for their financial issues...
    • Does it also misfire equally when revving?   Josh is very correct in what you should do. The coilpack harness wiring loom itself is a known problem due to its age and the number of heat cycles it has gone through. Throwing parts at a vehicle to diagnose the issue isn't a smart or good way to do it. Secondly, you may have a bad coil pack, you pop replacements in, they fix that issue, but messing with the harness breaks it, so the issue persists. So now you think "well it wasn't the coil packs" and have to continue chasing your tail, potentially swapping back in your shit coil packs and returning the good ones (yes, I've seen people do this because 'it wasn't the problem' and they want to save money). And suddenly, you've got two issues with the same symptoms...   Diagnose, don't use the spare parts shotgun.
×
×
  • Create New...