Jump to content
SAU Community

Recommended Posts

  • Replies 83
  • Created
  • Last Reply

Top Posters In This Topic

when are you expecting them to arrive??

Order has been placed, just waiting on delivery confirmation. Also your payment hasnt cleared yet... will let you know at end of week if theres a prob.

and mine dave?

I knew I was missing someone.... your payment never cleared mate. How did you do it? Send me a pm .

All moneys have cleared as far as i know.. apart from 2 people but they know who they are.

Order was placed on monday and paid wednesday. Just waiting ETA now.... supplier has to get all the parts then pack it up... so will be quite soon now.

Not sure if there is enough interest... but will run one more after this.... will include clothing and a few other ricey bits this time.

Dave.

Heh, sounds like my order might be delaying the whole order... sorry :D

LW.

Damnit, there is always one isn't there!! :headshot:

I bet you are the guy who orders the Filet-o-Fish in Macca's drive through when everyone else in the car orders a BigMac and then the "order here" window bitch says " Five minutes wait on the filet, ok?" GRRRRR Here eat this instead :Bang:

Err... hope you know I'm only takin the p!ss mate.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...